Problem - Honor 5X Questions & Answers

Hi
I have the KII-L21 version & I put the case on the wrong way round, so I presume it was pressing the power button without me realising. When I looked at it, it was displaying an EMUI message telling me not to unplug the USB or press any key.
Hoping to 'save it', I plugged it in a USB connected to wall charger.
But its been sitting there displaying this message - see attached - for over an hour without changing.
Any idea how to re-boot from this screen please ?
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

shawfield said:
Hi
I have the KII-L21 version & I put the case on the wrong way round, so I presume it was pressing the power button without me realising. When I looked at it, it was displaying an EMUI message telling me not to unplug the USB or press any key.
Hoping to 'save it', I plugged it in a USB connected to wall charger.
But its been sitting there displaying this message - see attached - for over an hour without changing.
Any idea how to re-boot from this screen please ?
Click to expand...
Click to collapse
Have you tried doing a hard reset by pressing the Power button for at least 10 seconds?

tsdsbrk said:
Have you tried doing a hard reset by pressing the Power button for at least 10 seconds?
Click to expand...
Click to collapse
Thanks that worked ! All resolved.
Cheers

Related

Softbank X02T unbrick workaround

I sent my phone to Vietnam to unlock. I guess they could unlock (I’m not sure because, right now, I have no way to check). As a bonus they changed my rom to English but when i got my phone on my hand, I found out that pin 1 and 2 were soldered, the battery was used up (voltage was less than 3V) and it was not charging. I managed to charge the battery externally and after putting it back, when I pressed the power button, the green light blinked once and turned off. After some searching in the forum (http://forum.xda-developers.com/showthread.php?t=680927), I found out that shorting pin 1 and 2 can wake up the phone and I could start my phone. Then I found out a easy way to do that. Here is the way I'm doing it now.
1. Solder pin 1 and 2 with 2 small flexible wires like the picture
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
2. Insert the sim and battery normally ( see the picture)
3. When starting, connects the two wires and press and hold the power button until Toshiba logo appears
4. Disconnect the wires and use the phone as normal(if you don’t disconnect, it will not charge).
Now you can charge, you can flash any English rom, do all the normal operations. Only drawback is when restarting, you have to open the back cover and connect the two wires again and disconnect.
Hope this will help unlucky X02t users until someone comes up with X02T's rom

Software Update Fail

I was attempting to Odin back to stock and my phone got disconnected.
Now it says "software update fail" cant seem to get anything, recovery, or download or anything.
Help?
Get a jig
Sent from my SGH-T959 using XDA App
The jig doesnt work either...
Pops up the software fail message as well...
post a pic
Sent from my SGH-T959 using XDA App
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
http://img.photobucket.com/albums/v293/kidynomite/20111014_215222.jpg
Try these steps:
1. Unplug USB from the phone (leave the other end alone). You already unplug lolz. Make sure the other end is plug in to your PC
2. Remove the battery
3. Press and hold both Vol Up and Down (don't let go until you finish step 6)
4. Press and hold Power button (don't let go until you finish step 6)
5. Plug the USB into the Phone
6. Slide the Battery in
Good luck
kidynomite said:
http://img.photobucket.com/albums/v293/kidynomite/20111014_215222.jpg
Click to expand...
Click to collapse
Still the same results, tried holding up only, down only, both vol buttons and all three.
Open Odin & plug your phone into your pc & see if you get the yellow COM port box. If you do , just Odin from there.
!
I'm not too sure what happened, but just sat there and held all buttons with all cables plugged in for about 10 minutes and it worked...
Thanks for all your help!
Hi I have the Galaxy Tab and I had the same problem then I somehow got it worked but then I don't have market or Gmail in this now.I'm currently in China and I get some stuff in Chinese stuff.

[FIX] Booting Samsung Galaxy Tab 10.1 from DSOD

{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
]Hello everyone,
I'm sure there are many fixes for the Deep Sleep Of Death but certainly most of them did not work for me but after giving up trying, one method worked.
These are the methods to try revive your tab from its deep sleep,
Method 1:
1.Since you cannot remove the battery physically, this key combination will act like the removing and putting the battery back on.
2.Try starting your tab by pressing the combination Low Volume + Power .
3.Keep pressing this combination until the boot logo appeares.
4.Dont press not more than 30 Seconds.
5.Since you cannot remove the battery physically, this key combination will act like the removing and putting the battery back on.
Method 2:
1.Try touching the screen while pressing the power button.
2. Press Power Key + Touching the screen
3. Keep doing that for 15 Seconds.
Method 3:
1. Try emptying the battery by pressing the Power Key continuously then try charging it and then try the 1st method.
Method 4:
1.First connect the tab to your computer and wait for few minutes.
2. It took me nearly 5 to 7 Minutes.
3. Then you can see the Charging Screen appear.
4.Now do not disconnect your tab from the computer, try powering on your tab let, it should start working normally now.
I do not know what causes this DSOD, but after trying all of the above mentioned methods,the 4th method worked for me.
Good Luck, you surely need it :fingers-crossed:

hi all...help me with android recovery no command

Good day to every1...hope i post this in the right section after 3 fails...hehehe...im using HUAWEI ASCEND Y600-U151,can any1 tell me what cause this...for ur info...i already.press power button or whatever button that i can find at my hp...still the text not appear...only this dying android with chest open.CAN PLSSSS TELL ME WHY THIS HAPPENING and will be grateful if u guys give me solution for this...
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
im a noob with strong intention to be well being
irmanpawanchik said:
Good day to every1...hope i post this in the right section after 3 fails...hehehe...im using HUAWEI ASCEND Y600-U151,can any1 tell me what cause this...for ur info...i already.press power button or whatever button that i can find at my hp...still the text not appear...only this dying android with chest open.CAN PLSSSS TELL ME WHY THIS HAPPENING and will be grateful if u guys give me solution for this...
im a noob with strong intention to be well being
Click to expand...
Click to collapse
Okay, first turn off your phone completely. Leave it for 10 seconds. Then press and hold Volume Up + Power button together (No other button) until the recovery screen appears. Hope this helps.
To get to this image...that is the button i supposed to press and yes that is android stock recovery...but it has no text..even when i tap power button...its only flickering or something like that till battery drain...button vol - & power will get me stuck on huawei flower splash screen...
im a noob with strong intention to be well being

ONDA obook10 V5 stays at Onda logo - image attached

Hi,
my Onda obook10 V5 decided to make my life difficult. After start in Android, it stopped suddenly in middle of some software download (update from Adroid store). After that it showed no more boot partitions, but only EFI Shell.
I tried to reset it, and now it hangs with onda logo. If I press the ESC key on keyboard (USB or magnetic) it says "ESC is pressed. Go to boot options." but nothing happens. Also any key kombination brings it to the same behaviour.
I can turn off the tablet, and start it with combo Power + "+" or Power + "-" or Power +"+" + "-" but nothing else happens. I also tried to disconnect battery, but same is happening.
I have a feeling, that some EFI settings are not correct, but I can not get into EFI shell, nor BIOS or any other life signs.
I also tried to connect it via USB to Mac Mini. It is not recognised on USB ports.
Please find attached images of screen and hardware.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Thank in advance,
Gregor
P.S.: I also asked same question on ondaforum(dot)com but I think there is little to nothing happening.
OK, with key combo using original Onda Keyboard:
"Crt+Fn+Alt+Del" I can reset the tablet and then it loads EFI Shell.

Categories

Resources