"no signal" after i run the bandswitch. - MDA, XDA, 1010 General

i was not able to use the phone after i run the "bandswitch" with the old rom, until now the phone doesnt work. plss help. what happen to my phone? the pocket pc runs but the phone doesnt, it says "no signal" what happen? HELP :?:

badram11 said:
i was not able to use the phone after i run the "bandswitch" with the old rom, until now the phone doesnt work. plss help. what happen to my phone? the pocket pc runs but the phone doesnt, it says "no signal" what happen? HELP :?:
Click to expand...
Click to collapse
Check the rear sticke rof your device.
Then enter bootloader and set band manualy to the right band (PW10A -> 900/1800, PW10B -> 900/1900)
HTH
Stefan

Related

[Q] IMEI failed?

NCS cannot read my phone's IMEI, it says "IMEI Failed" in the Basic Info. When I punch the *#06# in my phone it says "Failed" as well.
I can't get the phone out of flight mode (probably because of this!). Has this happened to anyone?! I believe my phone is some sort of developer model. There was a "security" sticker on it when I bought it used. Is it possible that my phone was nuked by the network/Nokia cause it never should be fallen into the hands of a consumer?
Chynkinese said:
NCS cannot read my phone's IMEI, it says "IMEI Failed" in the Basic Info. When I punch the *#06# in my phone it says "Failed" as well.
I can't get the phone out of flight mode (probably because of this!). Has this happened to anyone?! I believe my phone is some sort of developer model. There was a "security" sticker on it when I bought it used. Is it possible that my phone was nuked by the network/Nokia cause it never should be fallen into the hands of a consumer?
Click to expand...
Click to collapse
Did u solved ur problam brother ?
chandrau_1989 said:
Did u solved ur problam brother ?
Click to expand...
Click to collapse
same problem ....

4.03 RUU, unlock bootloader. I loose network

Guy here is the story. I was on the earlier RUU: 3.14. Anyways got the 4.03.XXX.X RUU from android police.com. Locked the bootloader. Flashed the RUU. Everything is fine and it boots up fine. I have data(both 3G and 4G). As soon as I unlock the bootloader(I'm using the Rezound all in one tool" to do it): I am not able to connect to the network. Says "no service". The mobile network tab under "quick settings" is grayed out. In "settings" tab, under "mobile network" it says: Use phone for data connection when Wi-FI is unavailable. WiFi is OFF. Does anyone have ideas as to where or what I am screwing up? Thanks in advance for any help.
try factory reset on hboot(will wipe phone but not SD card)
Make sure phone is in LTE/CDMA or Global mode.
stlcity said:
Guy here is the story. I was on the earlier RUU: 3.14. Anyways got the 4.03.XXX.X RUU from android police.com. Locked the bootloader. Flashed the RUU. Everything is fine and it boots up fine. I have data(both 3G and 4G). As soon as I unlock the bootloader(I'm using the Rezound all in one tool" to do it): I am not able to connect to the network. Says "no service". The mobile network tab under "quick settings" is grayed out. In "settings" tab, under "mobile network" it says: Use phone for data connection when Wi-FI is unavailable. WiFi is OFF. Does anyone have ideas as to where or what I am screwing up? Thanks in advance for any help.
Click to expand...
Click to collapse
you might have some sim card problems
I feel stupid LOL
Guys I figured the problem...I had to remove the back cover to remove the battery.Kept forgetting to put the battery cover back on before rebooting. Read somewhere that the antenna is on the back cover...NO wonder I could not get data connection...."facepalm"..Feel so stupid...LOL
Can I S off from the new RUU?
stlcity said:
Can I S off from the new RUU?
Click to expand...
Click to collapse
i did. and to get the timing and get it on the first try use this http://dl.dropbox.com/u/5026593/S-Off_Timing2.aac?dl=1 link i found on the faq for s-off. it's simple to do just don't let it discourage you

[Q] Help me please!!!

Hi forum, this is my problem, I just unlock my WT19 with wotan server.... and it say me "disconect your phone and turn on"....
after that i do that, my phone dont recognize the sim card... and I dont know why.....
can someone help me please??
no SIM detected
DanyBerumen said:
Hi forum, this is my problem, I just unlock my WT19 with wotan server.... and it say me "disconect your phone and turn on"....
after that i do that, my phone dont recognize the sim card... and I dont know why.....
can someone help me please??
Click to expand...
Click to collapse
wow,
I did the same with fastgsm ( its X Unlock Tool looks incredibly similar to wotans -quite identic?)
And my phone is the Xperia Ray ST18i:
ST18i detects a SIM card when booting, for I have to tip the correct SIM PIN.
Wrong PIN leads to re-asking for PIN.
Right PIN completes booting, but then there is "no SIM detected - insert SIM card and reboot".
No problem, if I only take photos, just use gps and always can use Wifi.
But sometimes I really want to use my phone to make a phone call or use 3G internet connection.
Now I heard something about 'radio something fix' in software.
Even some SIM cards should be unreadable for some ROM ???
Somebody there with more profund knowledge about that?
chorknabe1
btw, DanyBerumen,
might be better to NOT update the firmware over the air FOTA
with this I knocked out my Ray after unlocking with fastgsm.
Fortunately I found a way to fix it again... -but still "no SIM is detected" :crying:
chorknabe1 said:
wow,
I did the same with fastgsm ( its X Unlock Tool looks incredibly similar to wotans -quite identic?)
And my phone is the Xperia Ray ST18i:
ST18i detects a SIM card when booting, for I have to tip the correct SIM PIN.
Wrong PIN leads to re-asking for PIN.
Right PIN completes booting, but then there is "no SIM detected - insert SIM card and reboot".
No problem, if I only take photos, just use gps and always can use Wifi.
But sometimes I really want to use my phone to make a phone call or use 3G internet connection.
Now I heard something about 'radio something fix' in software.
Even some SIM cards should be unreadable for some ROM ???
Somebody there with more profund knowledge about that?
chorknabe1
btw, DanyBerumen,
might be better to NOT update the firmware over the air FOTA
with this I knocked out my Ray after unlocking with fastgsm.
Fortunately I found a way to fix it again... -but still "no SIM is detected" :crying:
Click to expand...
Click to collapse
Hi!!
I tell you what I done, after a few reboots, I try to unlock my phone with s1tool, and when the process finished I turn on my phone and I have signal again!!!... Maybe this be a problem with the service, because the tool that I used is "X unlock tool" hehehe....
i hope that you can use your SIM card again
DanyBerumen said:
Hi!!
I tell you what I done, after a few reboots, I try to unlock my phone with s1tool, and when the process finished I turn on my phone and I have signal again!!!... Maybe this be a problem with the service, because the tool that I used is "X unlock tool" hehehe....
i hope that you can use your SIM card again
Click to expand...
Click to collapse
ahm :
happy NewYear !
didnt see your post, only gifts, cookies, fireworks...
sorry.
but now:
good idea, s1tool. but
What did Ray tell You: Bootloader unlock allowed - yes or no ?
mine is NO.
so I'm not so happy with this in this year. yet.
chorknabe1

tab wont connect to WCDMA network after playing around with rooting stuff

I don't know what I did to my SGH-T859 I rooted it, and tryed to download a phone into it now I messed it up, when I try to connect to my sim network it trys to then says network unavilible, I think I might have changed the firmware for it when I tryed to put a phone on it ,maybe modem? Or something ? Any clue what I could do to fix it?
soakthesoul said:
I don't know what I did to my SGH-T859 I rooted it, and tryed to download a phone into it now I messed it up, when I try to connect to my sim network it trys to then says network unavilible, I think I might have changed the firmware for it when I tryed to put a phone on it ,maybe modem? Or something ? Any clue what I could do to fix it?
Click to expand...
Click to collapse
Flash back to stock

[Q] After kernel flash no signal.

Hi. I've done something stupid xD. When i tried to flash kernel to stock i didnt exclude baseband and now i have (no service) problem. In about phone shows baseband version 2.1.71. Whats more interesting, phone finds network operators normally but when i try to connect (phone dont connect automatically :/) shows "your sim card doesnt allow connection to this network". Thanks for any help in advance .

Categories

Resources