Hi
I used the factory reset function on my tab a couple days ago to delete all apps and such and upon reboot it was stuck at the slowly flashing Samsung logo and would proceed no further. I left it for a good hour and a half in that state before I tried hard resetting it but no dice. I've had it do this before when I first rooted it, but unlike that time it doesn't replay the whole boot animation, just the logo part at the end of the animation. I managed to get it in clockwork mod or bootloader whatever that function is and cleared all the caches and did a reboot recovery (i believe thats what it was called) but upon reboot it did the same exact thing. So after that I gave up and went to bed, but the next day when I went back at it again it wouldn't even turn on. After messing around with the power button and volume button trying to get into recovery mode it finally turned on but went to the battery screen with no other actions. I've tried several times to get it into recovery mode but it either wont turn on or it just goes to the battery screen. I have it plugged into my pc at the moment and apparently it is in recovery mode or something because Odin recognizes it. Says [0:COM3] and the box is yellow, but the screen never turns on though when holding the power button and volume button while it's plugged into a pc, the pc recognizes something plugged into the USB slot. My pc is only recognizing it as a modem and will do nothing else with it.
I have the Starburst rom and the overclocked kernel installed and would like to either revert it to stock rom or perhaps the AOKP rom, milestone 6. Is there any way to do this if I can't boot it into a state where I can access the SD card on my pc? All the guides I've found always require I put files on the sd card to flash in clockwork recovery mod. Thanks for any assistance
Edit: Solved it myself, feel free to delete this post. Thanks!
Related
I recently installed a gingerbread rom Lidroid. it was working ok till i realized i could not stand some bugs. I decided to try cyanogen that was released today. It looked like it installed fine but the phone is stuck trying to install clockwork recovey. it keeps going on and looping at the same screen. the last message it shows before it reboots off is "Replacing stock recovery with Clockworkmod" it just keeps looping doing the same thing. I have tried to get into download mode without success. I have been able to put my phone in download mode the past couple times i have run into trouble. Now i simply cant be able to do it. Any help?
I dont know how it happened but after trying for the past 5 hours, i have been able to get it to work. I took the battery out inserted it back in. I held the volume down button and the power button together. i immediately plugged the phone into USB cable while still holding Vol down and power button. After 10-15 seconds, it brought up the clockworkrecovery. I Wiped everything and the cache. I then tried to reinstall cyanogen(the one that brought all this in the first place) because it was the only one on my sd card. It installed and booted up and now i have CM 7. I can also successfully get into Download Mode
Am not sure what i did, but if anyone can run into such a problem you might try this.
I went from Shostock2 ICS to Shostock Gingerbread--flashed through recovery, everything seemed fine, rebooted a couple of hours later and the phone froze at the "Samsung Galaxy S II" screen. As of now I have NOT been able to get back into recovery though the volume rocker/power method ... Nothing happens at all. Half the time my phone wont boot, period, but if I pull the battery and put it back it will boot the first time into that same screen. Not at home so I can't connect it to my computer but if I can't boot into recovery not sure how I'm going to get my PC to recognize the phone .... (sigh.)
Please advise.
EDIT: Finally managed to get into recovery via volume rocker ... Don't know why it worked this time after failing over and over before. Have reflashed the Gingerbread zip ... Keeping my fingers crossed that it works out.
Haints said:
I went from Shostock2 ICS to Shostock Gingerbread--flashed through recovery, everything seemed fine, rebooted a couple of hours later and the phone froze at the "Samsung Galaxy S II" screen. As of now I have NOT been able to get back into recovery though the volume rocker/power method ... Nothing happens at all. Half the time my phone wont boot, period, but if I pull the battery and put it back it will boot the first time into that same screen. Not at home so I can't connect it to my computer but if I can't boot into recovery not sure how I'm going to get my PC to recognize the phone .... (sigh.)
Please advise.
EDIT: Finally managed to get into recovery via volume rocker ... Don't know why it worked this time after failing over and over before. Have reflashed the Gingerbread zip ... Keeping my fingers crossed that it works out.
Click to expand...
Click to collapse
Boot into recovery and wipe data/factory reset, that should get it to boot after you flash the GB zip!
Started two days ago. Phone would randomly power off and boot back up. Finally it shut off and would not power back on. I had Cm11 installed with CWM 4.0.4.6. The phone powers on after inserting the battery. The Samsung logo flashes and then it shows the "Galaxy S3" logo with the CM logo below it. The phone the powers off. I have done a factory reset, cleared both caches, formatted the system folder, flashed SlimKat from recovery and tried another known good battery. At this point I figured I would reflash CWM but if I put the phone into download mode, it powers off after just a few seconds as well.
If I boot the phone into CWM, the phone stays on as long as I want it to so it makes me think this might be fixable. Just need some help.
Ask in your device forums.
My apologies. Didnt realize there was another S3 board. Found and posted there.
I have 4.4.4 KK SlimROm with Dorimanx latest kernel (Without TRIM). Recently I bought a new extended battery fully charged it and let it discharge fully once. It was s tip for a new lithium batteries on one of the first sites on google search. After that the battery wouldn't charge at all for a few hours (Stuck on 0%) but the phone could be turned fully on. I remembered that once i saw in the recovery advanced options something about battery statistic refresh or something like that and went looking for it in the recovery, didn't find anything, didn't change anything, when I exited the recovery mode it told me the root was lost and if I want to root my phone, I chose yes, then it booted to download mode for some reason, turned my phone off and it stated to charge. I was happy until I tried to turn it on. Its starting too boot, after the Samsung logo it gets to Dorimanx logo and gets stuck there, cant access Recovery or Download mode. Searched the web didn't find anything with a solution only dead threads with no answers.
Please help, I don't have money for a new phone and I waited for this Amazon battery to get here 3 month :"(
TLDR;
Discharged battery wont charge, after it started to charge stuck on kernel loading screen, cant access Download or Recovery Mode. Pls help.
After a few days I found a solution. Here it is to people who has the same problem.
Remove battery, sim, sdcard, before you pluck the battery back hold vol down, pluck it in, power phone, and it should go to download mode.
If not try power+vol down+home, power+vol down or power+home+both volume as you pluck the battery or the same combinations as you pluck in the USB cable to the phone connected to the PC. a few tries should get you here, it was my 5th on with USB and first with holding vol down before plucking the battery back.
Download Odin
download JB rom form http://androidfirmwares.net/PhoneFirmware/Download/133
download recovery from here http://galaxys2root.com/cwmtwrp-recovery/
follow instructions on how to install rom from here:
http://forum.xda-developers.com/galaxy-s2/help/guide-26-12-flash-stock-firmware-rom-t2365701
Install the ROM via Odin(If by chance like me you will disconnect while installing the ROM and cant connect back or stuck on setup connection, just remove the battery for a few minutes and try again, exiting and starting Odin again recommended), after that install recovery, nothing will load but check if you can go to recovery, if yes, just install the same ROM you had from recovery, wipe cache, dalvik, install same kernel, wipe cache, dalvik, it should work with some errors popping, just sync and back up everything you need and reinstall fresh.
Hope it helped.
Hi:
I've read through several "bricked" threads and none of them had the symptom I have so I'm not sure.....
I was on IMNUT's Tweaked Remix (VRAMC3 0906 release) and it's been acting up so I thought I'd move up to a newer ROM (I had planned to go to lacoursiere18's 4.4.2 to start).
I first updated recovery from an old version of CWM to the last version of Philz.
I flashed IMNUT's unlocked VRAMC3 stock via Odin and it booted fine although I hadn't realized I needed to wipe it first so all my apps were there.
I then booted to recovery to see if Philz was still there and found it replaced by the stock recovery (I didn't realize that would happen but I suspected it might).
So, since I used the unlocked version I used stock recovery to flash Philz. The output went by very fast and all I really caught was something about a file check failed (3 lines in red about it) and then a bunch of lines and then the screen went blank.
Now the phone will not do anything - won't turn on, won't go to recovery, won't go to download mode.
I pulled the battery and no change. I was at 60% battery when I started so I connected the USB cable to charge it. The little battery symbol that comes up while charging when you tap the power button did not come up. I tried power on/recovery/download and still nothing.
Am I SOL?
it is sure sounding like it to me... I don't think i've ever had a phone not at least go into bootloader mode.. ( vol down, home and power)