Samsung Gear Circle restarting mid use. Sometimes multiple times. - Samsung Gear S

I've had the Samsung gear circle for over a year now, I think going on two, and they will randomly restart. I know for sure it's not my phone because I upgraded from a galaxy s5 to s7 edge.
The Bluetooth headphones will cut off and play they certain sounds in order on their own. The sounds are as follows:
•Device off indication
•Device on indication
•Connecting/paired to phone sound
•then the status of the battery.
This all happens without touching the power switch.
I also noticed that the headphones connect back faster when it restarts than when you would turn it on via the switch.

That's because of the damaged wire that goes to the left earpiece.
I have the same issue and looking for the videoguide or manual on how to disassemble it properly. Once I find it I'm going to replace the wire. Probably will make it a bit longer as well, so it better fits my collars.

Related

mic/ear-piece cut-off

I am using ROM version 3.17.03, May 15th 2003 Radio A.33.02 and Protocol version 1.3.3.
Does anyone know if there is a setting in the software anywhere which cuts off the mic/earpiece? The plug for a hands-free headset stilll lets the user operate the unit.
I have had a screen replaced and ever since, the mic/ear piece simply doesn't work. It has been back to the repairer numerous times but he can't figure out how to get them working again and I am beginning to suspect that he didn't accidentally disconnect anything which he didnt re-connect while putting the screen in.
Curiously enough, in the blue ribbon bar at the top of the screen there IS what looks like a broken top half of a cocktail glass with an X beside it, - next to a speaker-like icon??? But this may just indicate lack of service and when I switch to PHONE, the volume control comes up as working normally. I suppose this might just mean that the phone rings as opposed to vibrates, which it does, whether on (no) speaker/mic or hands free headset.
The unit is called a PW10A1 (SX-56)

[Q] Aria Front (In-Call) Speaker Stopped Working

The in-call speaker on my wife's Aria doesn't consistently work for calls. I've replaced the digitizer on it, but I don't think it's hardware related, because I took the battery out while it was on, and when I started it up again, it worked; and sometimes it works, then doesn't, then does.
What happens is when she calls or is called the speaker just doesn't work. She transfers the sound to the external speaker and it works fine.
She's running the Liberated ROM (not sure what version, sorry; I can find out if needed).
Thanks for any help!
It's probably a loose connection.
Using a wired headset has screwed 2 arias for me now.sometimes I can wiggle the plug before I remove it and get the speaker to work but generally I just turn speakerphone on and turn the volume all the way down to use the ear speaker.fairly common problem.
Sent from my Liberty using XDA App
drumist said:
It's probably a loose connection.
Click to expand...
Click to collapse
I'm going to agree on this one. I've taken my Aria apart more times than I probably should have... the first cellphone I've ever repaired on my own, so go figure.
My bet would be that the in-call speaker is still in place, but loose. If you open it up again, the piece you're looking for is maybe a half-inch long rectangular block with two prongs on one side. If the phone is sitting screen up, the prongs should be facing down with the points towards the top of the cell phone. It sits in a little recess above the lcd assembly.
You need to push the piece up so it's snug in it's little recess. Easy peasy.
If you've already done a digitizer replacement, you should have the tools to do a quick check and make sure the speaker is secure in the proper position.
I still think it may be a loose speaker connection, but I also think mtnlion could be right, too.
When the in-call speaker does not work, does the phone show an icon in the notification bar that indicates that a headset is connected?
In any case, I do think it's a hardware issue and not a software issue. But if the OP really wants to be certain, he can install another ROM and see if the same problem occurs.
Yeah, I took the thing apart again, and stretched those prongs a bit to make the speaker fit more snugly; hasn't had the problem since. But I think now the seal isn't quite as tight as it used to be so her screen "squishes". That'll be another day.
Thanks for the thoughts on it.
Adhesive issues
I had that issue too. To fix it, all I had to do was use a space heater (or a blow dryer) on the phone (take the battery, sim card and SD card out first) for about 15 minutes. Then take it and smoosh it underneath something flat and heavy like a book, but make sure to put something down beneath it so the screen doesn't get scratched. Once it cools down, it should be significantly less squishy.

[Q] Troubleshoot post-liquid-damage; phone boots/responds, but no display

I accidentally bumped a cup of coffee over on the back of my HTC Evo 4g LTE. I bumped a pillow into the nightstand while trying to contort my body in a way that would let me set sleeping my 10mo old into bed without waking him
I turned off the phone immediately, took off my Otterbox Commuter case (not the really waterproof Defender) and found a thin liquid coating on the back housing. Perhaps 1-2hrs later I made the poor estimate that it wasn't "that bad" and tried turning it on. The phone went into what I think was a boot loop (the display never showed anything, so I can't be sure), vibrating every ~30sec as it would if it were constantly trying to turn on and failing. It doesn't have a battery designed for removal, so I just had to let it sit.
Perhaps 6hrs later I went to check on it, and thought it was unresponsive after pressing the power button and nothing appeared to happen. I inadvertently pushed the volume rocker, however, at which point it made a beep as though it were adjusting the volume! After that, I noticed that the power button was also toggling the capacitive navigation buttons, which would illuminate and shut off as if the phone was "running" as well... but I still had no display.
Since then I've done a complete teardown (pop off all cases, separate all ribbon cables, vibration motor, speakers, camera, and removed the battery). I've done a few washes/brief soaks in isopropyl with the motherboard and then put everything in a vacuum chamber overnight at -20 inches of mercury. I also set the display and motherboard it in DriRite (lab-grate dessicant) for about a week now. In the meantime, I assumed the display may have been fried and ordered a replacement since it was only $28 on ebay. I just got it yesterday, but get the same results (phone "turns on," but display never lights up).
Any input on troubleshooting further?
- I've thought about looking at the two ribbon connector receivers for the display under a microscope to see if I can see any residue.
- I've also considered opening my wife's phone (same model) and swapping the batteries based on a probably false idea that if the battery might have gotten zapped, it could power the rest of the phone but not the display? Thinking not, as the power-ups I've attempted have had the USB charger plugged in, but easy experiment.
Would it be possible to short out just something related to the display on the motherboard so that the phone could run seemingly perfectly fine but just with no display? Just seemed so darn unlikely and that if I toasted some circuitry that a lot more would have been toasted in the process.
I plan to reassemble tonight and test for call reception (I think I can guess where the answer button is) and notifications (email myself and see if I get a vibrate/beep). That would confirm that the radios are also still functional.
Sort of at a loss and am not sure what else to do! I'm an engineer and even if the phone is toast... I'd really love to definitively figure out what's causing the issue.

[Q] plug in/charging sound, can i shut it off?

is there any way to shut off that beep? my wireless charger randomly looses connection occasionally and beeps in the middle of the night... not often, but enough! id really like to kill that sound, any suggestions?
I don't believe there's a way besides putting your phone on silence. I use the Quiet Hours setting to put mine on silence during sleep time, and create exceptions for certain contacts.
ive got the quiet hours set and it still beeps? i thought that would do it, but no luck on my phone?
You know, I stand corrected. Quiet Hours still doesn't disable the charging sound. Only silent mode shuts it off.
That is the #1 reason I want to root mine... I'm holding out for samsung pay though. I have a lot of different wireless charging pads and they are hit and miss as far as the connection. However, the one I have at my bedside is an official samsung pad and it never seems to lose connection as long as it is centered. Perhaps switching pads might fix your night problem.

Bluetooth antenna issue.

After replacing the battery in my Z5 compact the bluetooth range is now poor.
With the phone in my pocket I get skipping/stuttering when using my headset.
If I place the phone down and walk away from it, my headset cuts out completely at about 10 feet, whilst stuttering up to that point.
Before I changed the battery the range was fantastic, easily 60+ foot, with direct sight to the phone, and zero stuttering. I have checked my headset on another phone (st27i) and there are zero issues, so it's not the headset.
I'm guessing I have done something to the hardware when I removed the old battery? I took out/disconnected everything that had to come out to the point I had the mobo loose enough to heat the battery with a hair dryer and carefully peel the battery off. Everything else works on the phone and I have checked the connections on the bluetooth antenna and they seem fine. One odd thing is that in the service test menu, the bluetooth test fails (even when it's connected) but in the help section of the bluetooth settings menu the bluetooth test says, pass, all ok. Is there something I have overlooked perhaps?
Regards,
AJ

Categories

Resources