[Q] Gathering informations from upload mode (URGENT) - Galaxy S III Q&A, Help & Troubleshooting

Hi!
I would need a quick help from you guys pls, i'm facing a kernel panic and want to gather information, when i try to do it with last_kmsg i only get the messages of the boot up in it, no errors (no matter if i try to access it from recovery directly after i shut the device down or from system after the reboot).
Now i'm currently at upload mode because i reproduced it and want to gather information, but i don't know how (sry, i'm a samsung noob, been using htc before).
Any quick help would be much appreciated.
P.S.: Pls post no solutions how to get out of it or solve the issue, i know how, but i want to gather information for the developer that he maybe can fix it.

Anyone pls, there have been already 107 views, if searched myself (and still doing) and all i found has been things like wipe, format,... but no hint how to use upload mode itself to get informations.
Sry about my impatientce, but even if i know it won't harm my device to stay in upload mode i'm a bit worried about it.

Ok, i'm leaving upload mode now, will try to reproduce it if someone is able to give me a respond sometime.

Related

[Q] white screen htc diamond 2 t5388i clon chinese [help me]

Good
Searching the internet I came here to change the rom of my phone, use the hard reset and did not have any problem in the process, then asks me to restart the phone, restarted, and when a screen turns white and does not come out of it, no more than anything.
I'm a little desperate now, I know there is a high-value mobile but it cost me to raise the money to buy it, I hope you have a solution and can help me.
From already thank you very much
PS: sorry for my bad English, I am South American
Sounds like you flashed and incompatable ROM or didn't use hard_spl either way go over to the htc official website - click support find your device and it will list some stock ROMs download an official ROM using the S/N from underneath the battery - Make sure the battery has plenty of charge - plug into your PC and load the stock htc ROM file this should take you through all the standard ROM flash info and will then flash the stock ROM onto your device. Hopefully this will flash back to stock for you and no more white screen.
Good luck and let us know how it went
warlordxxx said:
Sounds like you flashed and incompatable ROM or didn't use hard_spl either way go over to the htc official website - click support find your device and it will list some stock ROMs download an official ROM using the S/N from underneath the battery - Make sure the battery has plenty of charge - plug into your PC and load the stock htc ROM file this should take you through all the standard ROM flash info and will then flash the stock ROM onto your device. Hopefully this will flash back to stock for you and no more white screen.
Good luck and let us know how it went
Click to expand...
Click to collapse
good
I think that what you say is only for original phone htc diamond 2, since according to official rom I read are for the real htc diamond 2.
The mine is not original, as it says is a Chinese clone t5388i, please follow the screen in white, would greatly appreciate if someone helps me out of this problem is quite afflicted.
Again sorry for my bad English
sorry missed the clone bit on your topic . I don't have a clone myself so no ideas if the hard reset works. Might be a good idea to post which ROM you flashed to it
good day
the mobile screen just stayed white and does not know how I can flash now, there will be someone who has been the same and have a solution? I appreciate it, I would be very helpful.
Greetings
HTC_NEW, please check this topic. It's dedicated to the clone phones (except the T5388++ who has it's own topic)
There is a tool called k3AID available who could help you. It's posted in that topic about 50 posts ago. I have a copy if you need it.
There is also another possibility to do a blind flash. This means the screen is not working but the phone can still be flashed. First thing is get the correct firmware for your phone because each time you flash the phone can get bricked / defect.
If my feedback helps you to solve your problem, please give me a thanks on the post.
Eer said:
HTC_NEW, please check this topic. It's dedicated to the clone phones (except the T5388++ who has it's own topic)
There is a tool called k3AID available who could help you. It's posted in that topic about 50 posts ago. I have a copy if you need it.
There is also another possibility to do a blind flash. This means the screen is not working but the phone can still be flashed. First thing is get the correct firmware for your phone because each time you flash the phone can get bricked / defect.
If my feedback helps you to solve your problem, please give me a thanks on the post.
Click to expand...
Click to collapse
hello friend
Reading that topic and searching for the tool by
internet gave me great hope, many users
have managed to solve the same problem, as no
I have a good English I can not understand how it's done
the process, did you guys could help me with a small
tutorial on how to fix my phone with that program?
I enter the program is that you give to download mode and
then I get 'EU entry Not calibration mode! (Mode =
0x00) 'and then does nothing else, I hope I can
help, thanks from now!
hello
I finally entered the discharge mode and while carrying on the idt went for something to eat when I returned I showed up he was 100% complete, the phone went off and did not catch more! Does anyone know it could happen? Is there any way to restart?
please help
K3 AID program
reeprich said:
OK - I can summarize my experiencies:
IDT flash... I think everybody who is doing this experiments have this software...
K3AID... h++p://www.ulozto.cz/6556122/k3firstaid-exe
can switch phone to "download" state even if the HW keys are not working
it suppose working ActiveSync connection (downloaded from mobileuncle com) not my own sw...
Sometimes may be a bit dificult to get K3AID working.. it can show some error message like "RTM state Error" - You need to install h++p://www.ulozto.cz/6556123/cabviaactivesync-1-5-setup-exe
and h++p://www.ulozto.cz/6556124/gb-ppc-2-1-3-20090929-cab
it is only summarize of my experiences - none of this utility is mine, so use it on your own risk
Click to expand...
Click to collapse
@HTC_NEW: Did you do the following steps according to reeprich instructions? What was the end result?
I did read that you used the calibration menu but I expect that you should use the download firmware menu. Is that available? ( I had the software installed but my virus scanner complained that there is a virus in the tmp file...) What's more important if your phone does not work anymore... Please be aware that this is a possible virus.
Removing the battery for a couple of minutes can help for restarting the phone.
htc new
I have done the same thing with my t5388i clone from china.
I tryed to flah the ROM and now I have the white screen.
I used the SOLONOMI t5388i rom, and now it is BRICK - white screen.
Did you get your phone working back ?
Now i´m trying to use other ROM´s , but until now no success.
I used the SOLONOMI t5388i rom, and now it is BRICK - white screen.
Hi,
I had the same problem.
I used the rom postet from parabellum20000 (post # 1354) in this thread:
http://forum.xda-developers.com/showthread.php?p=8573304&highlight=Electronic+star#post8573304
parabellum20000 said:
Electronic star finally sent me (what they claim to be) SD ROM for t5388i. (99.3MB) I personally do not want to verify if it is truth, I am the one fortunate owner of perfectly (in some degree) working phone. Please feel free to use it on your own risk and share results if possible.
http://www.mediafire.com/?ymgvo8bf2t3v4c5
P.S.Please remember, flashing your phone with a wrong ROM is the safest way to brick (damage) it. So do not do it if it isn’t really necessary!
Click to expand...
Click to collapse
I hope this rom helps you to alive your phones again.
Cheers
5290

[Q] Gtab SHW-M380K.

Hi guys. I'm encounting some problem with my gtab 10.1. Since it have a very rage model name for you (SHW-M380K), i think this's because it come to me strangly from Korea, I have problem with rooting my tab, sometimes the root permission works, sometimes it's not.
And the ClockWorkMod recovery is acting very weird, its fuctions work as usual but the screen is all messed up, like the noise effect from an old tv, i can't see the words, the only way i could use it is to lock at xrecovery menu images from internet and blindy press buttons, i did my backup this way. (When it comes from the store, the stock recovery work perfectly)
With this two problem, i have not guts to flash any of your beautiful roms, but again, I love to!
Please answer me, would you guys find out what i did wrong with my tab, and (if maybe), what rom can my tab (SHW-M380K) flashs in your prefer?
my tab have 3G, wifi and all other services. So it's hard for me to say which model am i on, yes i'm a noob, and i even am not an english speaker, so sorry for my dump questions and bad english.
Any one please respond, i'm very apriciated if you guys could help me out
Please, anyone could help me?
I don't think our roms would run on your (SHW-M380K) tab. Sorry, but then again, I'm probably wrong
M380k
lonelycount said:
Please, anyone could help me?
Click to expand...
Click to collapse
Me too, please help me, i don't know how to root and convert it to P7500
I forgot my email address and password yet after many pattern attempts my tab requests for the email and password so please help me

[Q] Can't enter to Downloadmode

My GT-I9100G Can't enter to download and also recovery mode.. Pls help me.. I try already many times .. If another problem is phone doesn't know power when connect to charger...
Most likely going to need to know what it is you did to turn your phone into a paperweight. All not lost yet though tell us what you did and we can tell you the way forward.
N.B this post should really be in Q&A and not in general. There are also many other threads about this. Have a quick search of the Q&A thread see if anything comes up the same. Maybe your answer lays in there.
Good luck

Don't know what is this issue.But need help.

This problem is not actually a problem. Because I don't have any bugs due to it.But it is annoying me.
Here is the issue:-
WHEN I FLASH ANYTHING IT SHOWS AN ERROR BETWEEN THE LOG.BUT IT DOESN'T AFFECT FLASHING.
I want to know why is it happening and how to get rid of it.So please help me.

Anyone can help me with my phone? Blu studio 5.5 s D630u.

Well, hello guys from xda, ill be fan of this site for a long time but i recently made an account just for get a bit of help with my phone since idk wtf im doing wrong(
Well my phone is the blu studio 5.5 s d630u.
First it was stuck on bootlogo, i tried to made an hardreset but i wasnt able to enter into recovery mode idk why.
so i tried to flash it, after i try it pops up an ERROR i dont remember exactly.
Now my phone dont event turn on but when i connect it to my pc the flash from the camera turns on for like half second then it get recognize by my pc.
Now when i try to flash my phone it just gives me any error.
i would like to upload images but i cant idk why or idk how:laugh:
Help me with this PLEASE, im kinda desperate and without money to send it to technical support :s
Ty for view this thread and sorry for my english.
I see you posted over a year ago but hey better late then ever anyway i have the same phone and it did the same thing and i was able to fix it very quickly

Categories

Resources