my is working position outmatic hang then reset my set but is not working press prower button show orange light indigate and green (calling butten) and red[calling butten] what a problem
Related
Hi everybody,
I need help to unbrick my PDA.
If I power on, It shows only the tri-color page of the bootloader but without light and without any text indicating the version of IPL, RADIO, ecc.
If I connect io to the USB charger, the red led flashes, but if I take away the battery while still connected to charger, the red light stays on...
The phone had the No-GSM problem, and was flashed probably with the wrong ROM.
I've tried all the methods shown in the Thread to unbrick Hermes, but noting worked.
I've not read this tipe of brick anywhere.
Can someone please help me?
Many thanks !
Reset SPV M3100
Switch off the SPV M3100, then on the bottom of the phone you have the answer call and end call buttons in clusters of 3 buttons on each side. The Top button on the left is a dash like symbol -- above the windows button, and you have the same dash like symbol button -- on the right above the ok button. You need to hold down both the dash-like symbol buttons and the middle silver button at the same time, then restart the phone. The phone will ask you if you want to reset the entire phone memory and settings back to factory settings and confirm this by using the Query keyboard letter "R". Click R and it will wipe it and set it back to its original settings. Hope this helps. Thanks Pete from www(dot)86plex(dot)com
Hi all!
I am experiencing a very strange problem with my Nokia Lumia 800.
1. Upon switching it on the screen turned black after Nokia and Windows Phone logos.
2. Only the battery, cellular signal and wi-fi icons are shown when I sweep with my fingers down.
3. Volume and power buttons are working (volume bar shows up on top).
4. No interface is shown on screen, no tiles, nothing except the items from item 2 above.
5. Sensor buttons on bottom make the phone buzz but nothing appears on screen.
6. It is still able to accept calls, i.e. call menu pop ups and allows you to pick up.
Any ideas what's wrong and what to do?
Wow, never seen this!
Keep the power key pressed for about 10 second until the phone shut off
Hello,
I moved to CM10.1 the 3/4 Nightly a couple days ago, and it was working fine.
Then yesterday out of the blue the dialer stopped working.
When I press the call button, there is a delay where the screen is black except for the status bar and the home buttons are backlit.
Then the calling screen comes up w the timer etc but you can hear no ringing and eventually the call stops.
The in-call buttons are also responding poorly: press the speakerphone button and the whole button stays blue for a second, then it shows the blue line at the bottom.
I went to Setting-Apps and cleared the cache and force closed both Phone and Phone/Messaging Storage and rebooted and it still does it.
I've got the full 4 blue bars with HSPA:10.
Should I reflash an older 10.1 nightly?
Flashed the 3/7 build just now ... Same issue.
It's almost like the speaker gets disabled when a call is made.
Hi ill be short and quick
My s3 boots normally shows logo and sudden disappears i hear booting sound and notification light but screen is black like no life and when it bots soft keys lights up and i need to wait about 3 seconds before that press power button than press it again
than i can use it its normal and sometimes if i soft press power key or menu key screen is black and i tried to maximize and minimize brightness and i see black screen so little lights up and back dims! and i need to press power button to lock it and again to make it working battery is old 2 SOC time bearly with 100% with no network
I can't go in recovery it works but black screen ..on download mode i can with no problem and everything else works i don't think its battery thing i can change it no problem and network is wired i type in pin its unlocked and it shows no network i go to settings and search for my carrier it says registered on network but emergency calls only i will go to repair shop but first if u know anything big thanks! :fingers-crossed: :fingers-crossed: :fingers-crossed:
and please dont delete post till someone reply with knowledge
FakerS3 said:
Hi ill be short and quick
My s3 boots normally shows logo and sudden disappears i hear booting sound and notification light but screen is black like no life and when it bots soft keys lights up and i need to wait about 3 seconds before that press power button than press it again
than i can use it its normal and sometimes if i soft press power key or menu key screen is black and i tried to maximize and minimize brightness and i see black screen so little lights up and back dims! and i need to press power button to lock it and again to make it working battery is old 2 SOC time bearly with 100% with no network
I can't go in recovery it works but black screen ..on download mode i can with no problem and everything else works i don't think its battery thing i can change it no problem and network is wired i type in pin its unlocked and it shows no network i go to settings and search for my carrier it says registered on network but emergency calls only i will go to repair shop but first if u know anything big thanks! :fingers-crossed: :fingers-crossed: :fingers-crossed:
and please dont delete post till someone reply with knowledge
Click to expand...
Click to collapse
Solved Solved Solved Solved Solved Solved Solved Solved Solved Solved Solved Solved
Hi,
My Honor 9 has still black screen. Indication of chargering working properly, vibration, when I turning on to and when I press the power button, the buttons under the display light up. I tried soft reset with volume down and power button, but it didn't help, only vibration and restart with black screen.... Honor has no damages like new! Any idea? I would like to try disconnect battery. Will be usefull?
up ? did you manage to wake up your screen ?