Htc Hd2 phone has no previous image or rom. I have tried the Task29 and once it completes and i reboot the phone, an triangle appears which says software update fail please try again then it continues onto the RGB screen. Screen says SS-B3 after that SPL-2.08.HSPL 8G XE, CotullaHSPL 0x05 and 0x50 all on the red part of the screen. Im going to be using T-mobile, If anyone can help that would be great.
Related
i have hd2
info
PB81100 HX-BC
SPL-1.66.0000 XE
Microp(LED) 0x05
microp(TOUCH) 0x40
when i turn on that got white screen,i try run hspl2 but stop on runing page
cannot install hspl2
plz help me
what did you do to your HD2?
have you already flashed a custom-rom before HSPL?
omg.
lxno1007 said:
i have hd2
info
PB81100 HX-BC
SPL-1.66.0000 XE
Microp(LED) 0x05
microp(TOUCH) 0x40
when i turn on that got white screen,i try run hspl2 but stop on runing page
cannot install hspl2
plz help me
Click to expand...
Click to collapse
Have you followed the installation instructions for HSPL2? What error messages do you get? Does USB show up when in bootloader screen, are you running HSPL as Administrator etc etc etc.
Please supply a little more information than this if you want help.
i just playing game ,and receive a call then phone stoping in game picture
i take out bettery , and put it back ,pown on phone ,got white screen
misterious behaviour... have you tried a hard reset? that should help at last.
(hd2 wasn't made for playing games! ^^)
My HD2 was repaired. Board/IC changed and also new screen.
But the guy said software needs to be installed. The screen was stuck on the first white screen with "htc".
I tried installing custom ROMS, HSPL etc but it got stuck with triangle and exclamation mark. I read lot of forums and realized I need to flash with stock rom using SD card. I downloaded the below stock/ship ROM from HTC site did the same with SD card flash and everything went successfully.
RUU_Leo_hTC_Asia_WWE_1.48.707.2_Radio_Signed_15.28.50.07U_2.05.51.05_2_Ship.
Now after I did hard reset and restarted the phone it is again back to the same white screen with "htc".
Following is displayed in bootloader
PB81100 HX-BC
SPL - 1.42.0000 XE
MicroP(LED) 0x05
MicroP(Touch) 0x30
Can someone please help with step by step guide on how can I recover my HD2?
hello i'm in need of dire help! i flashed my htc hd2 with the dexter rom and all was well after that i tried to flash to a clean rom series and it doesnt happen!!! nothing! i can change anything. when i try to change my spl version its the same it says i need to have 1.42.000.i tried downloading it from htc website but after i input my S/N it says that this software was not made for my phone. could someone please help me? this is what my boot loader shows
PB81100 HX-BC
SPL-2.08.000 8G XE
MicroP(LED) 0x05
MicroP(TOUCH) 0x30
you don't have hspl, run hspl3 choose 2.08.hspl then run your rom flash.
i was flashing a new rom on my hd2. i used "active sync," started through the flashing process and the phone came to the all black HTC screen with the status bar but it did not finish to 100%. it got to 40% and froze, then the wizard took me through a recovery process. my phone is stuck on the red green blue and white screen displaying: " ss-b3 spl-2.08 . hspl 8g xe 0x05 0x50 cotullahspl. what do i do from here?
model id is corrupted. you can try flashing stock from sd card, but i suspect you may be now stuck.
Hi,
I been given a HTC HD2 from a friend, when i turn the phone on all get in a white screen, and nothing if connected to the PC over USB. I've to re-flash with ROMs, but with no luck. If i load into the Bootloader, i get the following.
PB81100 HX-BC
SPL-1.42.HSPL XE
0x05
CotullaHSPL 0x30
From what i have learned so far, this is because the phone has been played with and had the ROMs/Radio changed.
My question is..
Can i get the phone working at all?
Can i get to work again on its origional Vodafone ROM?
Thanks in Advance