Huawei G630-U10 problems with booting. - Android Q&A, Help & Troubleshooting

Hi guys,
I'm trying to fix someone's Huawei G630-U10 but ran into some serious issues.
The device was stuck on the Huawei logo so the obvious choice was to factory reset to get the phone working.
When I go into recovery to "Wipe Data", it just says "Wiping data..." and then nothing. No formatting and no deleting seems to be done.
I downloaded the stock ROM (Update.app) and selected the option in recovery to "Update from external storage" and selected the file. It gives a message that it's rebooting into update mode to update, but then the device reboots and gets stuck on the logo again.
I've tried going into update mode (Pwr+Vol Up+Vol Dwn) and it just remains on the logo. So I guess only recovery mode works.
Since the recovery couldn't delete anything, I suspect the storage is faulty or corrupted.
PS: the device just stays on until I force to power down. Then it just reboots automatically after a few seconds and remains stuck on the logo until I power down again. This happens as long as I don't physically remove the battery to end the loop.
Any suggestions or tips?
PPS: I've search extensively for flashing tools for qualcomm based huawei but no luck. The official site just hands out the update.app firmware which only works in update mode (which doesn't work in my case).

Related

[Q] [tf201] (unlocked) Prime bricked or not?

Dear community,
I tried to boot into CWM (installed via Rom Manager) but nothing happend after the reboot-to-recovery, invoked via Rom Manager. The tablet was stuck at boot, displaying the Asus logo. No animations and no error messages were displayed. I needed to press and hold power to reset my prime so it would boot my rom again. I was still able to load fastboot (power + volume down)
Next I tried to reboot-to-recovery using Goo Manager. The same issue occurred, stuck at startup, displaying the Asus logo, but now I am unable to recover from that state to load the rom!. When resetting my prime it is still stuck at displaying the Asus logo. No animations and no error message displayed. I can also no longer enter the menu using power+volume down...
I am afraid I perma-bricked my Prime but ofcourse hope it is not the case. Can anybody help me confirming my fear?
Thank you for helping me out!
straumli said:
Dear community,
I tried to boot into CWM (installed via Rom Manager) but nothing happend after the reboot-to-recovery, invoked via Rom Manager. The tablet was stuck at boot, displaying the Asus logo. No animations and no error messages were displayed. I needed to press and hold power to reset my prime so it would boot my rom again. I was still able to load fastboot (power + volume down)
Next I tried to reboot-to-recovery using Goo Manager. The same issue occurred, stuck at startup, displaying the Asus logo, but now I am unable to recover from that state to load the rom!. When resetting my prime it is still stuck at displaying the Asus logo. No animations and no error message displayed. I can also no longer enter the menu using power+volume down...
I am afraid I perma-bricked my Prime but ofcourse hope it is not the case. Can anybody help me confirming my fear?
Thank you for helping me out!
Click to expand...
Click to collapse
That is bricked unfortunately.
CWM only ever worked on the ICS bootloader and there are warning everywhere on here never to use it.
You needed the correct version of TWRP for what bootloader you was on.
If you cannot get into the rom, the bootloader menu or you have nvflash backups that you created before then you are out of luck.
Hi flumpster, Thanks for clearing this up :good:
I think I have the similar problem. I have TF201 Android 4.1.2 installed and a PC Ubuntu 13.04 installed.
-First of all, I used unlocker releases by Asus. Then I loaded CWM by fastboot, but it didn't launch, I loaded CWM Touch, but it didn't launch, I loaded TWRP and again it didn't launch. When I tried to launch recovery rom every time it stuck at splashscreen.(It says booting recovery rom or smth like that)
-Then I tried to start unlocker again, it gave network error.(If you shut down the wifi it asks for internet, I think Asus collecting some information about prime.)
-Then I rooted my device. Again it stuck at splashscreen while trying to launch recovery rom. I reloaded recovery roms again it didn't work. I choose restart to recovery from the ROM MANAGER, it stuck again but nothing about "booting recovery rom" just "device is unlocked" writen. Then finally I installed CWM from ROM Manager again and I choose restart to recovery from GOO Manager. Boom! I think it tries to boot recovery rom in everytime. I can't boot android, I can't boot fastboot, power+volume down didn't work. Even I can't close it, it always restarts and I had to wait until the battery last.
So is there anything to do?

[Q] Oppo Neo 5 Softbricked

Hi guys, I really need your help.
I'm new at this rooting stuffs and I tried to root my Oppo Neo 5.
I tried so many softwares like OneClickRoot, FramaRoot, and Kingroot but none seemed to work.
So I resorted to an app called oppo tools
It worked at first but I got really annoyed when my status bar suddenly colored to red when my phone discharges to 15% so I unrooted my phone and rooted back again. I really thought that was going to fix my problem but that's where the bootloop issue started.
I tried to flash some custom recovery zip but it failed since I only have a stock recovery.
But the thing is, I found a guide that says to rename the clockworkrecovery img to PG86IMG.zip.
So I did tried that and as soon as I flashed the zip from my stock recovery, my phone hanged.
I long-pressed the power button to restart and boot into recovery mode but nothing seems to happen.
I'll try to explain a bit more on how it looks when I boot my device.
When it boots normally (I mean not pressing the volume to enter recovery mode) it will only show the logo but when I try to go into recovery mode it will show the logo with a little text on the lower left portion "Recovery Mode"
Before I flashed the PG86IMG.zip, recovery mode was still working and the charging screen when off is working too.
but after I flashed the zip, every time I try to recovery mode the logo shows up with the little text but RECOVERY MODE isn't working. When I charge my phone it automatically boots up and shows the logo and text like it's trying to go recovery mode (I'm just trying to charge? It's going to recovery mode)
I tried using "adb devices" on cmd but it's not detecting any devices.
I'm really out of ideas guys, I know not all people use this model but what would be your suggestion?
A suggestion on how to fix this would really be appreciated :good:
I'm sorry I'm really new at this, please correct me if I did something wrong starting this thread. :angel:
@DeepBricked please confirm your problem, Boot-loop and can enter into recovery.
Salman Al-Badgail said:
@DeepBricked please confirm your problem, Boot-loop and can enter into recovery.
Click to expand...
Click to collapse
Oh, I'm sorry, I didn't notice.
Lately I can't access the recovery mode but now
I'm currently on Boot-loop and I can enter into recovery.
The ColorOS recovery mode only have limited function that I can mess around.
It only has the apply update, wipe data and cache, reboot, power off and system file verification.
As always I already did wipe the data and cache but nothing happens. Still boot-loop.
What should I do?
DeepBricked said:
Oh, I'm sorry, I didn't notice.
Lately I can't access the recovery mode but now
I'm currently on Boot-loop and I can enter into recovery.
The ColorOS recovery mode only have limited function that I can mess around.
It only has the apply update, wipe data and cache, reboot, power off and system file verification.
As always I already did wipe the data and cache but nothing happens. Still boot-loop.
What should I do?
Click to expand...
Click to collapse
You made a soft brick, not to worry flash it with correct stock firmware, if the phone is in warranty than ask them to do flash, this will take approx 10-30min. If it isn't in warranty than you should try it own or else pay some amount and the rest they will do.
Salman.
how about bootloop, cant enter recovery, reboot continiously when turn on even going to recovery, only fastboot isnt rebooting automaticaly but pc days drivers not succesfuly installed, and when off it qont detect by pc because of rebooting auto,
where can i find a rom for my oppo neo 5
pls help me pls

Bricked Acer Iconia Tab One 10 (A3-B20)

Hi all,
I own the Acer A3-B20 and had it rooted some time ago with Kingroot. Installed a system update by Acer a few days ago and since then the tablet only boots in Recovery Mode. Resetting to factory defaults does not help, the filesystem integrity checker shows a few modified files.
Only viable option in recovery mode seems flashing a new firmware and I tried to do so with the currently available offical ROM from Acer: "AV0L0.B3-A20.RV03RC06.WW.GEN1". Flashing starts successfully but ends in the android screen of death (lying robot with red triangle).
Does anybody have a better idea on what to try? I haven't been able to find another firmware to try except the aforementioned.
Cheers,
Jarek
jarekkut said:
Hi all,
I own the Acer A3-B20 and had it rooted some time ago with Kingroot. Installed a system update by Acer a few days ago and since then the tablet only boots in Recovery Mode. Resetting to factory defaults does not help, the filesystem integrity checker shows a few modified files.
Only viable option in recovery mode seems flashing a new firmware and I tried to do so with the currently available offical ROM from Acer: "AV0L0.B3-A20.RV03RC06.WW.GEN1". Flashing starts successfully but ends in the android screen of death (lying robot with red triangle).
Does anybody have a better idea on what to try? I haven't been able to find another firmware to try except the aforementioned.
Cheers,
Jarek
Click to expand...
Click to collapse
Try Wiping your System partition then doing a Clean Install of the ROM using Fastboot.
Hopefully there will be a option in your Recovery to restart the device in boot loader mode(that's fastboot).
Hi,
Thanks for your help. Unfortunately I'm not able to enter bootloader mode. Recovery mode has an option "Reboot to bootloader" which causes the tablet to power down, nothing else happens.
Also, booting up with Power+Volume Down/Up (tried both) only boots to the same recovery mode.
jarekkut said:
Hi,
Thanks for your help. Unfortunately I'm not able to enter bootloader mode. Recovery mode has an option "Reboot to bootloader" which causes the tablet to power down, nothing else happens.
Also, booting up with Power+Volume Down/Up (tried both) only boots to the same recovery mode.
Click to expand...
Click to collapse
To access the recovery menu on my B3-A20, I use the Volume-Down by itself; The Power+Volume-up combination starts a Chinese factory test/debug menu.

Stuck in bootloop, can't enter Download or Recovery

Hey there,
so I wanted to update LineageOS to the latest nightly (1st August) coming from an April nightly. I did it OTA, entered TWRP, installed the update and got stuck in TWRP, which is apparently a known issue with TWRP 3.0.2.0. But I didn't know that, and tried to fix it by installing a backup of CM 13 WITHOUT wiping data, because I did not want to lose my data. Stupid, I know.
I then found a fix to leave TWRP and tried booting into CM 13 but now I'm stuck in a bootloop. It shows the CM logo, then prepares apps, shows the logo, prepares apps, logo, and so on...
I can't enter Download mode or Recovery mode using the keys and adb/fastboot commands don't work while the phone is turned off or booting.
Any ideas what I can do?
Some more info:
It only bootloops when plugged into my pc. When it's unplugged (or plugged in to just power) it stays at "preparing to start". Sometimes it even leaves that screen but then the System UI keeps crashing leaving me with nothing to do but hard reboot. I still can't Recovery or Download mode tho. And whenever I plug it into my PC, it reboots
So you can't get into downloadmode with holding [Vol Up (+)] and plugin the cable into your pc at the same time?
[Edit]: Sorry, [Vol Up] is the right key.

Huawei Y550-L03 LOOP Restart

Hey, I think the phone is totally brick, can anyone confirm it? Here we go
The phone came totally crazy and it has restart automatically, and went to the Fastboot mode. (i dont know if it was updating something, i had not using it). So, I've UNLOCKED it with the code that Huawei brings, till here everything is fine. The problem becames when I try to flash the CUST, CACHE, ABOOT, and the others that I think that are useless, it says
"FAILED (remote: Command not allowed)". But I can flash SYSTEM, RECOVERY, BOOT and USERDATA correctly. But that doesn't solve the problem of the LOOP RESTART, it show the Logo of Huawei and keeps restarting. I also tried 3 other stock roms, and the problem persists. Also tried putting the dload in SD with the UPDATE.app, and starting the phone with 3 buttons pressed and I have the error of "Error:update.app is a invalid package" and doens't work. (If i go to the Recovery it just stay for 1-2 seconds and automatically restart again). I don't think it could be the power button because it stays well in the Fastboot mode and also tried the CWM and works. I've been searching solutions for around 5 hours and didn't found any. I wish someone could help me, thanks in advance!
PD: I have the ADB Drivers updated.
live it

Categories

Resources