Hello, i got a Galaxy ace, and i replace the screen, lcd and digitizer cuz they were broken, because my girlfriend, have an attack, and drop the phone hard to the floor, i replace both screen, and now, i get into "Download mode" (blind) and i could update the rom (stock) via Kies, but the phone still have the white screen, from boot, always have white screen, after and before screen replacement. NEED HELP Please !
miloosj said:
Hello, i got a Galaxy ace, and i replace the screen, lcd and digitizer cuz they were broken, because my girlfriend, have an attack, and drop the phone hard to the floor, i replace both screen, and now, i get into "Download mode" (blind) and i could update the rom (stock) via Kies, but the phone still have the white screen, from boot, always have white screen, after and before screen replacement. NEED HELP Please !
Click to expand...
Click to collapse
I think your screen digitizer or lcd is not connected correctly to connecter of display so check that or your lcd has problem..there is no problem of software..just check your display is connected right or your display has peoblem..
Press thanks if i helped u..
Sent from my GT-S5830i using Tapatalk 2
most likely hardware not soft
IF YOU BREAK IT SORRY BUT YOU CAN TRY
open up again clean sockets inspect phone for visual damage (near screws edges etc.) to the board
connect screen to board outside of case so you have access to screen socket plug in the charger and gently touch the ribbon/socket when on if no changes try gently bending the board (very gently you do not want to make something loose or even worse snap the thing) see if any effect on display post any findings
|PS its easy to buy faulty screen as they are not transported the way they should be try to replace
Thanks, ill try all advices i hope i can do something with it, cuz she has a few things on it, that she will like to preserve.. and u know.. if she dont get it, will be my fault.. haha Thank so much ! hehe
Related
So... first of all.. i'm relocked, hboot 1.5xx, s-off, official ics
This morning I switched on my evo, looked at time and then suddenly screen came black..
Only sensor buttons worked
Then I tried to remove the battery and power on again
Display was OK but just for a few seconds.. then it began blinking or came black again.. I tried factory reset but no working..
Now screen isn't working, but i can hear HTC sound when i power it on.
Sensor button vibrating when i touch them..
Is it screen failure? Where can I buy new(original would be better) touchscreen?
Or I should try to post it to shop for repair (i think im not under warranty)?
thanks
If you plan on replacing the screen yourself, I'd open it up first and check all the ribbon cables and make sure they are secure. I've had something that simple happen on an HD2 repair. Was set to replace the whole screen and digitizer and the only thing wrong was the digitizers flex cable came loose.
Sent from my PC36100 using Tapatalk 2
I can blindly unlock my screen so i think digitizer is OK, isnt it?
All i just need is this or? http://www.ebay.com/itm/New-OEM-HTC...664?pt=LH_DefaultDomain_0&hash=item336a5156f0
Yeah....but what I'm saying is check before buying it.
Because it could be as simple as the LCD screens flex cable coming loose from the motherboard of the phone. So all you'd have to do is plug it back in and apply some tape.
Sent from my PC36100 using Tapatalk 2
i dont have good screwdrivers at home :X
i also concider that i will try to send it back to shop for repair
If they wont repair it, is possible to pay HTC to repair it?
sry for my english .)
thx
So dropped phone and screen went out. Replaced amoled and digitizer, device powered on and lit up home keys, but no display still. Replaced main board, in case video was out on board, but no joy. Any thoughts? No custom software or anything....
Maybe you didn't clip on the ribbon cables all the way. Or, just try pulling the battery and booting it again.
When I replace my screen, screen didn't work for first few boots.
ddochi11 said:
Maybe you didn't clip on the ribbon cables all the way. Or, just try pulling the battery and booting it again.
When I replace my screen, screen didn't work for first few boots.
Click to expand...
Click to collapse
I checked and checked, digitizer works, I can reboot and swipe unlock, adjust volume, but no screen. At this point I'm thinking bad LCD. Thoughts?
Thx for response and ideas though....
I bought a replacement but ut was a cheap fake, not an OEM screen. It went purple then black within 10 minutes. I got my money back (thank you PayPal) and made sure the next one was an OEM screen.
I hope you didn't spend too much on the repair parts. You can pick up a new Note for about $290 now.
i have Xperia mini (st15i) cell phone. there was a lot of dust inside it and over its LCD screen so i opened the screws of this and cleaned the dust from inside and from the screen also. but when i assembled the phone again and turned the phone ON there is no display. only the light on the top of the phone is turning ON and there is no other light on the phone or screen is turning ON. phone also vibrates when i turn it on as usual only display is not coming.
I have replaced the LCD screen with new one but problem is same. i dont know what to do know please help me to solve this problem. i will be very thankful to you..
Aashirg said:
i have Xperia mini (st15i) cell phone. there was a lot of dust inside it and over its LCD screen so i opened the screws of this and cleaned the dust from inside and from the screen also. but when i assembled the phone again and turned the phone ON there is no display. only the light on the top of the phone is turning ON and there is no other light on the phone or screen is turning ON. phone also vibrates when i turn it on as usual only display is not coming.
I have replaced the LCD screen with new one but problem is same. i dont know what to do know please help me to solve this problem. i will be very thankful to you..
Click to expand...
Click to collapse
probably u damaged yr board or the connection cable. thats why u never should do sth if u not know what u are EXACTLY doing.
we cant really help here, bcuz to do this we would dissassemble the device & take a look. bring it to a tech shop, bcuz like said sth with the HW is surely damaged. sry
today i was checking the phone LCD today and during checking phone display appeared for few moment and than disappeared again.
bejunk said:
probably u damaged yr board or the connection cable. thats why u never should do sth if u not know what u are EXACTLY doing.
we cant really help here, bcuz to do this we would dissassemble the device & take a look. bring it to a tech shop, bcuz like said sth with the HW is surely damaged. sry
Click to expand...
Click to collapse
Hello. Today I get SGS3 from my aunt. SGS3 fell on floor. At first there was some white lines, then half of screen became blue, then the LCD shut down. It isn't working now.
I have a question. Could anything else be broken? I opened phone and i see, that there isn't nothing that could "destroy" LCD.
P.S. Phone boot up, I hear the sound, no view on screen.
You won't know until you replace the screen assembly, probably easier to buy a new phone.
boomboomer said:
You won't know until you replace the screen assembly, probably easier to buy a new phone.
Click to expand...
Click to collapse
Still, phone would boot if there is broken GPU?
Hi there xda.
I gave my phone to replace the battery. To a service that claims they know what they do. Everything was looking good after I got the phone back after an hour.
I left the city so I got to use a satnav and after a while I've noticed a yellow splash on the bottom left of the LCD. It gets more yellow when the phone heats up, and gets less yellow when it cools down, but it's still visible.
I decided to take it apart and the yellow splash/dot immediately disappear.
I've returned to the service but they ofc claim they did nothing wrong.
So I've got a question for you guys, what could they do wrong. When I took the phone apart, I've noticed a curbed cu metal plate over the battery, and got nothing under the battery, between the battery and the lcd. Sth should be there to isolate the battery from LCD or what?
Any help would be appreciated.
Thx in advance
tapatalked
feels bad for this brother. That may b because they hit the screen with a punch aur may b it Being pressed hardly.. even it may b they replaced your screen with old or used one rather than battery
well, the screen looks like the same, the glass has the same scratches.
so if they pushed it to hard or sth, there is really nothing i can do.
rajman said:
well, the screen looks like the same, the glass has the same scratches.
so if they pushed it to hard or sth, there is really nothing i can do.
Click to expand...
Click to collapse
Hi, it may be that they damaged the flex cable for the screen, since my cellphone also heats up but the screen is ok .
Optimus said:
Hi, it may be that they damaged the flex cable for the screen, since my cellphone also heats up but the screen is ok .
Click to expand...
Click to collapse
it might be that it gets a bad display after it heats upa a bit, i'll try to add some copper by myself to isolate the heat between battery and screen/cables