Hello guys,
I have searched the forum and tried all kinds of combination of buttons to get my phone to boot up but to no avail. Last night I was trying to flash the phone using odin and the latest OTA firmware. I was able to get into download mode and odin detected the phone. I selected the PIT and PDA files and hit start. After 5-10 minutes went by it was still sitting there so I thought it did not really start transfering so I tried to reboot the phone so I can start again and now I just get a picture of a cell phone, exclamation point and a computer. No matter what I do all I can get is this screen to come up. Download mode doesn't come up. Even if I pull the battery and connect the phone to the AC charger I see this screen. I tried doing a hard reset and that doesnt work. Nothing I do seems to get me to any screen other than the screen i described above. Anyone have advice for me? Thank you.
Connect the phone to your PC and open Odin. Hold down power and the volume buttons. When the screen goes black, release the power button. It will go into download mode. Since Odin is already open, it should recognize the phone.
I've had your same problem many times. About 20% of the time, Odin just hangs and I have to retry. It's scary the first time, but don't worry (that's what she said)
YOU WERE RIGHT! This error screen was throwing me off. I just held it for several more seconds after these error screen popped up and the screen went blank. It is flashing now!! Thanks!
Glad everything worked out! Odin can definitely be a pain sometimes.
Related
Was attempting to flash one of the leaked samsung roms using ODIN. Only way we were able to get phone into download mode as using the ADB command line with ADB Reboot Download.
Odin saw it, we started the process. Seemed to be working, but it got stuck with a black screen for over an hour (when I flashed my Vibrant process to all of 10 minutes). We thought the phone just didn't reset, so we unplugged it and hit the power button...and the dreaded cell phone...!...PC screen came up.
I've tried all manner of trying to get into recovery/download mode with no avail. Again, we tried EVERY combination of button presses to get INTO download mode initially, but only the ADB command line method worked.
Now we cannot get past this screen. Any ideas???
SCREWED!!!! Call TMO and have them send you a new one. Nothing you can do if it is hardware locked.
That's what I was afraid of. That is what he is going to do, glad mine didn't have that happen as that ROM has my Vibrant working like it should (GPS works now!!)
I wonder if having to force download mode via ADB was an indication that this phone would have a problem with flashing anything to it??
Never had a brick as many times as I fooled with my Dash and G1. Guess it was bound to happen sometime.
if the battery pull method won't get you into download mode you're likely screwed...
- Make sure USB cable is connected to PC, but disconnected from phone
- pull battery
- hold down VOL+UP & VOL+DOWN and do not release
- insert battery
- insert USB cable into phone
If after a few seconds download mode appears, release VOL keys...and....you've got download mode...if not, it's safe to say your gonna replace the phone..
If that works, I'd also recommend using Odin3 v1.30 instead of v1.00 that most people use. Available here... http://forum.xda-developers.com/showthread.php?t=790026
Wishing you the best of luck!
Try runnin odin with NO pit or pda file. Ive been at that screen like 100 times, let me kniw what it does
You mean start ODIN and just plug in the phone?
tweak89 said:
You mean start ODIN and just plug in the phone?
Click to expand...
Click to collapse
try my steps in this post , works every time for me, to get to download mode ...
I'm trying to load the Unofficial 2.2 ROM onto my phone and I'm using the Odin method. I got into Download mode, got the pit and the ROM and put it all in place, the process starts but it just keeps getting stuck at "Do not turn off the Target." Now if I restart it, it won't even go into my phone.
Any suggestions why it keeps stopping at that point?
Q and A section
ferhanmm said:
I'm trying to load the Unofficial 2.2 ROM onto my phone and I'm using the Odin method. I got into Download mode, got the pit and the ROM and put it all in place, the process starts but it just keeps getting stuck at "Do not turn off the Target." Now if I restart it, it won't even go into my phone.
Any suggestions why it keeps stopping at that point?
Click to expand...
Click to collapse
My advice is to repost this question in the Q and A section and then edit your OP, to indicate you've done as much... Add a link in THIS OP to your Q and A thread. You should get some help after that i'm sure.
does you phone just sit at a black screen? mine did the same thing black screen to where i doesnt look like its on but if you turn the lights off in the room your in you will see the screen is actually lit! no idea on how to fix this myself... on mine if you press and hold the vol up, vol down, and power buttons for a while, (until your fingers hurt) you will eventually see a black screen with red writing with some stuff i was unable to understand! but thats all i could get out of the phone... called t-mobile and they sent a replacement... but i would like to know what i did wrong because i will be flashing froyo alot and i dont want to run into this problem again... btw can get odin to recognize the phone at all!
If your phone is not Hardkey locked.
1) Remove battery from phone and put it back in again
2) Plug your USB into your computer (and make sure it is not in your phone yet)
3) Push and hold down your two volume keys (DO NOT HOLD DOWN THE POWER BUTTON)
4) Plug in the USB cable into your phone
This takes me into Download every time. I did what you did. I had problem with Odin my phone and it just got stuck. I unplugged the phone and rebooted it. Or I should say I tried. It was dead to the world. Black screen. Power button did not start etc. Ran into a note from Kazer and he suggested the above procedure and it worked every time for me. Holding down the power button did not work for me.
Try it out and let me know if it worked.
i was in the middle of flashing stock oidin when my kid pulled out the usb cable!!!!
now all that happens is when i hit the power key the download mode comes up but nothing else and the pc doesnt see the usb plugged in!
ant ideas?
Try plugging in while off then turning on while holding vol up/down...? Plugging in while already on.... give it 30 seconds or so while plugged in with ODIN on, etc? Mine doesn't always show up instantly, but I've had my phone unplugged while ODINing, and I just had to restart the process. I've heard that sometimes you just have to keep messing with it and trying, and sometimes after 30 mins of trying the phone will show up.
Also, try quitting ODIN and starting it up again.
Best of luck!
Got it working I took the battery out plugged in the usb then held down a 3 keys!
But for dumb reason clockwork wont go in to recovery now?
That's what happened to me, on my vibrant. After I restored it CWM recovery didnt work, and wouldn't "download recovery". But I tried updating froyo and completely ruined it so I have no solution. But this thread may help you.
http://forum.xda-developers.com/showthread.php?t=932981
Hi All,
So, I tried to flash Cyanogen mod last night using the instructions here: http://wiki.cyanogenmod.com/wiki/Samsung_Vibrant:_Full_Update_Guide. I was coming from a BIONIX ROM that flashed fine.
Anyways, the phone went into a reboot loop in the recovery screen and I foolishly just held the power button until it stopped. When I turned it back on it was broken. That is, now all it does is display the white Vibrant logo in the middle of the screen with the smaller Samsung logo below it. If I hold the power button for about 8 seconds the screen goes black for about 2 seconds and then comes right back up to where it was. I can't seem to even turn the phone off any more. It just stays on that screen permanently unless I hold the power button, in which case the screen is off for 2 out of every 10 seconds. Yanking the battery of course turns it off, but putting it back in immediately returns it to the state I've described.
I've scoured these forums and tried every button press + battery state + cable state + SD card/SIM state combo suggested, but the phone won't go to download or recovery mode. I found one thread describing the exact same problem. The OP said he'd try a jig and then disappeared without any further updates. I'm going to try to get my friend to make a jig using one of these sets of instructions
http://forum.xda-developers.com/showthread.php?t=819551
http://factoidz.com/how-to-unbrick-your-samsung-vibrant-galaxy-s/
but until then my questions is: does anyone have any experience with this problem (can't even turn the phone off)? If so, do you have any recommendations? Did a Jig work?
keep trying to get to download mode, pull battery, plug usb in to computer and to the phone, while holding both volume up and volume down pop in the battery. People have tried hundreds of times with it not working and then all of a sudden *bam* download mode.
So... my friend made me a jig and it works in that I can see the shoveling droid indicating download mode. However Heimdall/Odin won't recognize my phone. Heimdall's zadig utility won't locate the phone either, even with the cable plugged in. I'm, once again, stumped.
Just an update; I've tried Odin on three different computers, two Windows 7 (64 bit) and a Mac (with Heimdall). None of them seem to recognize the phone. Device manager on the Windows 7 machine does not update when I plug the phone in (in Download mode via the jig or not) and I can't find anything about Samsung in it anywhere. However I have installed the Samsung drivers; a few different sets I've found around the forums. I've also tried a couple utilities like the Vibrant toolbox and one click unbrick. Nothing seems to have any effect. I was so hopeful when the jig worked and got me to download mode, but now it's seeming I'm actually bricked. Has anyone seen a phone that could get to download mode but still be bricked? Oh, and I checked the cable using a friend's phone; her Mac recognized her phone using the cable. Haven't tried her phone on my Window's machines though.
Once again, any help is more than appreciated.
Have you tried to see if adb is working? If it does then try adb reboot recovery? If it works there is a file I can post for you later (is in my pc) that can restore your sbl.bin and fix your download mode problems.
Thanks for your help everyone, the problem was apparently resolved by a new cable; which is strange because the old one works for data transfers... just not for flashing apaprently. :S
So, I wanted to update the Rom, so tried to go into recovery mode. Pushed the volume down button instead of up, so got into download mode. Pushed the volume down button to cancel. Then pushed the right combination, but nothing past the Galaxy S2 logo with the warning triangle happened.
Tried to reboot a couple of times, but now the phone is completely dead.
Everytime I turn it on the Galaxy S2 logo appear, and when it dissappear the phone seems to be dead. However if I look closely, the screen is not turned off, it it just black (but turned on), and every 5 seconds or so I can see it "blinking", but it blinks "black" if you could say that, you won't notice it if you don't look careful, or you are in a dark room.
If you triple click the home button you normally "invert" the colours on the screen, and this also works in this case. Instead of it flashing with an almost unnoticable black, it is now white and every 5 seconds the screen turns off very briefly, but then the screen is white again.
To get it to stop doing this I need to remove battery. If I push and hold the power button the phone just restarts with the galaxy s2 logo, and then does the same again.
When I connect the phone to a charger or to a PC (while it's powered down), the battery logo appears for a couple of seconds, and then it enters this "blinking" screen thing again.
When connected to a PC it does not appear as a drive - however it seems like windows detects it, it installs the GT-9100 drivers. Samsung Kies can't connect, it just keeps trying to connect forever, without coming with an error, but it's not connecting.
Hard reset is not working in any of the described ways, whatever I do, if its to get it into recovery mode, download mode, or just trying to turn the damn phone on, it just do the blinking thing.
Is this some sort of a boot loop from hell!!?
sounds strange, can you still get it in download mode without issues?
If you can i would advice to flash back to stock(!!)
or you could try to flash a cf-root to see if thats gets you into recovery format system, data, cache, dalvik and flash the new rom.
but im not sure if that would work, a clean install from stock would be better i believe,
as to why it went this way i have no idea!
Good luck!
If you can get in download mode, flash a stock rom with odin and that should do the trick
yes!
Well, that was odd, thought I had tried that several times, but yes now at least I can get it into download.
Now I used ODIN to flash a file (CF-Root-SGS2_XX_XEO_LPQ-v5.3-CWM5.tar) that I had laying on my PC from back when I was originally rooting my phone. ODIN gave me a "Pass" reply and I got the phone into a bootloader. I quickly wiped everything I could, and at the moment I'm seeing if I can boot the phone normally.
Thanks!!
Well my rom is f***** it won't boot, but atleast I can get it into recovery mode.
Have just installed cyanogen 9 stable + gapps, it is now booting up!
Luckily I backed my phone up with Titanium backup just a couple of hours ago!!!
it's working!
Well that saved my ass. I was so close to throwing my phone out of the window and going online to order a S3...
Now I'm setting up my phone - nice, wanted to try Cyanogen 9 anyway.
Cool.. Always be patient.... Rather than thinking of purchasin a new phone when these kind of situations occur. Keep a usb jig with you
Sent from my GT-I9100G using xda premium