when i listen to music I hear some noise sometimes, but headset work good with pc
Related
I just experienced a bug. I got in mij car, enabled bluetooth and stared the enging. I could hear the touch cruise connect to the parrot bluetooth carkit (usually it beeps twice, now it beeped 4-5 times).
I fired up my TomTom, instructions were given over the speakers of my car stereo (via carkit)!! I did some testing with other audio files, all worked over speakers.
Quality wasn''t sufficient for audio, but e-books and podcasts sounded good enough.
After a few minutes of playing arround I received a call, after hanging up the call the usual way on the carkit shut down the possibility to hear audio over the car speakers.
Anybody know a way to force audio over the car speakers through the handsfree??
Try this tool:
it sends all the audio signals to the headset (or BT Carkit)
Would it be possible to switch bluetooth audio on just when there is a sound to play, cause it seems a little bit useless to hear nothing when my navigation has nothing to say..
Is there an option that I can choose sound output (Speaker, Headset, BT,...) while playing music while connecting to BT Headset?
thx
So I'm having some issues with my bluetooth stereo headset. They're the Rocketfish RF-MAB2 headphones (Best Buy in house brand).
The headphones pair and connect with the touchpad no problems.
The problem is that when I try to use TuneIn Radio or iHeartRadio it doesn't recognize that audio is playing so it doesn't feed it to my headphones.
The weird thing...I have a drum kit app called 'Beat Box' and if I open that app while I still have TuneIn or iHeartRadio playing, it actually recognizes audio being played and I can hear it in my headphones.
It's kind of bizarre. Any suggestions?
my bt headphones work fine but I am having problems with the volume. Even when I plug my beats in the volume is much lower than when I use them with my phone. Weird because I thought the tp was optimized to be used with any beats by dre headphones.
i found a bug in .73;
sometimes if i listen to music with standard no mic stereo headphones (Sennheiser MX160), once i disconnect headphones and try to make a call the audio signal is not switched to the phone's speaker. so the call is mute, the other end can hear me but i can't hear the other end, if i connect the headphones and disconnect again the audio signal get routed correctly.
this doesn't happen if i connect, instead of Sehheiser headphones, the standard sony headphones or my "DIY" car stereo adapter...
I think it's an hardware bug, something looking for the impedence connected
I did notice an issue that's only occurred once, where audio wouldn't swap between headphones and speaker. I was watching a movie trailer at home on the loud speaker, then put my headset (aJays One+ with mic) in to listen to some music whilst on the move and it just didn't acknowledge the headphones. It took several restarts before the phone would correctly detect the headset and switch between the two. This was also on the .73 firmware.
i've got a mono BT earphone which works fine for phone calls, but when I play music it's routed via the phone speaker, not the earphone.
is this an x10mp "feature"?
any way to circumvent this, that is, getting music on the mono earphone?
TIA