I've followed several guides on how to unlock the bootloader, but i have not been able to do so.
USB Debugging is enabled
OEM is unlocked.
adb devices show my device.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I'm able to reboot into the bootloader.
fastboot oem device-id shows my device id. (I won't show the id)
I've submitted the form on LG, and downloaded the unlock.bin inside the adb folder.
fastboot flash unlock unlock.bin
And it fails.
This is a ryzen system, and posts on google shows that problems occurs with fastboot and ryzen. So i've tried the process on my laptop with a intel processor, and it was stuck on the fastboot flash unlock unlock.bin, no error or prompt. Just stuck for 30mins.
I've tried using other terminals, drivers, machines, versions of adb, and other cables. I don't have a usb 2.0 port, and i'm not going to buy a usb 2.0 hub for a possible fix.
Any help would be appreciated.
Unlock your BL through ChazzMatt's method here:
https://forum.xda-developers.com/t/...ar-instructions.3790500/page-10#post-76584629
ldeveraux said:
Unlock your BL through ChazzMatt's method here:
https://forum.xda-developers.com/t/...ar-instructions.3790500/page-10#post-76584629
Click to expand...
Click to collapse
Too complicated for my use case, my solution was using another operating system "Arch Linux" and everything worked fine.
Related
How to Unlocking the Bootloader LG L1 II
E410/11/15
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Requirements:
LG L1 II rooted (How to Root here)
Terminal Emulator
bootloader-L1 here
steps:
Download the bootloader-L1 ( link above)
Unpack "bootloader-L1" in "internal memory" (/sdcard)
Open the terminal and run these commands
su
cd sdcard
sh unlock.sh
Done Bootloader Unlocked
[/LIST]
i did it for training, but then i tested fastboot device-info and it showed locked.
then with fastboot oem unlock it worked. would it work without it?
How to enter fastboot mode?
johnny_s23b said:
i tested fastboot device-info and it showed locked.
Click to expand...
Click to collapse
How did u enter on fastboot mode? I can't find the correct key combination, and adb reboot-bootloader doesn't work...
EDIT: I've used an TWRP Installer APK which just unlocked bootloader and installed twrp, rebooting to it and now I can enter fastboot by rebooting to bootloader in TWRP
Hi,
I have Micromax Canvas A1 AQ4501 which comes under Android One. It’s upgraded to Android 6.0.1.
I tried to unlock its boot-loader but it’s not successful.
I did
• adb reboot bootloader
• adb devices (it shows device.)
• fastboot oem unlock (after this command its stuck on 'waiting for device')
• fastboot flash recovery recovery.img (after this command its stuck on 'waiting for device')
I changed USB cable and plugged it in another port but no changes.
I tried to root it using Kingo Root from PC. After 15 to 16%, it says, failed.
Please help me to fix this issue.
Regards
Ugn10
I unlocked bootloader by using same command as you used but successfully
But i am not able to boot into twrp recovery
I am still having stock recovery
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Sent from my Micromax AQ4501 using XDA-Developers mobile app
error:cannot load 'boot.img'
it wont let me flash it says
error: cannot load 'boot.img'
when i use the command fastboot flash boot boot.img
I have a problem with a lg g2 mini (lg d620), is bricked but only start in fastboot mode (is the correct mode?), im trying to enter fastboot commands because my phone is detected as *Android Bootloader Interface*, but all these commands that i put on cmd, finish on errors; the phone show this *failed writing block @1*, and the cmd window show *FAILED (remote: failed to erase partition)*
Well, i think the fastboot erase partition command will work, but end on error (Partition table doesn't exist)
If you asking what happened when i put fastboot flash commands, end on the same way (remote: flash write failure).
Extra: fastboot erase system -w fail
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I find some solutions that need to short circuit some pins of the emmc chip, but can't understand what pin need to touch with another one, so, trying to find a more easy solution, is there any way to create a partition table via fastboot?
https://forum.xda-developers.com/g2-mini/help/lg-g2-minid620r-hard-brick-recovery-t3543466
this thread should get yours phone unbricked
i have the same problem somebody sent me partitions.txt for the LG G2 Mini LTE?
Hello!
I have a Allview X3 Soul (clone of Gionee S6)
GsmArena link : https://www.gsmarena.com/allview_x3_soul-7913.php
So, i managed to get it in fastboot mode through adb. The phone screen shows this:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
So it says that fastboot AUTOMATICALLY turns off to keep the phone safe.
PC doesn't detect it in fastboot, only adb
I have rooted it and then unrooted with KingRoot (NOT KingoRoot) 1 year ago, and after that wireless connections stopped (wifi, cellular data, calls and bluetooth), I couldn't install some apps.
3 months later I tried rooting with Magisk Manager (bad idea, i didn't have twrp or unlocked the bootloader). Same thing happened as last time, adding that the wallpaper became blank black
Anybody knows how to unlock bootloader through adb or to enable fastboot mode through adb?
EDIT 1
Performed a Hard Reset, same results
You do not have to use fastboot to flash TWRP recovery ..or any new rom .. use sp flash tool to flash the orginal firmware
I get the "< waiting for any device >" error even though it can detect my device when I use "adb devices".
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I've tried updating the drivers with "android_winusb.inf" and it doesn't work either.
ADB and Fastboot are 2 completely different softwares, hence require different drivers. To get Fastboot work install the Samsung Android USB Driver suitable to your device.
Samsung Android USB Drivers for Windows (Latest: v1.7.59)
Download latest Samsung Android USB Drivers for Galaxy mobile phones/tablets to transfer files and flash firmware using Odin. Compatible with Windows 11, 10, 8, 7, and XP computers.
www.thecustomdroid.com
A11with_the_person said:
I get the "< waiting for any device >" error even though it can detect my device when I use "adb devices".View attachment 5429197
I've tried updating the drivers with "android_winusb.inf" and it doesn't work either.
View attachment 5429199
Click to expand...
Click to collapse
use fastboot..downgrade..use bs wifi next trick