I am generally horrible at applying screen protectors, I have been known to go through 4 or 5 before I apply one that is both aligned and without bubbles. This guided system was extremely easy to use, quick and produced the best results Ive ever done. Took me about 5 mins to apply with rigorous cleaning. Pro tip use the little bottles of fluid to remove the air pockets on the edges. instructions are a bit vague but pretty much squeeze the bottle applying the liquid along the edge between the glass protector and the screen. Wait a second then wipe away using a small amount of force. You also can send a free trial reuqest to [email protected] try to get new one as free .
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
What about fingerprint detection? Flawless or not?
Related
Hi,
My O2 XDA IIs have two small problems :
- The part including the screen isn't very well attached to the part which contains the battery,
- I don't know how to explain it but a kind of fine film present on the plastic layer covering the screen has gone. The screen and the touch screen are working perfectly and there is no cracks anywhere.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Is there a way to repair this 2 faults ?
Thanks a lot and continue your great work!
Tristan
Maybe you use lousy screen protector and take out will be like this .
Yes, you're right ... I used really expensive screen protector but when I retired it this fine layer goes out with the screen protector ...
Is there a way to buy this part (the protective plastic layer) somewhere or to take this thing off ?
You could try rubbing alcohol or something like that....
...just dont blame me if it goes wrong!
Puro offers 3 different cases for Xperia P: 'Professional', 'Clear' and 'Case'. The 'Case' model, which I have got, costs around $10. Here are some photos.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
The case is made of silicone, sits tight on the phone.
The camera collects dust easily, but that is a weakness of the phone model itself.
In this area the case is loose and vulnerable. They could leave the SIM slot hidden after all.
Buttons are hidden under the case, one must get used to the specific action of hidden buttons. The second step of the camera button is quite hard to feel, actually.
I like this case. It offers serious amount of protection and hides scratched black aluminum edges of the phone effectively.
Bear Motion Premium Tempered Glass Screen Protector GN3
-Perfect cut
-Scratch resistant (so far)
-Not terribly good with finger prints, but easily cleaned off (comes off after I pocket the phone for a bit)
-No air bubbles (however I have one little piece of lint that's PISSING ME OFF) so make sure you clean the surface properly.
-Includes wipes and stickies to clean off screen
-CHEAPEST glass protector at $12.99 shipped on amazon! (vs mime or spigen which are $28-$40)
Sorry for the craptacular pics but it should get the point across.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Pics showing fitment with case.
I purchased the armor suit note 3 case friendly version because I had scratch Ed up my zero lemon case screen... This is great... LIFETIME WARRANTY.... 7 dollars..
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Crystal clear... Easy to install... Must have for. Note 3
MB865/ST-ATT/4.4.2/BMM
ZLP- SM-N900W8/Att-ST/OxO/CWM/ViSiOn NC2_4.4.2,Snapkat 3.1
It looks great and seems like a decent screen protector. Since you have it, could you verify if the screen quality is still the same or is there any difference?
I use "Invisible Defender - Samsung Galaxy Note 3 Screen Protector Premium HD Crystal Clear Film" and its amazing. It's hard to put on since the screen is massive but it has no affect on the screen quality. It also comes with Lifetime Replacement Warranty.
I purchased this from amazon, only cost me $12.99 plus tax. The protection seems like it will hold up pretty well, but it's still early. I included some pics and will update if I form a negative opinion about it. Off the bat i would give it 4 1/2 stars. Oh and this was made for the US variants. There is no antenna cut out.
http://www.amazon.com/gp/aw/d/B00JW7AV6U/ref=redir_mdp_mobile?ref_=pe_385040_30332190_TE_dp_2
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I have the same case, went with the black border. Love it, it's very snug, and protects the phone well. Ports are all available.
My only issue is the clear back is a LITTLE frosted, which I'd prefer it to be clearer to show off my gold bling.
That looks like a phone condom. I'm glad to see you are practicing safe sexting...