Hi collective brain, i am searching for a buttonshortcut to power down my poco F1 . touch screen is not reacting any more and i need to change the display.
If anyone ever did that i will be very thankful for an idea.
i tried the mouse connectin version - failed.
i tried the shortcut to shut down for Mi - failed.
all best simone
simone2311 said:
Hi collective brain, i am searching for a buttonshortcut to power down my poco F1 . touch screen is not reacting any more and i need to change the display.
If anyone ever did that i will be very thankful for an idea.
i tried the mouse connectin version - failed.
i tried the shortcut to shut down for Mi - failed.
all best simone
Click to expand...
Click to collapse
i just pulled of the battery connector cable - works
simone2311 said:
Hi collective brain, i am searching for a buttonshortcut to power down my poco F1 . touch screen is not reacting any more and i need to change the display.
If anyone ever did that i will be very thankful for an idea.
i tried the mouse connectin version - failed.
i tried the shortcut to shut down for Mi - failed.
all best simone
Click to expand...
Click to collapse
You can hold the power button for around 30 seconds, you might also hold the volume down button.
Related
Not sure if anyone can give some advice on this...
If the battery goes dead or if for some reason the phone has to start up,
It goes back to inital config!! - ie: - tap screen to start, set up the phone etc...
all apps, settings etc have gone, as if its a new phone!!
Its highly frustrating and wondered if anyone can help.....
thanks
......just wondering, does the phone have a small battery that keeps its memory??
maybe that needs changing??
Try a hard reset.
how do I do a hard reset?
thanks
is this right??........
# remove the battery cover.
# observe that by the USB port, there is a small indentation. This is the reset switch access.
# Keep the slider closed.
# power the phone on.
# press the “talk” and “end” buttons; while holding them down, use the stylus to probe into the reset switch hole at a 45 degree angle to the major axis of the phone.
# when you get to the “press enter to reset the phone” page, press the center dpad
yep, thats right
didnt work,
when I reset or battery dies etc. It reboots back, as if its a new flash....
have you tried changing the radio and/or the rom?
andy_dutch said:
Not sure if anyone can give some advice on this...
If the battery goes dead or if for some reason the phone has to start up,
It goes back to inital config!! - ie: - tap screen to start, set up the phone etc...
all apps, settings etc have gone, as if its a new phone!!
Its highly frustrating and wondered if anyone can help.....
thanks
Click to expand...
Click to collapse
I Had exactly the same problem
I tryed all the 6.5 rom in this forum and the problem continues
i also tryed changing the radio.
I tryed a 6.1 rom and get the same rhing.
The only solution was flashing the original rom from htc
There is some strange error in this new roms.
I have the same problem!!
Now I have the Salvy C83 v3.3 rom on my Touch dual...
JMD2006 said:
I have the same problem!!
Now I have the Salvy C83 v3.3 rom on my Touch dual...
Click to expand...
Click to collapse
The only way to get the phone running again was to install the original htc rom
And it has to be this one:
http://www.4shared.com/account/file..._13171012_Radio_Nike_1582123_signed_Ship.html
Thanks for the solution, now it works.
Hey everybody
I just expose my problem
1-the Folio 100 i bought is a new brand (received yesterday)
2-I turn on my Folio 100, just in beginning they is no light on the 4 buttons,
i wait android to boot and in the homescreen i try to use the 4 buttons, nothing happens, no light
3- i decide to install the Foliomod without wipe (because the home button like the 3 another button don't have any light, i try to press the buttons many time, still nothing)
4- I install foliomod successfully without wipe everything work better but still the problem of the 4 buttons (no light and don't work)
5- I install different recovery.img but impossible to use it, it's simple, when i press the power button, don't have any light on the 4 buttons, look like the 4 buttons are desactivate on boot mode or anything else
I was wondering if anyone have the same problem ?...
I battle with that, i try to do a reset mode with the button near the battery, get off the battery (power button hold like do a clear CMOS) still nothing
I'm tired to send the Folio back
I really want to fix it, they is no way to fix this problem ?
Thanks !
one thing i find pretty annoying is the fact that to press the buttons you have to make contact with your whole finger.
I dont mean to make presure, I mean to make contact with a large portion of skin than just taping the button.
I got my folio one week ago and I am still getting used to it.
Maybe you already tried to tap the buttons in several ways but... this is the only thing I can think of right now.
By the way... the default behavior es to have the lights off and to turn them on for a second when you tap the buttons.
I hope this helps...
Thanks but if you check what i said, i can't use the buttons.
Usually the home button you can use it on recovery mode but i can't do anything, it's like the 4 buttons don't exist, like desactived.
try to install folio widget and change the button sensitivity
roglio said:
try to install folio widget and change the button sensitivity
Click to expand...
Click to collapse
If the home button don't work on recovery mode, i don't think folio widget can help, foliomod 1.4/1.3 has already a folio widget and changing the value of the sensitivity didn't change anything
I think the problem is more on the boot of the folio, didn't activate the 4 buttons
Sinate said:
I think the problem is more on the boot of the folio, didn't activate the 4 buttons
Click to expand...
Click to collapse
its seen before... open folio and remove battery .. wait 20sec and reinsert and boot .. same can happen to sdcard slot and vol button etc.. very strange hardware we got..
Dexter_nlb said:
its seen before... open folio and remove battery .. wait 20sec and reinsert and boot .. same can happen to sdcard slot and vol button etc.. very strange hardware we got..
Click to expand...
Click to collapse
Like i said, i already do that i don't know what happen with this hardware, i start to regret.
If i can't fix, i will send back
Did you see the folio forum on the website toshiba was deleted ?...
Sinate said:
Did you see the folio forum on the website toshiba was deleted ?...
Click to expand...
Click to collapse
what a bummer.. (just saw it now)
does that say something about them and their next release..
i will NOT be supporting their next tab for sure!
Dexter_nlb said:
what a bummer.. (just saw it now)
does that say something about them and their next release..
i will NOT be supporting their next tab for sure!
Click to expand...
Click to collapse
When we press the power button have a small boot sequence, it's probably this boot sequence make many problem.
I try to erase the boot and change it on fastboot mode but it always fail.
Sinate said:
When we press the power button have a small boot sequence, it's probably this boot sequence make many problem.
I try to erase the boot and change it on fastboot mode but it always fail.
Click to expand...
Click to collapse
bootloader is closed source.. probably needs re-designed, and we havent seen any updates of it, since their update.zip probably cannot write a new one..
i think they forgot to add support for updating it..
just like the full wipe with power button, probably also a mistake..
That what i was thinking
Mistake to Mistake
This reminds me the TG01 (phone by toshiba, really suck)
Hi, I bought a crashed folio just to see inside it's guts and found that those bastard buttons are a board on its own.
I'm going to reverse engineer those signal and replace them with push buttons.
All these OEMs should learn that touch technology is only for the screen and nothing else!
roglio said:
All these OEMs should learn that touch technology is only for the screen and nothing else!
Click to expand...
Click to collapse
i think Google figured this out for us since they invented touch buttons somehow..
Unbelievable!
The chip on the capsense board is a PIC16F722 from MicroChip!!!
PIC16F722 <--- difficult to program and too much problem on it, they use this on clone phone in China.
I sent back my Folio, i don't know if i get a new one or wait for the XOOM or iPad 2 (but don't make any sens without USB/Thunderbolt, SD card etc)
Hi guys.. remix OS is almost perfect for me most of problems has been solved but after sleep I can't unlock the screen
I have dell XPS 12 i don't have keyboard and I don't use mouse but
When i press windows button from the tablet ( working as home button before sleep) nothing happened and power button not working in any statement
Actually in stock android-x86 the power button works but it has the same problem in sleep .. even when press the power button still black screen
@katana444 that's not button related. It's because Power Management is not fully supported/developed yet on many devices. It is one of Remix team priorities for a fix.
Sent from mobile
Is there a way to prevent the machine from going to sleep then? I'm pretty sure the max I can set is 30 mins and I tried a keep alive app that doesn't work.
Sent from my ASUS_Z00TD using Tapatalk
Under settings/development/keep screen alive while charging
Cheers
mitchell4you said:
Under settings/development/keep screen alive while charging
Cheers
Click to expand...
Click to collapse
Yep thanks I came across that myself today too!
Cheers
Sent from my Asus ZenFone 2 Laser using Tapatalk
The problem unfortunately not solved in version 3.0.204 I have already installed it
Hi!
I bought xiaomi my pad 4 on aliexpress, it comes with Mokee pre-installed.
The vibration when pressing a key does not work, I have tried applications to test it and it has not worked.
I have seen a video of android 8 that from GBoard activate the vibration, but I have gone to look for the option and it does not appear.
Does anyone have this tablet? Does the vibration work?
I return the tablet to the seller?
I would appreciate your help, greetings.
I don't think it has a vibration motor, mine doesn't vibrate either.
phobus81 said:
Hi!
I bought xiaomi my pad 4 on aliexpress, it comes with Mokee pre-installed.
The vibration when pressing a key does not work, I have tried applications to test it and it has not worked.
I have seen a video of android 8 that from GBoard activate the vibration, but I have gone to look for the option and it does not appear.
Does anyone have this tablet? Does the vibration work?
I return the tablet to the seller?
I would appreciate your help, greetings.
Click to expand...
Click to collapse
I don't know any tablet which has a vibration motor..
Thanks for the answers. I'm more relaxed
I thought the tables also had vibration.
It is strange to press a virtual button and have no tactile response.
Anyway, the tablet is very good.
I'm not an expert in hardware. But I have searched for mipad 4 teardown and in the pictures I have not seen any motor.
I will make one last attempt changing Mokee for original MIUI.
?
phobus81 said:
Thanks for the answers. I'm more relaxed
I thought the tables also had vibration.
It is strange to press a virtual button and have no tactile response.
Anyway, the tablet is very good.
I'm not an expert in hardware. But I have searched for mipad 4 teardown and in the pictures I have not seen any motor.
I will make one last attempt changing Mokee for original MIUI.
Click to expand...
Click to collapse
vibration works in miui man ?
I'm using official MIUI with OTA support and there's not any vibration setting in SwiftKey keyboard. Attached screenshot.
Same settings screen shows vibration setting in my phone.
So, no, there's not vibration for keyboard in this tablet.
Mi Pad 4 has no vibration! GPS module also absent!
When I'm charging my phone and I turn my screen off, the screen lights up again and you can see a small white border as if the home button was held and Google turned on. If I turn the screen off again, it does the same again. The phone charges normally. I have tried different outlets, but I haven't tried different chargers. Please could somebody tell me how to fix the screen lighting up? Thanks in advance.
seems like ghost touch! need more details, rom, version, etc
Try using a different charger, that solved it for me
peroanjo said:
Try using a different charger, that solved it for me
Click to expand...
Click to collapse
Didn't work for me...
YasuHamed said:
seems like ghost touch! need more details, rom, version, etc
Click to expand...
Click to collapse
I have the Pocophone f1 128gb rom 6gb ram version running MIUI Global 11.0.5.
Not sure if this will help, because the more I look into this the more it seem like a mechanical error.
It's a new feature in Google assistant called Ambient Mode(Something Like That) You Can turn it off in Google settings.
Thank you so much! It solved the problem.
arcy1102 said:
It's a new feature in Google assistant called Ambient Mode(Something Like That) You Can turn it off in Google settings.
Click to expand...
Click to collapse
Solved.