I have made a reset and put the phone to the box. After one week I take it and try to Power On. But the red light flashes. So i try to charge, but the same red light apear. Then, I replace new battery the phone powered on, but aftered pin code it freezes. So i shut it down, and the phone will not loads anymore. I put my old baterry and tryed to update software. On update the phone freezed, so I unplug cable and see that update is failed. Now eerytime when i trying to update or reipai ir loads until 90 percents and I get a message failed. Please check or replace the battery or contact sony support. Now when I try to Power On the Xperia x10 green light appear phone vibrate and I see only black screen. Any logo nothing. When replacing the battery the problem is the same green light vibrate and nothing. I think that it's the software fault. Could anybody can help me to solve this problem ?
Related
Hey everyone. This is a quote from androidforums.com it is not my own writing, but this is my exact problem.
"Hey everybody, i recently bought a Sony Ericsson Xperia x10i and thought i should root my phone, using the following tutorial:
Newbies Guide to Rooting X10 and giving you the newest firmware! - xda-developers
So, i was following the steps and after i completed step 5, my phone refused to turn on. At first, the phone would initially vibrate like normal and the LED light would turn green, but then immediately turn off. 5 seconds later, the phone would start constantly vibrating with a black screen and the phone would become unresponsive. To turn it off i had to remove the battery.
I then downloaded the Sony Ericsson PC companion and tried to repair my phone. However, it did no good. Now my phone does the initial vibration, except this time the black screen would lighten up slightly and just stay like that.
I then attempted to charge my phone overnight and when i woke up it just flashes 3 red lights where the LED light is.
could somebody please help me? i only bought my phone 3 days ago and would be a COMPLETE waste of $600 if i was unable to get a replacement phone due to the void of warranty due to rooting.
Is there any way of fixing the phone? If not, is there any way of removing any trace of me rooting or attempting to root the phone (without turning the phone on since i can't) in order to use my warranty?"
My phone has now gone so flat (and doesn't seem to charge) that i can't enter flash mode.. although it was working last night before i went to bed and i did manage to update it using SEUS. But it wont boot up properly. Any ideas? I have noticed that there are a few other people that are having the same problem.. but no one seems to have a solution.
I have also noticed that it runs in a loop. When i plug it in the red light flashes for a while, then attempts to turn on.. and does the black screen for a while. Then it runs out of battery and goes back to the red flashing light. then it repeats.
Hope you can help. Thanks.
Have you tried flashing new firmware with flashtool?
As i tried to explain above.. my phone wont enter flash mode as it is too flat. And it wont charge. when i take it off the charger and try and turn it on. it flashes red three times then a break then three times again and so on.
Any ideas on whats going on?
would it be possible to still claim in on warranty as it wont start properly and wont connect to the computer.
Phone Model - Motorola Cliq (MB200)
My battery got totally drained yesterday afternoon, when i was charging it, i tried to turn it on, apparently i was able to get to the bootscreen (with the M logo in the middle) when all of a sudden it shut down after a few seconds. When I tried turning it back on again, the screen won't display anything at all, just black screen. I kept on pressing the power button continuously and it would vibrate and the LED notification light at the upper right corner is lighting up, which indicate that it's trying to boot however it still wouldn't display anything. I tried removing the battery, sim and sdcard and plugged it into the computer, the keyboard together with the LED light, will both light up but still black screen. I also tried charging the battery using a wall charger, but still no luck. I'm currently running CM7. RSD lite wouldn't recognize my phone anymore. I'm just wondering if you guys could help me out? and was it hard bricked? Is there any solution to this matter aside from the SIG method? Or might it be the battery that i should change?
Would really appreciate your replies....
Hi Guys I have spent past 5 days searching google watching videos on youtube and I still have issue with my Ericson Xperia X10
I have downloaded Flash tool and that stuck on reading device part and does not go any more.
I have downloaded updates service but it cuts of after url downloaded the software need it, and when it tries to update the phone it self.it says fail I tried this few times.still same thing.
I have downloaded Sony PC Companion same thing it will not update.
I tried videos on youtube from plugin phone in to main charger not the PC and sticking down the on button still nothing happens
I also tried pressing Volume and on button same time still nothing happens.
if I plug the phone in main charger it blinks with red light if I try and turn it on it will blink 3 times with red light and nothing happens
on some occasions it will have steady green light for about 5 minutes and then it just goes off and no green light and no blinking.
This is really frustrating for me and any help would be greatly appreciated.
I have Sony Ericsson xperia x10 ( white version ) please advice.
Thanks guys.
The red flashing LED generally indicates the battery is completely depleted.
Plug the phone into a wall charger and leave it for a few hours, after which (hopefully) you should see an solid red/orange light as it charges.
If it does start to charge when the red LED stops flashing and you get a solid red/orange LED I would suggest to charge it for a good 12hrs+
If may take over an hour before the red flashing LED stops and turns a solid red/orange depending on battery state.
For best charging(and if you still have it) use the original Sony EP800 charger with Sony EC600L cable that came with the phone, as this 'pumps' the largest amount of Amps into the battery and charges quicker.
If you don't get a solid red/orange LED on the phone after approx 3-4hrs charging, then you may need to look at purchasing a new battery.
Dr Goodvibes said:
The red flashing LED generally indicates the battery is completely depleted.
Plug the phone into a wall charger and leave it for a few hours, after which (hopefully) you should see an solid red/orange light as it charges.
If it does start to charge when the red LED stops flashing and you get a solid red/orange LED I would suggest to charge it for a good 12hrs+
If may take over an hour before the red flashing LED stops and turns a solid red/orange depending on battery state.
For best charging(and if you still have it) use the original Sony EP800 charger with Sony EC600L cable that came with the phone, as this 'pumps' the largest amount of Amps into the battery and charges quicker.
If you don't get a solid red/orange LED on the phone after approx 3-4hrs charging, then you may need to look at purchasing a new battery.
Click to expand...
Click to collapse
Hi thank you for your reply
My issue is this when I plug it in to main charger and not PC solid green light comes on for about 2 minutes and then nothing no blinking lights or anything any ideas or suggestions on this please?
oOSTAROo said:
Hi thank you for your reply
My issue is this when I plug it in to main charger and not PC solid green light comes on for about 2 minutes and then nothing no blinking lights or anything any ideas or suggestions on this please?
Click to expand...
Click to collapse
Try removing the battery from the phone and leaving it out of the phone for 2-3hrs.
The green LED indicates it's in 'Flash mode' and thinks it's waiting to start/complete a firmware install.
I'm guessing you don't have a Sony EP800 charger and Sony EC600L cable and that you using some other combination of charger/cable.
[Update]
After the battery has been removed from the phone (overnight would be good) then insert the battery back in the phone and see if you get a solid red/orange/green charging light and if so, charge for 12hrs+
The reason I ask about the Sony EP800 charger and cable, is that I know it provides over 900mAh draw which means the phone 'should' know it's a AC wall charger, but many other charger/cable combinations only provide a USB ~500mAh draw which could prompt the phone to think it's still attached to a PC and thus remain in it's last connected state. i.e. Flash mode.
Just an idea.
Dr Goodvibes said:
Try removing the battery from the phone and leaving it out of the phone for 2-3hrs.
The green LED indicates it's in 'Flash mode' and thinks it's waiting to start/complete a firmware install.
I'm guessing you don't have a Sony EP800 charger and Sony EC600L cable and that you using some other combination of charger/cable.
Click to expand...
Click to collapse
Thank you for your reply again this is the charger I have
ebay.co.uk/itm/Genuine-Mains-Home-Micro-USB-Walls-Charger-For-Sony-Ericsson-Xperia-X10i-UK-/140647228895
It is genuine sony ericsson charger usb can plug in to charger it self or in PC as seen on above link. I have removed battery now and will wait for few hours and will try again as you advised above.
Thank you again for your prompt reply will update this thread tomorrow see how it goes. Have a good night.
oOSTAROo said:
Hi Guys I have spent past 5 days searching google watching videos on youtube and I still have issue with my Ericson Xperia X10
I have downloaded Flash tool and that stuck on reading device part and does not go any more.
I have downloaded updates service but it cuts of after url downloaded the software need it, and when it tries to update the phone it self.it says fail I tried this few times.still same thing.
I have downloaded Sony PC Companion same thing it will not update.
I tried videos on youtube from plugin phone in to main charger not the PC and sticking down the on button still nothing happens
I also tried pressing Volume and on button same time still nothing happens.
if I plug the phone in main charger it blinks with red light if I try and turn it on it will blink 3 times with red light and nothing happens
on some occasions it will have steady green light for about 5 minutes and then it just goes off and no green light and no blinking.
This is really frustrating for me and any help would be greatly appreciated.
I have Sony Ericsson xperia x10 ( white version ) please advice.
Thanks guys.
Click to expand...
Click to collapse
Hi did you install the driver's for flashtool from the folder?
If your SEUS file failed during download then re-download it and go back to stock.
It will update itself and restart be patient :good:
After the install is finished Sony Update Service start's up then follow the on screen instruction's. Agree to license - click Start - Choose x10 - press next etc
Just Follow onscreen Instructions
If your phone has trouble with back key and plug in usb,
Then leave the usb plugged into both phone and computer with your battery out!
Then hold back key and put your battery in :good:
doodownunda said:
Hi did you install the driver's for flashtool from the folder?
If your SEUS file failed during download then re-download it and go back to stock.
It will update itself and restart be patient :good:
After the install is finished Sony Update Service start's up then follow the on screen instruction's. Agree to license - click Start - Choose x10 - press next etc
Just Follow onscreen Instructions
If your phone has trouble with back key and plug in usb,
Then leave the usb plugged into both phone and computer with your battery out!
Then hold back key and put your battery in :good:
Click to expand...
Click to collapse
After trying everything as suggested still have issues so I have ordered original battery for my xperia x10 when it arrives I will try again see if I can turn my phone on. Thanks for all the great suggestions
Reflash 2.3.3 firmware using flashtool
Hi, I think i have a unique problem with my phone. I dropped my Sony xperia Z2 from knee height and now it will not turn on. The battery was on 70% when i dropped it.
If i try to boot it into recovery or download mode, it doesn't work either, it just doesn't power on.
Now the odd thing is, when i connect a charger to the phone, the notification light turns on and flashes a red color. The phone turns on very briefly displaying the Sony Xperia Logo before turning back off again and this happens repeatedly. This leads me to believe that the issue is to do with the software and not the hardware. If this is the case then i feel as though the problem can be fixed without having to open the phone.
Do you guys have any idea what the problem is? or what can be done/tried to fix it?
Just to add, i tried to push the red reset button down which is located next to the sim card holder. This achieved nothing.
Any Help is much appreciated.
Thanks
Hold the reset keys till it vibrates 3 times
Volume up + power
Or red key under the left flap
Once this is done try powering on your device and it fails to work then flash a FTF or try to
If this fails then you have done some damage to your device hardware and you need to contact a repair centre
So, my phone is just suddenly wouldn't turn on. When power button is pressed, it vibrates and a green LED blinks. The screen turn on but aways black, no logo, nothing. It remains this way ultin I retreat the battery. Flashtool can see the divice, in flashmode and fastboot mode. I've tried flash three different stock roms and even Xperia 2011 Range_FreeXperia_ALL.ftf, no success. Any advices?
Sorry for my bad English, this is the first time I post.
Your flex ribbon might have worn out. I had similar response (the phone vibrates, detected under flashtool.. etc) then I replaced the flex ribbon and it comes back alive. No guarantee though
thanks, i'll try to replace it.