"Dial up networking" is checked and "USB debugging" is checked, but can no longer connect in Diagnostic Mode...I can verify that it worked before with this same phone with JB...I can't connect with BP tools modeI messed around with drivers. But I can't figure out what to do and how do I turn it back on. Anyone have a solution to getting Diagnostic Mode back? on KitKat I am using Droid Razr.
Related
"Dial up networking" is checked and "USB debugging" is checked, but can no longer connect in Diagnostic Mode...
I can verify that it worked before with this same phone...I can connect with another Fascinate now.
I messed around in the "Hidden Menus", just before it stopped connecting in Diagnostic Mode, so that has to be the culprit.
But I can't figure out what I did and how do I turn it back on. Anyone have a solution to getting Diagnostic Mode back?
Kitkat in Diagnostic Mode
"Dial up networking" is checked and "USB debugging" is checked, but can no longer connect in Diagnostic Mode...
I can verify that it worked before with this same phone with JB...I can't connect with BP tools mode
I messed around with drivers. But I can't figure out what to do and how do I turn it back on. Anyone have a solution to getting Diagnostic Mode back? on KitKat I am using Droid Razr.
Hey guys I'm trying to connect my g3 to dfs, I installed sever g3 drivers but no go I get the mtp but no diagnostic mode what's so ever I tried uninstalling and deleting the drivers but nothing works thanks in advance guys .
##DIAG# MSL ENABLE
Check if developers options are on, further USB debugging has to be on.
Under pull-down notification, set the phone to charge only when your USB cable is connected to a comp.
Check with different USB ports.
Hey guys I'm trying to connect my g3 to dfs, I installed sever g3 drivers but no go I get the mtp but no diagnostic mode what's so ever I tried uninstalling and deleting the drivers but nothing works thanks in advance guys .
You need to enable the developers option on and usb debugging on in it. also put the phone in charge mode only from MTP. enable diag using ##DIAG#. Install the drivers again. change USB port also.
Hello, I need help to activate USB debugging mode. I don't know why I don't have the option. I mean, I have turned on the developer options, also I have turned on the USB debugging mode. The problem is that whenever I plug my phone I only receive the MTP mode, not debugging mode. I was in fulmics 7.5 rom and thought that was the problem, but I returned to stock 10B and nothing.
Hello everyone, I use lenovo k6 note phone, the touch is not working stably inconsistently.
so I was unable to activate "developer options" and turn on the "usb debugging" feature.
Despite this, I was able to install software on my phone without any error with the qfil program.
As a result, my phone does not turn on, it shows no signs of life, and when I connect my phone to the computer, it goes into the bootloader loop.
what I can do after that?
@okan_kilkuyruk
Seems you flashed an incompatible firmware. Retry using the correct firmware.