i can't remember having this issue while running older roms, but now since the update it hangs...i have the feeling that it happens when the signal is poor, but m not sure...anyone having the same problem ?it's bothering me because i have to turn the phone off
Related
ever since i have had my hd2 ive had problems with it, but most seem to have faded away as recently its become pretty stable and fairly good on battery (ever since installing 'NoData')
But the one thing thats still with me is my signal gremlin
when the hd2 is sitting on the desk i get 3-4 bar signal, but as soon as i pick the phone up my signal lowers untill its no longer connected to the network (voda)
im still on the stock rom and radio 2 0 1 51 22~2
any advise?
upgrade the rom/radio
im already on the latest stock rom which is - ROM version:1.72.161.3
is it possible to upgrade the radio on a stock rom, or does it need a custom rom?
I have to say this
when i had build 3.0.xxx my gps worked very well, stable signal during many hours of navigation (i use sygic)
then, with build 4.0.xxx, is a very disaster
the phone loose the signal few times in 15 minutes, so so bad
and withouth reason
the signal is very strong, 6-7 satellites with nice reception, but in a while no more signal, then it fix again after 5 seconds
this is no possible, an hardware issue will be always present i think
so what can be? have you experience this with firmware 4.0.xxx ?
GPS lock performance is very dependant on you clearing cache and user data... then updating. There is nothing wrong with the new 2.3.4 or 2.3.3 firmware regarding GPS - it is very good indeed.
Have used GPS in the city and also in the country and have no issues with it on 2.3.4 on my neo, maybe do a reflash or something, clean install and see if the issues are still there with the gps? good luck man.
Hey guys! This is my first post on XDA, though I've been using it for quite a while.
I'm not exactly looking for answers/solutions, but rather sharing my problem and see if someone else is having them too.
I have a Latin American version of the I91000 (TTT). I recently upgraded to ICS using the official firmware from Samfirmware (UHLPE). At first everything looked great. The performance improvement was noticeable from the first bootup. Not only was it faster, but the intro video was far smoother and looked nicer. The general UI changes are very nice, and I did notice an improvement in battery life.
However, I've been experiencing a couple of glaring issues that really mared the experience enough to make me want to go back to Gingerbread, which I will probably do.
These are the problems:
1. The mobile data connection is very unstable. Sometimes it just doesn't load anything, and sometimes I lose the signal altogether. The 3G/H/H+ icon disappears and all. I never had this problem in GB during the 6 months I've had this phone.
2. The Bluetooth audio connection also has problems. It's now more unstable and susceptible to interference, and the lag is also much more noticeable now. It was about .5 seconds before, but now it's more than a full second.
But that's not the worst issue. The media remote control functions just stopped working altogether, namely, the |<< , >>| , >/|| buttons on my headset. I have a Nokia BH505 Bluetooth headset, and I didn't have any of these problems before either.
So that's it. I would like to know if someone else is experiencing one or both of these issues. I'll also check the Samfirmware forums to look for replies on the matter. Thank you for your feedback.
Hi Guys,
i come from the Moto Stock Rom and have flashed Neutrino 2.6EE few days ago.
Now i've got a little issue with the Wifi Connection.
When I unlock the phone and a known wifi (home and work) is in reach, it takes about one minute until the connection is established.
With the stock rom ist takes only a couple of seconds.
When i go into the wifi settings while waiting, the connection will be established immediately.
Does anyone know a solution?
European Atrix
Wifi-Standby: off when display is off
Rom: Neutrino 2.6EE
Baseband: N_01.100.00R
I also have this issue with every CM7 ROM. I believe it is a bug present in all CM7 based ROM. Flashing a new radio or reflashing your old one may fix this issue, but I haven't tried it because I cannot find a working link to the N_01.77.30p radio for a backup in case of failure in the flashing of a more recent one. If anyone could provide a CWM flashable N_01.77.30p radio I could begin testing to fix this problem.
Sent from the Land of Multiple Cores.
try: http://forum.xda-developers.com/showthread.php?t=1339047
Me too, I used to experience the same problem with older versions of the Neutrino ROM but this new version is working flawlessly. Only one thing, when the screen is off for about 15-20minutes the wifi connection is lost so I keep a wifi settings icon handy on the desktop, but I noticed this issue on the CM7 roms too so it should be a bug there. On CM9 roms the wifi stays on during the whole time maybe try a cm9 rom?
Some reason when I click the download link nothing happens, if you could directly link the file that would be great.
Sent from the Land of Multiple Cores.
This has been discussed many times.
This is either a hardware fault or a CM7 bug. Therefore, I cannot fix it as Neutrino builds are based on CM7, and obviously, if it is a hardware issue, then there's nothing I can do at all.
For now, just pray that CM7 magically fixes it.
I am sorry, I mean no offense to your development, and since my previous post is incorrect or misinformed I am very sorry, and I will change my previous post to reflect this new information. Neutrino is an awesome ROM by the way.
Sent from the Land of Multiple Cores.
I will try a CM9 ROM to see if that fixes the issue. But I will not be able to flash for awhile since I am on a business trip. If someone else could try it out and report findings that would be great.
Sent from the Land of Multiple Cores.
I'm on Jokerz version 0.3ish and turning on wifi gives me an error report followed by random reboots. The problem did not originate with this ROM and I've flashed a handful of different ROMs with no fix.
I got smoked by Windows just for the free phone so I can sell it.
Notorious544d said:
This has been discussed many times.
This is either a hardware fault or a CM7 bug. Therefore, I cannot fix it as Neutrino builds are based on CM7, and obviously, if it is a hardware issue, then there's nothing I can do at all.
For now, just pray that CM7 magically fixes it.
Click to expand...
Click to collapse
So we have all this hardware problem?
Because I have the same issue with my Stock Rom 2.3.4.
What is your advice?Bring it to Motorola Support or wait in this "magical fix"?
This is most likely a hardware issue.
For the latest news regarding the issue check out this thread:
https://forums.motorola.com/posts/0c2f1387d6
If you are having this problem please post!
Cloudus91 said:
So we have all this hardware problem?
Because I have the same issue with my Stock Rom 2.3.4.
What is your advice?Bring it to Motorola Support or wait in this "magical fix"?
Click to expand...
Click to collapse
With the original rom version (45.31.1.MB860.NonEFIGSRetail.en.EU) that was on my phone, the Wifi connection was established much faster.
The second thing is, when I went into the wifi settings while waiting, the connection will be established immediately. It turns from searching to getting ip and then connected.
So I can't believe that this is a hardware problem. I think the phone is waiting for something before the connection will be made or so.
I've serarched a bit an found that:
Notorious544d said:
When your device is connected to Wi-Fi, then it will consume less battery as it needs less 'juice' to receive data from a Wi-Fi network than a cellular network.
However, if you are on 3G, but have Wi-Fi enabled, then your phone will consume more battery than with Wi-Fi disabled as the phone frequently scans for Wi-Fi networks. The scan time is configurable and stock ROM and CM7 scan every 30 seconds, whereas Neutrino ROM scans every 2 minutes. This means that Neutrino will have slightly better battery with Wi-Fi always enabled as it scans 4x less than normal.
To configure the scan time, you'll have to edit the build.prop.
...
Click to expand...
Click to collapse
I measured it again, how much time passes before the connection is available.
It takes about 2 minutes and 5 seconds, until the connection is there.
I think it is related to the scan-intervall.
Can you change the setting, that the phone will scan for wifi when it will be unlocked?
Hello !
For many issues i left Android 10 , issues like battery drain , camera, proximity sensor issue , network issue, restart issue.
Big question will there be a stable Android 10 ultimately??? ?
If then when?
I have two EU Mi A3 phones on Android 10 (one fully stock, second one rooted). There is no battery drain, no network issue, no random restarts. The latest June update (not available for global yet) fixed also camera and "generic" memory leak issue (or at least it's not that visible anymore). The only remaining issue is that Chrome sometimes freezes during browsing, but that could be due to the app itself.
Long story short, A10 is already as stable as A9 was.
Yes, same here, full stock global unrooted, no big issues.
You can use brave browser, no ads and no freezes
Here the situation is totally different.
I have owned 2 Mi A3 phones.
Both were upgraded to A10 (Evolution X with root). While one was stable, the other suffered from automatic reboots when the screen is locked (usually when I'm asleep) or while unlocking the screen.
Both were originally European versions of the phone, but the custom A10 ROM may have installed a global firmware/vendor.
The stable one I gave to my sister and she's still using and upgrading it without problems.
I kept the unstable one for myself and I've tried to repair or at least find out why it reboots by installing different ROMs (crDroid and Evolution X) and different kernels (Bit and Fenix) but so far I've not been able to solve the issue. I've looked at the logcat and even send the logcat to the developer of some custom ROMs.
I suspect that the reboot happened because of the phone activating itself to look for new messages in the background (while the screen is locked). Maybe the phone was switching between different sleep/active states. The reason I suspect this is because I've seen at least once that the reboot happened around the same time that I see in the logfile of my WiFi access point that this phone is having some internet traffic.
Sadly I don't have the right skills to develop my own custom ROM, but if someone with these skills is reading: If you have time, please make a custom ROM based on A9 with signature spoofing and root. I was still using Kitkat a half year ago, so I'm not in a hurry to use A10 or 11.
Update:
I've just read some one suspect that the reboot is caused by the phone trying to adjust the brightness because he was walking out of a building when the reboot happened... so maybe in my case it was the phone (while the screen is off and locked) is receiving a new message and trying to turn on the screen to show the notification.
Well guys there is new disgusting problem faced by me also by many ..
Screen goes off after call , it doesn't alive untill the other person hangs.
We r here mostly use global version.
Facing many bugs!!
Like restart problem!!
Sensor problem..
Battery not stable..!
MI A3 still they didn't declared STABLE 10.
SO I AM WAITING WITH MY GLOBAL VERSION..
_mysiak_ said:
I have two EU Mi A3 phones on Android 10 (one fully stock, second one rooted). There is no battery drain, no network issue, no random restarts. The latest June update (not available for global yet) fixed also camera and "generic" memory leak issue (or at least it's not that visible anymore). The only remaining issue is that Chrome sometimes freezes during browsing, but that could be due to the app itself.
Long story short, A10 is already as stable as A9 was.
Click to expand...
Click to collapse
Yes EU iz most stable ?but still not stable A10
eric2 said:
Here the situation is totally different.
I have owned 2 Mi A3 phones.
Both were upgraded to A10 (Evolution X with root). While one was stable, the other suffered from automatic reboots when the screen is locked (usually when I'm asleep) or while unlocking the screen.
Both were originally European versions of the phone, but the custom A10 ROM may have installed a global firmware/vendor.
The stable one I gave to my sister and she's still using and upgrading it without problems.
I kept the unstable one for myself and I've tried to repair or at least find out why it reboots by installing different ROMs (crDroid and Evolution X) and different kernels (Bit and Fenix) but so far I've not been able to solve the issue. I've looked at the logcat and even send the logcat to the developer of some custom ROMs.
I suspect that the reboot happened because of the phone activating itself to look for new messages in the background (while the screen is locked). Maybe the phone was switching between different sleep/active states. The reason I suspect this is because I've seen at least once that the reboot happened around the same time that I see in the logfile of my WiFi access point that this phone is having some internet traffic.
Sadly I don't have the right skills to develop my own custom ROM, but if someone with these skills is reading: If you have time, please make a custom ROM based on A9 with signature spoofing and root. I was still using Kitkat a half year ago, so I'm not in a hurry to use A10 or 11.
Update:
I've just read some one suspect that the reboot is caused by the phone trying to adjust the brightness because he was walking out of a building when the reboot happened... so maybe in my case it was the phone (while the screen is off and locked) is receiving a new message and trying to turn on the screen to show the notification.
Click to expand...
Click to collapse
Well thats definitely big concerns.. however.. a10 is just out for this device in may update! So waiting for more fixes !
I think dev. Should concern about the feedbacks and bugs..
Not worth to use like this..
I am not ROM developer i have seen only miui11 Working for a9 but i dont like miui at all..
I dont think anyone will make rom for a9. Coz its very irritating work to rollback !
I only like stock rom!
Am just waiting for PIXEL EXPERIENCE..
The rom u use Evolution X has not good camera. Like stock..
I want 99%✓✓ ok custom like stock..