Hi everyone!
I hope I'm in the right forum, I'm sorry if I'm not but I just don't know if that's a android general issue or a specific tablet issue.
So here it is, I just bought the ASUS memo pad HD 7. ( That was my 1st mistake :silly: )
Just after opened the box, I tried to root the device, because of the many useless apps factory installed in it. I installed Titanium Backup and I tried to unistall one or two app to test it.
After that, I was like " Hey... maybe it would be better to update the tablet first, and then root it ", because I don't know if update after a root delete the root ( like a jailbreak on iOS).
So, I proceeded to a factory reset, following this tuto: you tube /watch?v=rMTzwG1IOcc
After that, I started to update the device normally ( actually it started automaticly on startup ). And, during installation ( Green robot on full screen ) it stops and shows:
image.noelshack.com/fichiers/2014/05/1391332670-error.jpg ( copy/paste in browser )
Does the factory reset not a good un-root thing? I thought it would just restore the tablet exactly how it was before the root
How to clean everything properly and make the update works?
Thanks for reading! Hope you'll know how to fix this
Related
I recently purchased an Optimus T and rooted it with z4root and then installed Titanium Backup to delete some of the preinstalled apps, like the Pacman Demo.
As I was removing each app, (~5 at this point) the Home button suddenly stopped working, followed by total phone death. Even after factory reset, when I was trying to access the phone, eventually I was shown a "... setup.exe stopped responding..." (or something like that) message and my phone just stayed stuck on the booting screen (android) every time I restart (w/o entering factory reset).
Does anyone have any ideas, or know which apps can prevent the phone from booting properly? A list of safe apps to delete would be helpful too. I thought I was pretty cautious with removing only non essential apps, but it seem bricked. Thanks again!
daramji said:
I recently purchased an Optimus T and rooted it with z4root and then installed Titanium Backup to delete some of the preinstalled apps, like the Pacman Demo.
As I was removing each app, (~5 at this point) the Home button suddenly stopped working, followed by total phone death. Even after factory reset, when I was trying to access the phone, eventually I was shown a "... setup.exe stopped responding..." (or something like that) message and my phone just stayed stuck on the booting screen (android) every time I restart (w/o entering factory reset).
Does anyone have any ideas, or know which apps can prevent the phone from booting properly? A list of safe apps to delete would be helpful too. I thought I was pretty cautious with removing only non essential apps, but it seem bricked. Thanks again!
Click to expand...
Click to collapse
About list off apps, I have to agree. Even it there is litle problem with dependencies, some minimum describe of these issue will be great!!
So, about your problem - I think, that you will have to download original ROM and do flashing with KDZ_FW_UPdater. (search on xda for more information).
But definitely, if it's possible I would try to install custom recovery throw adb shell (android SDK tools) and do backup of system for possibility to recovery or saving at least few data, and after try wipe and install one of custom ROM.
This happened to me after I tried deleting preinstalled apps on my Optimus One... Sent it in for repairs since it just stopped working. The tech guy said he did a "software update" and everything is good as new (except for the LGMITS error once in a while)
They didn't even bother trying to fix mine. They just told me to send it in and gave me a replacement.
So I finally figured out what I did wrong - basically when I was doing the deleting, I accidentally deleted the LG Home app, which effectively deactivated my (duh) home button and effectively stopped everything from functioning properly. For some reason I thought it was just a simple link from my phone directly to the LG website, as would happen with new PCs very often. Well... won't be doing THAT again.
However, my web2go button isn't working. I have to force quit every time I try to click on it. Can I just get rid of it or will it just give me more trouble later on?
At least you knew what went wrong with yours... I was just erasing CarHome and Layar and the LG App Adviser among other things i wont be using like Twitter and Latitude.
And they even gave you a new one x__x I had to wait 5 days before everything was good as new. After the first fix, USB debugging and mass storage stopped working so I sent it in for another "software update"...
Hello,
I have chinese tablet Irulu eXpro X1, and recently i've tried to root him, i did as is written here : androidtablets.net/threads/allwinner-a33-4-4-2-kitkat-rooted.70443/ and it worked, but after some time i've noticed that tablet after reset are coming to factory settings. Initially i've thought that this is problem with BusyBox ( like this : android.stackexchange.com/questions/52406/why-does-bad-busybox-installation-in-system-xbin-cause-problems ) but deleting BB didn't worked. I've removed root, and did factory reset through recovery, and nothing happens, the problem still exists. Moreover i've noticed that attempting to root tablet again ends up with error, because of complete reset after reboot. Do you have any idea what can i do to fix this issue ?
PS. I'm not native in english, so I'm sorry if i made mistakes.
Anyone can help ? The case is getting worse, auto-rotation of screen stopped working, and after some time of using android show up random errors like "Unfortunately, xxx has stopped"
ichimawero said:
Hello,
I have chinese tablet Irulu eXpro X1, and recently i've tried to root him, i did as is written here : androidtablets.net/threads/allwinner-a33-4-4-2-kitkat-rooted.70443/ and it worked, but after some time i've noticed that tablet after reset are coming to factory settings. Initially i've thought that this is problem with BusyBox ( like this : android.stackexchange.com/questions/52406/why-does-bad-busybox-installation-in-system-xbin-cause-problems ) but deleting BB didn't worked. I've removed root, and did factory reset through recovery, and nothing happens, the problem still exists. Moreover i've noticed that attempting to root tablet again ends up with error, because of complete reset after reboot. Do you have any idea what can i do to fix this issue ?
PS. I'm not native in english, so I'm sorry if i made mistakes.
Click to expand...
Click to collapse
It might be cuz of the king root you need to flash the tablet with the firmware do you still need it?
I need the firmware please if anyone has it. I'm in the same boat here. .
Sent from my XT1575 using XDA Free mobile app
sKoWN_kAT said:
I need the firmware please if anyone has it. I'm in the same boat here. .
Sent from my XT1575 using XDA Free mobile app
Click to expand...
Click to collapse
I asked the same ? on xda no replyies yet but when I get a reply Ill post it here for You
Hi everyone... this explanation may be long but I'll try to put my problem in context, please patience!
First, I have years of experience coding stand alone applications and programs but close to none in Android or web development experience... so ... been confident that I could do something as simple ("Yeh right!") as rooting, why should I backup anything from my phone? Big mistake...
My S2 was getting old, space was getting limited and at first I downloaded some cleaning apps (Clean Master) was good for a time but then I had to start uninstalling some of my favorite applications to keep the phone fully operational. After a while I had nothing else to install, as programmed obsolecense was getting my ass, so I decided to find out some ways to get some room in and I found External2Internal app to use my SD as InternalMem, it did the trick except that there still was the "not enough space" message and some apps still refused to install due to the lack of room. So, basically this only modified the reported space in the Storage section of settings.
How I did this? Well, installed KingRoot and then APK Uninstaller with root and External2Internal to finish the trick.
As the problems continued I decided to research more, found out that there was a "better" way, more 1337 way to ROOT and that was installing a Kernel/ROM that was rooted and that would even improve my OS. So I took a tutorial on youtube and Installed "Siyah-s2-v6.0b5" using ODIN and "I9100 XWLSN .NeatROM.Lite.v4.6.1" with Recovery Mode -> Install ZIP from SD. At the end the CMW kept saying that I needed a upgraded version of it and SU needed to be updated but it failed everytime.
After each attempt I wiped to factory settings, cache, battery and even some delvik...
Nothing worked, I downloaded a console simulator to be certain about the rooting and surprise! It wasn't rooted at all...
Then I downloaded CMW update... SU Update... Syrah update... then tried with 4.6 NeatRom Apollo Kernel....:crying:
Now... the phone won't start... it can go into download mode and recovery mode but after ... nothing... I doesn't show anything pass the Samsung Galaxy S ii start screen with the admiration sign < ! > with the triangle.
I Factory reset, wiped everything and still nothing... doesn't start properly.
PLEASE HELP!!!
[bump] please help!
Hey people,
I have a big problem and I am a big noob what contains to software, hardware is my thing.
Lets get straight to the point......
I have rooted my device(Kingzone K2) with Kingroot on Android lolipop 5.1.
the first time i tried to root it would not work because my phone had a unknown version of android or something like that, so i reported that to kingroot and a month later they made it possible to root on my device.
now I have rooted my device but I started up my phone and all of a sudden my phone was reset to factory setting.
I thought it would have been a accident with android devicemanager.
And up following I wanted to download apps and stuff but it gave me the error that Android.procces.media was stopped.
And the apps wont download I tried everything to download them, also camera and gallery wont work for the same reason.
So can someone please help me with this problem.......
Thanks.
Hi guys please help me i need to have my phone working back |:.... today i updated my wiko fever 4g but i got an error... now when i boot it an android icon shows with "no command." text. Tryed with v.39 program on wiko website but its not working for me... when arrow becomes green download wont start.
I'm thinking to recover system fom sd card but i cannot find roms please help me |: thanks in advance
Same issue here... Finally decided to upgrade the system from stock firmware, and got "error" when it rebooted the phone. Then "no command".
Darknezz89 said:
Hi guys please help me i need to have my phone working back |:.... today i updated my wiko fever 4g but i got an error... now when i boot it an android icon shows with "no command." text. Tryed with v.39 program on wiko website but its not working for me... when arrow becomes green download wont start.
I'm thinking to recover system fom sd card but i cannot find roms please help me |: thanks in advance
Click to expand...
Click to collapse
I solved my issue by restoring Lollipop (v.39) with the tool from the wiko website and then performing the update again; the phone started again (at v.41) and I was able to download Marshmallow from the next system update.
Issue was probably caused by some configuration or application.
Still slowly downloading Marshmallow now, so cannot say anything about the next update, but I guess that will go well, since the phone is reset now.
Just to follow up: Marshmallow is working fine on my Wiko Fever, much better than Lollipop. Amazing update.
Instructions for others after having read some comments from other people experiencing issues with the upgrade:
- BACKUP all your data before upgrading from Lollipop to Marshmallow, as if you would buy a new phone; I luckily did, as I wanted to set the microSD from removable to internal
- remove the microSD and (after having a backup of all your data as per step above) format the card as FAT32 on your PC; better to have a clean MicroSD card for after the upgrade I think
- reboot the phone in recovery mode and do a: wipe cache+reset to factory settings
- once the phone is reset and started, proceed with upgrading to Marshmallow
- don't know if needed after the upgrade to do an additional wipe cache+factory settings reset, doesn't harm to do it though
- be unhappy for the hours lost in restoring the phone data + apps + reconfigure everything
- be happy of the improved phone software
Questions upon questions.
So, i got the notification for the update last week, and i saved it until today to install it. The file downloaded was just 7 mb, i had enough battery for the intallation of the update (30% recomended by the software), something got messed up and an error message with the dead android character appeared. I know i lost all my things contacts and sd card... tried to hard reset the damn thing and nothing. I already googled the problem and i found nothing similar to what i get, i'm stuck in the recovery screen and the phone doenst shut down, every time i force it, it just boots back up after 15 30 seconds. I got to be honest i tought it was just another update but aparently its a "new" operating androind system. They could have told me with a update log or something...