TWRP no loading or booting same for recovery Eui ! - LeEco Le Max 2 Questions & Answers

Hello everyone,
I have a problem with my leeco Le max 2 - 6gb/64gb (x820).
I installed the ROM EUi cuoco92 and I would like to install a new rom (lineageOS 7.1.2 for LeEco MAX2)
I installed a new recovery on the official site, I followed the steps (install adb, drivers, unlock the boot loader ok and install Twrp)
When I finish it is not going to start on the twrp at startup there's marked recovery then a black screen and it vibrates several times to finally start normally on the old ROM)
Trwp no loadind or booting same for recovery Eui ! :crying:
I responded to the manipulation several times, I do not know what to do
Thank you and your help :good:

You'd be better off installing cuocos recovery. I had trouble with flashing roms with official twrp. You can find the file on cuocos thread
Sent from my Le X820 using Tapatalk

it's good with twrp recovery cuocos...thank you very much
luisoman2000 said:
You'd be better off installing cuocos recovery. I had trouble with flashing roms with official twrp. You can find the file on cuocos thread
Sent from my Le X820 using Tapatalk
Click to expand...
Click to collapse
it's good thank you very much.
sorry for my english i'm french...

Installing twrp on me Max 2
Ok, not sure if this is your problem - when trying to install twrp, that the installation all goes through correctly, but when rebooting - twrp has not loaded.
I have had the same problem on two Le Max phones now. I originally found the solution on xda ( or another site ) but only just remembered it just now .....
The solution is - after the install of twrp has completed on the phone you will be left with a screen with an image of 3gears, Chinese writing and in English - you've entered Fastboot Mode etc... , you need to hold the lower ( smaller ) power button down to make it reboot
But Immediately as it starts to reboot release the power button and quickly push and HOLD the volume button top ( up ) , then quickly do the same with the power button. The phone will beep a couple of times, release the buttons and the phone will boot into twrp.
It appears that if you don't carry out this sequence then the original startup sequence restarts and wipes the new twrp install, meaning that you have to go through the whole twrp sequence again. ( I've done it so many times now i've got really fast .... )

Related

Soft bricked phone?? No access to recovery mode but I have access to fastboot

Hi all,
I have a Xiaomi Redmi 3 and I tried updating it to Android 6.0 today using a very helpful article from cyanogenmods
It was all going so well until the end when I came to flash the ROM, I downloaded the wrong one!! (I needed the ARM64).
Anyway my phone restarted and now I can't seem to rectify my mistake!
I can't access the recovery mode (Power button and volume up) It just shows me the Xiaomi sign and stays there but I can access Fastboot (Power and volume down) and it can communicate with the PC via CMD.
I'm super new to this and I've been looking online for the past 5 hours with no luck so maybe someone can help me out.
I tried fastboot update open_gapps-arm64-6.0-aroma-20160814.zip
But I got...
archive does not contain 'android-info.txt'
archive does not contain 'android-product.txt'
error: update package has no android-info.txt or android-product.txt
Any suggestions? I've found a few other threads but they're way too techy for me and I couldn't understand what to do!
Thanks in advance
I've realised that my initial post was pretty vague and I don't think I used the correct terminology so I'll explain in the hope that someone may be able to help.
So I wanted to update from 5.1.1 to 6.0.
I found an article from Cyanogenmods and I downloaded the Redmi 3 TWRP recovery, the ROM for Redmi 3 Cyanogenmods 13 and the GApps.
I installed the TWRP recovery,
Copied the GApps and CyanogenMod ROM ZIP to my device
Booted into recovery mode and backed up my data using TWRP,
Wiped data factory reset, Cache partition, Dalvik Cache and Formatted the System partition,
I flashed the custom ROM and it all worked well,
I then went to flash the GApps and thats when it said that I had installed the wrong version (I needed the ARM64 not the 32).
It then restarted and I've been stuck in a bootloop.
I can access fastboot.
I can't get into recovery, the phone just goes to the Xiaomi sign then gets stuck on the Cyanogenmod logo.
A few times it looked like it was doing an update but it was all in Chinese so I couldn't understand it then it briefly went to what looked like a set up screen but then rebooted and got stuck on the logo screen again.
Any help would be great;y appreciated.
I only bought this phone a few days ago, my stupid mistake for wanting to upgrade!!
Ramah.h said:
Hi all,
I have a Xiaomi Redmi 3 and I tried updating it to Android 6.0 today using a very helpful article from cyanogenmods
It was all going so well until the end when I came to flash the ROM, I downloaded the wrong one!! (I needed the ARM64).
Anyway my phone restarted and now I can't seem to rectify my mistake!
I can't access the recovery mode (Power button and volume up) It just shows me the Xiaomi sign and stays there but I can access Fastboot (Power and volume down) and it can communicate with the PC via CMD.
I'm super new to this and I've been looking online for the past 5 hours with no luck so maybe someone can help me out.
I tried fastboot update open_gapps-arm64-6.0-aroma-20160814.zip
But I got...
archive does not contain 'android-info.txt'
archive does not contain 'android-product.txt'
error: update package has no android-info.txt or android-product.txt
Any suggestions? I've found a few other threads but they're way too techy for me and I couldn't understand what to do!
Thanks in advance
Click to expand...
Click to collapse
if i was in your situation i'd probably go fastbootmode > EDL > then flash official dev rom from miui site(ido). from there'd id redo everything unlocking bootloader,flashing twrp,etc.
check out this post:
http://forum.xda-developers.com/redmi-3/development/redmi-3-pro-spacex-rom-t3406919
it has a "How to Unbrick Redmi 3 ? " on the first page.
helped me alot, hope it unbricks ur phone too! cheers!
have you unlocked your bootloader?, its very risky to change to custom rom when your bootloader is locked, if its already unlocked, all you have to do is go to en.miui.com and download official rom for redmi 3 and flash it using Miflash
Edl mode is the best bet to get back to stock. Vol up and down while plugging in if i recall, from an off state. I couldn't get it from fastboot.
Lets try this for reach to TWRP.
First press volume up and down button after press power button and wait.
Phone is going to restart and you see mi icon very short time and screen is going black, immediately release all buttons and wait. You have to reach recovery with this combination.
Open a terminal/command prompt and navigate to where you have the TWRP file. Put phone in fastboot mode and enter this command: "fastboot boot (name_of_TWRP.img)".
Then when you're in recovery, just flash the new Gapps.

How to remove EUI recovery screen?

Hi guys,
Firstable sorry about my English.
i have le max 2. it came to me rooted and twrp recovery system.
there was a problem with calling and i load this one. LeECO_Le2_X820_MAX_5.8.018S_REV2_CUOCO92.
but there are many Chinese app and keyboard ect.
i think i found another room with no Chinese app.
now i want to load this rom but when i try to recovery by volume up and pover bottom combo,
its always shows me eui recovery screen.
i tryed many time to setup twrp but no happend.
i tryed to update by eui recovery screen but says no apk
any one help me?
advance thanks
You have to install twrp, you Lost it
Hi venezolano69,
thanks for your answear.
i tryed to install that many times. but it doesnt come on recovery screen.
i dont know whats going on
Did you solve this after?
I received my Le Max 2 yesterday....
I enabled usb debugging, unlocked the bootloader and then flashed the twrp recovery image which it says is successful but when I then exit and press volume up with the power key to enter recover I get the eui recovery screen....
That is strange.
I never had problems with this. Just follow the steps men.
Found the problem.
I was rebooting normally after flashing TWRP and then turning back off and then into recovery, instead of rebooting straight into recovery mode from fastboot. Once your are in TWRP in gives you the option to permanently disable the stock recovery system.
HTH

MiPad 1 Stuck at MI logo. Tried almost everything. Please Help.Soft brick.

Problem:
1.I had Resurrection Remix rom 7.1.2 installed with TWRP.
2. Tried to Install stock rom and stock recovery. Was able to install stock recovery but it was hanging in recovery. Could not move with volume buttons.
3. Then I tried flashing fastboot roms through miflashtool. Flashing was done successfully but nothing happens. It is now stuck on MI logo.
4. Mi logo only(No powered by android below or anything) It just restarts.
5. Cant go to recovery by any means tried everything.
6. Can only go to fastboot.
7. Adb does not detect device tried to install multiple times.
8. Cannot switch on Usb debuging since tablet wont boot even once.
9. I have no means to flash recovery as well.
Please help.
Have you found any solution
I am looking for a solution facing similar problem
I am looking for a solution facing a similar problem. Any help will be appreciated. I am able to reach fastboot and sun boot as well as recovery command successfully with twrp iso. but twrp is not loading after reboot and also trying to press vol up and power buttons.
chandidas said:
Have you found any solution
Click to expand...
Click to collapse

Problem with Fastboot(trying to return to Stock MIUI from OOS beta 11

Hello everyone.
I'm currently using OP6-O2_beta_21 on my phone and i want to go back to stock rom.
I did the usual steps
1- shutdown phone
2- put phone on fastboot
3- connect to pc using the original cable(tried different ports usb 2 and also 3)
4- Open Xiaomi Mi Flash(using 2017.4.25.0)
5- When i click the REFRESH button on MiFlash my phone just "quit" the fastboot screen and a small text appears on the phone :
TAP KEY TO SHUTDOWN.
I tried a lot of times on my desktop and my notebook and it did not worked.
After I tried going to TWRP to flash a custom rom but after I did the wipes/factory reset and rebooted the phone on TWRP now the Touch do not work on TWRP( when i boot the phone again on OOS the touch works)
Now after this reset my OOS is really bugged and i can't even login on play store
Anyone can help?
dimelus said:
Hello everyone.
I'm currently using OP6-O2_beta_21 on my phone and i want to go back to stock rom.
I did the usual steps
1- shutdown phone
2- put phone on fastboot
3- connect to pc using the original cable(tried different ports usb 2 and also 3)
4- Open Xiaomi Mi Flash(using 2017.4.25.0)
5- When i click the REFRESH button on MiFlash my phone just "quit" the fastboot screen and a small text appears on the phone :
TAP KEY TO SHUTDOWN.
I tried a lot of times on my desktop and my notebook and it did not worked.
After I tried going to TWRP to flash a custom rom but after I did the wipes/factory reset and rebooted the phone on TWRP now the Touch do not work on TWRP( when i boot the phone again on OOS the touch works)
Now after this reset my OOS is really bugged and i can't even login on play store
Anyone can help?
Click to expand...
Click to collapse
try installing google play service maybe then u can login
i am using this twrp 3.3.3-1 unofficial
for those who have touch problem in twrp
https://mega.nz/#F!bdwQVIyK!OWNLH72HNT-ecmC-vAVmPw
i would suggest you to put proper vendor + firmware and flash lineageOS first! then try putting back your fav custom rom
https://mirror.akhilnarang.me/MIUI/beryllium/ ( i am using 9.6.27-9)

[CLOSED] Am I going Mad :-)

HI,
I inherited this phone. ( D6503 )
Fixed a few hardware problems, now looking at software improvements.
I have unlocked the bootloader , but for the life of me I cannot get a recovery on this phone??
I have previoiusly done flashing on nokia, motorola and Nexus, but I am having no luck with this sony
I am able to connect using ADB, and can get to fastboot, but it stops there.
Issuing '' fastboot boot twrp.img'' ( to try and boot temporarily to twrp ) gives me a blank screen.
issuing ''fastboot flash recovery twrp.img'' does the same.
I cannot get a bootloader screen at all, even using the key combinations.
I cannot boot any recovery at all.
Is there someone here who can put me out of my misery
I am not looking to perform anything fancy, I just want to flash the latest lineage to see how it performs
Many Thanks in advance.
pootler.
Anybody???
I have rooted the z2 by dropping down to 5.11, installed the twrp app, then flashed recommended version of twrpl
Then when I power off the phone, and press the power and volume down buttons, instead of booting into twrp after 7 or so seconds, it just reboots after abour 2-3 seconds???
Can anybody help?-------please
I have even tried rooting , then installing twrp by either 1) fastboot or 2) twrp app.
I then installed NDR utils, to reboot to recovery - it still reboots to main system??
HEEELLPP !
I also tried flashing TWRP with 1) fastboot and 2)the twrp app,
I then installed NDR utils ( i have root ) , and it still wont boot into recovery, just straight into system???
HEELLPP!!
Thread closed on request of OP @pootler

Categories

Resources