hi mates,
what size torx screwdriver is needed to take apart the my polaris?
thanks
it is T5.
thanks for answers mates :
Related
my wallaby dropped and is not clear anymore. i can see some white lines across the screen then if i shake it well enough i can see it go blur. can i open it. i have a feeling its a cable that came off in it. or am i done for :?:
PLEASE HELP
Get a small flat blade screwdrive and a number 6 torx screwdriver. You need to get a thumbnail or plastic card between the 2 halves to seperate them. All will then be revealed.
thanks that helped alot. i got it opened. and some how it started working well again n since that was the goal i am happy. again thanks alot :lol:
I am looking for some help/instructions as to how to do this. Has any one done this before? I am wondering if this would be easy or difficult.
Thanks in advance.
JSenthil
Here is information how to disassemble StarTrek http://forum.xda-developers.com/showthread.php?t=313066
Replacing is very easy, You only need to unscrew front cover. Few screws and lift front cover(first the plastic part, then more screws and metal part), unscrew screen and disconnect it. The front metal part sometimes doesn't lift but You'll figure out how to do it. And make sure you clean everything because dust always gets on the screens. Good luck.
Hi Kucyk,
Thank you for the link and explaining how to do it. This is exactly what I need. I appreciate it.
Thanks,
JSenthil
i lost all screws from my touch hd. any idea where i can get new ones?
refresh my question.
same question.. i need some screws to
+1 here, only because when I disassembled mine I '*****ed' one of the PCB phillips screws
Hi!
I'd like to open my Galaxy tab 10.1 since i need to change the digitizer..
I can't open the gt without the right screwdriver. What screwdriver am I supposed to get? And where can I get it?
If I remember correctly, you don't need any fancy screwdrivers as all the screws used in the Tab are simple crosses. You do need your screwdrivers to be small enough of course.
But for replacing the digitizer, I don't think you need any screwdrivers at all. The digitizer is just glued to the front and the cable held in place by the connector on the backside of the board. All you need is something to pry the casing loose, like a plectrum You might need a small flathead one to click the digitizer connector open, but other than that nothing.
So when you changed the digitizer, you didn't take it all out of the cover? Since I have bought quite a lot of screwdrivers both triwing y0, didn't work either. But the tablet is using triwing screws..
I've now removed most of my digitizer - my problem is now that i need to remove the cable from the backside - which i need a screwdriver, to be able to get to that cable.. What should i do now?
I all
i need to know if the digitizer of Achos 101 Xenon Lite is the same model of the Archos 101b copper one.
The model-code is the same HXD-1027 SR, but i need to know if the frame is the same too.
Anyone can help me?
Thanks in advance
Cheers
Solved!! The digitizer model is HXD-1027 SR.
Thanks