Good Day,
I have an Archos70IT that i had not used in a while, It was working OK, I went ahead and reset everything to factory and it booted OK, I installed applings and Gapps and still worked OK then suddenly it froze, I used the power button to reset and after that I get a boot loop with the Archos Entertainment your way splashscreen and then after a couple of seconds blank screen and almost immediately the same splashscreen.
This is what I have tried/found out so far:
- Tried to boot the recovery console by resetting (Hold Power for 10 sec), waited a minute, tried to boot with Power and Volume Down (-) pressed and I only get a static splashscreen and it stays like that until I reset again.
- Let the battery die by leaving the splashscreen bootloop all night, connected to power and after a couple of days tried again with the same result.
- Have tried resetting and connecting to USB nothing detected by the computer, at this step have tried resetting, holding power + volume up and down and no luck, same result.
So I have no idea on what else to do, I think I screwed up by not updating the firmware before installing apps after the whole factory reset.
Related
Help!
My Tablet S keeps going to the boot animation when trying to connect to the wifi. It appears that once it can connect to my home router it jumps into the boot animation, which stops the wifi, then the tablet will try to connect again. Upon connection it'll loop back into the boot animation. This just loops over and over again.
Tried turning it off and then back on, no luck. Factory reset works, but it this problem comes back.
Any ideas?
what can be is you have to install something wrong or ideally where you bought it back and give you another of the insurance so that error may be the device
Thats what I thought 2 at first...but a factory reset would've removed any faulty apps. U could try a factory reset from recovery mode tho.
For this, shut down tablet and start it by holding both power and Volume up key. Once in recovery mode navigate with ur Vol. down key to factory reset and select it with the power key.
Hope this helps.
My friend brought by his Galaxy Tab 10.1 over for me to fix and another of his friends had loaded a custom ROM on it and it was stuck in an endless boot cycle. I got into the CWM recover menu to factory reset and wipe all cache folders used ADB to push Android Open Kang Project - p4wifi (build 21) followed instructions to a T... Rebooted and started the first time setup of ICS and it froze and rebooted just like the other ROM before. I re-flashed the ROM with out Gapps and factory reset. Rebooted and it got to the home screen and froze again after about 30 seconds. I turned it off (by holding the power button down). Now when I try to turn it on it does nothing. Hold power and vol - it does nothing. Plugged it into the wall to charge it does nothing. Power and vol + does nothing a well. Plugged it to my PC the drivers are no longer found... Tried everything the only signs of life are the fact that when its plugged to the PC the drivers don't install (listed as APX under other devices) and power + vol + makes a 3 beep tone on my windows idk what that means...
From couple of days ago I started to get popups saying "android ____ .com" or something and every time I clicked OK the message would pop up again not letting me press anything but the OK button continuesly.. so I powered off the phone
I powered back up again and my phone wouldn't boot anymore. The screen said "Encryption Unsuccessful" and then there was a "Factory Reset" button right below - nothing happens when I clicked it
So I went on and performed a factory reset by entering recovery mode (power button + volume up + volume down) and after it didn't work I went back to recovery mode and tried "clear cache" which didn't work so I then went to factory mode (power button + volume up) and cleared data by selecting MMC or something (it was in chinese)
What happens next is, the phone enters a boot loop. It boots, shows the Lenovo logo, then turns off, then boots again, Lenovo logo, turns off, and so on. I wasn't even able to turn off the phone so I clicked that red reset button at the back
I didn't try removing the battery or SD card
How do I go from here?
My phone was constantly restarting at the micromax logo, so I took it to the customer care and he fixed the device.
He also said that the device will not be able to last for any more and can only perform some of the basic tasks and couldn't be fixed in the future.
(He said just use it till the time it can be used and rip it when its not working anymore).
After some time, I tried to reset the phone from the settings(factory reset), it booted and came back as it was before(nothing happened it just restarted), then I tried to hard reset it, but it didn't boot up into the recovery mode, After some weeks, It got another problem in which when I power it ON, it shows the logo and then a black lit screen.
I pressed the Volume (Up+Down) Key+Power Key and it showed a screen with "=>FASTBOOT mode..." written at the bottom left corner.
Is there any hope I can fix it again, Or I will have to buy a new device?
Hello,
this is my dad's phone and it started rebooting by itself. When phone boots you can use it for 30 seconds and then it reboots again. I tried to factory reset from settings but nothing happens when I press ok on the last menu. So i tried opening menu when phone is booting (power button + volume down) and selecting factory reset with power button. Phone then showes red triangle with exclamation mark. After 2 minutes phone reboots itself without doing factory reset.