Hey guys so I've owned the V10 for a while now and actually when it started slowing down and having calls up whenever I plug in the headphone jack. I have an old car and I just connect the call to the speakers but the minute I do
..hangup. I reset the phone to factory settings and it stopped for a while but now it's back. I know that some headphones have the small voice input for talking so either while walking or driving the phone gets disconnected. Any ideas???
Related
Hi,
For some reason my phone sometimes goes to car mode and loud speaker switches itself all the time when I receive or do calls. I have reseted it few times, but still the same.
Any ideas?
I guess you charge your phone with a car charger. Reboot your phone and all will be well.
Hey everyone,
Has anyone noticed bluetooth issues? I've pointed them out in other threads, but they seem to be glossed over. I hate to seem like a noob by creating new threads, but I fear that the issue is being looked over by most people. I've read a few reports of people having issues with their phones connecting to their cars or headsets automatically. Has anyone else faced these issues?
I specifically cannot get my BT headset to connect unless I unpair and repair it everytime I want to use it. Sometimes even during a phone call the headset will drop connection and wont reconnect unless i turn it off and on a few times. For reference, I've tried multiple BT headsets and they all behave the same way. These headset's also work just fine with my Galaxy S2, just not with my S3 (international on XLE8)
No problems with bluetooth here and I use it a lot (HS3000, Logitech Boombox, PS3 and Wii controllers too).
No issues here. Phone sometimes doesn't pair automatically with the BT kit in my work car, but I've had that issue with my S1 and S2 in the same car so I'd say it's a problem with the headunit.
Works perfectly with the Sony headunit in my own car, and connects to my mate's fine.
ok, what firmware rev are you guys running? im going nuts not being able to use bluetooth here!!
somewhat related.
i often leave my sgs3 connected to my laptop via usb when i fall asleep. at morning, battery's charged 100% obviously and phone isn't hot.
last time around, i was listening to music via hm3700 bluetooth headset. then later turned off the bluetooth headset. i forgot to turn off the bluetooth on sgs3 and again fell asleep while it's still connected via usb to laptop.
when i woke up at morning as usual battery's charged 100% but the sgs3 was hot, not so hot but isn't anywhere the normal hot we're accustomed to.
connects automatically to my car's BT built-in system. Only needed to pair once.
Works very well with my Sennheiser PXC 310 BT.
If I switch on the headphones the phone automatically connects to it.
can everyone please detail their firmware/kernel they are using?
i am on XXALE8, with the stock kernel
I have problems on XXLE8 as well connect it to my car head unit and it acrually crashes the headunit after 5 mins being connected . After the heaf unit crashes 3 times it requires a pin code. Iphone 4, 4s and gs2 connect no issues.
Sent from my GT-I9300 using Tapatalk
bean12147 said:
I have problems on XXLE8 as well connect it to my car head unit and it acrually crashes the headunit after 5 mins being connected . After the heaf unit crashes 3 times it requires a pin code. Iphone 4, 4s and gs2 connect no issues.
Sent from my GT-I9300 using Tapatalk
Click to expand...
Click to collapse
thanks for your input, i upgraded to XALF5 and still having the same issues. this is frustrating!!!!
Oddly - my phone will automatically connect to my cars in-built BT system, but it won't auto connect to my Jawbone Era without switching BT of and back on....
I also have problems, with my build-in bt in my car. Have XXBLH3. Connect fine, but drop the connection 2-3min after. My SGSII have no problems
No Ringtone through Bluetooth
Okay here is my problem……I want my custom ringtones i have set for contact to play in my Bluetooth headset when a receive a call, not that dumb ring. That way I will know if I want to take the call or not because I can tell by the ringtone who is calling. Why would Samsung disable this feature. my iPhone 4s plays the ringtone I have setup when I get a call. Is there anyway to do this. I ride a motorcycle and I have a device called a Chatterbox that let’s me connect via Bluetooth to my phone so I can hear my music and talk and make calls while I am riding. On my iPhone 4s my music would pause my custom ringtone would play and I could decide it I wanted to take the call or send it to voicemail, then my music would start right back up from where it left off. Right now my Galaxy i717 and my Galaxy i747 (Note and S III) just play this annoying ring and I can’t tell who it is! Any have a fix or work around for this.
Hmmm, the sound on my cars bluetooth gets distorted and only a reconnect will fix, and more worringly sometimes the S3 will not wake up after disconnecting from my car and only a hard reset will solve it.
My S2 did pretty much the same thing.
Hi all,
Since I got my S3, I've been connecting it to my car's built-in bluetooth headset for music and for phone calls, and it's been working flawlessly.
Anyway, about 2 weeks ago it started making weird noise when I'm trying to call someone. At first I thought it's a connection issue, I hang up and call again, and it works fine. But at the moment, it happens all of a sudden during phone calls.
The issue is that the phone itself is still working earpiece and mic even while the bluetooth headset is connected and the bluetooth headset green button is ON. Which creates an audio loop and makes all the static and noise.
I've read that people started getting this after the JB update, with me it happened so slowly, I'm not rooted to try ICS back again. However, I tried to diagnose by connecting my old XPERIA arc to the car and my GS3 to another bluetooth headset. Same problem with the other headset, while the arc and the car work perfectly together.
I also tried to disable NFC and even removed the NFC sticker from the car completely....still the same problem.
Any idea how to fix this, or even bring it up to samsung to try to fix in the next update?
bond_1982 said:
Hi all,
Since I got my S3, I've been connecting it to my car's built-in bluetooth headset for music and for phone calls, and it's been working flawlessly.
Anyway, about 2 weeks ago it started making weird noise when I'm trying to call someone. At first I thought it's a connection issue, I hang up and call again, and it works fine. But at the moment, it happens all of a sudden during phone calls.
The issue is that the phone itself is still working earpiece and mic even while the bluetooth headset is connected and the bluetooth headset green button is ON. Which creates an audio loop and makes all the static and noise.
I've read that people started getting this after the JB update, with me it happened so slowly, I'm not rooted to try ICS back again. However, I tried to diagnose by connecting my old XPERIA arc to the car and my GS3 to another bluetooth headset. Same problem with the other headset, while the arc and the car work perfectly together.
I also tried to disable NFC and even removed the NFC sticker from the car completely....still the same problem.
Any idea how to fix this, or even bring it up to samsung to try to fix in the next update?
Click to expand...
Click to collapse
I had a similar issue when connected to my friends bose. Ended up with noise coming through, it might just be bluetooth, can be a bit funny at times.
Car bluetooth audio feedback
Helo,
I'm trying to revive this thread... I have also problems with audio feedback from my original embedded bluetooth car kit.
have a Toyota Avensis and I get a terrible feedback noise when making out calls from my phone.
I tried playing with many settings, like noise reduction etc', but none helped.
All this started since I updated to Android 4.1.X (from 4.0.4). At 4.0.4 there is no problems at all.
I see that it takes a while to the phone to actually dial. From the time that I push the call button to the actual dialing, the microphone is active and is directly feeding the audio system, which results in this annoying audio feedback.
In my mind, the microphone should be muted till the call is made... but it is on. When I wear a BT earpiece, there is no problem since there is no audio feedback path from the mic to the earpiece. but when hooked with the CAR kit there is a direct audio path between the mic and loudspeaker.
I'm sure I'm not the only one suffering from this problem. please post here if you suffered such problems.
Please post if you managed to solve the problem.
I am currently running with the latest 4.1.2 update - same frustrating problem.
no solution for feedback noise....anywhere
It seems to be a mystery. I've checked a number of forum posts with this problem and absolutely no solution. I also suddenly began experiencing this problem in my car's hands free blutooth system. Sometimes it happens, other times not. I usually switch the phone to headset then back again to make it stop. But it's becoming more frequent and the headset switch seems to be lasting for a short perios before it starts again. I've seen posts mentioning grounding issues and others that say it's normal because of the car speakers (like putting a microphone close to a speaker). This is NOT normal. I have never experienced this with a hands free system and a phone. Also, the fact that I have been using this for some months with no problem. I did however notice that when I am not using the hands free and I put my s3 on speakerphone, it sometimes switches back to headset for no reason at all. If anyone has found a solution please post it because right now in the interverse...there is none. Will do the same if I don't crush this s3 for being so annoying while in the car first.
Loud static noise
h_bear said:
It seems to be a mystery. I've checked a number of forum posts with this problem and absolutely no solution. I also suddenly began experiencing this problem in my car's hands free blutooth system. Sometimes it happens, other times not. I usually switch the phone to headset then back again to make it stop. But it's becoming more frequent and the headset switch seems to be lasting for a short perios before it starts again. I've seen posts mentioning grounding issues and others that say it's normal because of the car speakers (like putting a microphone close to a speaker). This is NOT normal. I have never experienced this with a hands free system and a phone. Also, the fact that I have been using this for some months with no problem. I did however notice that when I am not using the hands free and I put my s3 on speakerphone, it sometimes switches back to headset for no reason at all. If anyone has found a solution please post it because right now in the interverse...there is none. Will do the same if I don't crush this s3 for being so annoying while in the car first.
Click to expand...
Click to collapse
I've been going nuts with a similar problem and it started happening after the 4.1.2 update as well. When I make a call I sometimes get an ear shattering blast of static for about 1 or 2 seconds just before the call connects. My wife has the same problem and she uses her phone all the time and she's going deaf. We both have Moto's Razr Maxx. Verizon gave he a new phone, it worked phone for about 2 weeks and now it's having problems again. This really sucks and I think we need to buy new phones. If anyone has a solution I would sure like to hear it.
Hi guys,
I need your advice here. I love the music capability of the v10. So my headphones is plugged in the phone all the time while listening to music. However, I noticed that 30% of the time when I receive/make phone calls the mic would just stop working. If I unplug my headphone and replug it back, about 50% of the time it will work again. The other 50% the phone call would end when I unplug my headphones. During all these scenarios the mic would work under speaker mode.
Is this a software issue?? Coz the mic obviously work flawlessly when the phone is unplugged or when it's on speaker mode. Would reboot the phone solve this problem or should I send this unit back to lg??
Thanks in advanced for your help!
I'm having the exact same problem you are. This happened to me once before and it just sort of fixed itself after a while. Do you see a weird little headphone chord icon at the top of your screen? If you do, it means that your phone thinks that a headset is plugged in when it's not, thus not allowing sound - such as music - to output from your external speaker. Mine doesn't even play music through headphones or allow me to hear anyone while making calls if I don't use speaker phone - the person I'm calling can't even hear me.
This is such a faulty issue - and a rarely known or talked about one at best. I'd take it up to your local carrier store and see what they say.
Mic prpblem even without headphone plug-in.
JBlake93 said:
I'm having the exact same problem you are. This happened to me once before and it just sort of fixed itself after a while. Do you see a weird little headphone chord icon at the top of your screen? If you do, it means that your phone thinks that a headset is plugged in when it's not, thus not allowing sound - such as music - to output from your external speaker. Mine doesn't even play music through headphones or allow me to hear anyone while making calls if I don't use speaker phone - the person I'm calling can't even hear me.
This is such a faulty issue - and a rarely known or talked about one at best. I'd take it up to your local carrier store and see what they say.
Click to expand...
Click to collapse
Thanks for the reply. I think I will contact LG. However, today I hada mic problem without pluggingin my headphones
Now I know the phone's mic works ~80% of the time. When it works, it works flawlessly. So, do you guys think this might be a software problem??
Hi!
Got this little nagging issue that is bothering me. At work I use a bluetooth Jabra65 headset. Problem is I don´t wear on my head all the time (talkin to coworkers, listening to audio through speakers etc) and have them around my neck. When doing this I keep missing calls since the ring signal is played through the headset (which I´m not wearing) and not through the phone speaker.
I really would like the ring signal to be played BOTH on the phone and through the bluetooth headset. Any way to set this up? I´ve tried all the audio and bluetooth settings I could find on the Mate 10p but no success. Thanks for any advice.
Lo and behold! Just half an hour after I posted above I got a call and got loud and clear signal on both phone and in headphones . Magic! ....or maybe the upgrade to android10 that landed last night?