I flashed a custom boot (from cm 9.1) and now it is stuck on boot loop, and it doesn't open the recovery, is there anything I can do?
nevermind I found out I could connect the phone to my pc and open in the bootloader.
marioskg7 said:
I flashed a custom boot (from cm 9.1) and now it is stuck on boot loop, and it doesn't open the recovery, is there anything I can do?
nevermind I found out I could connect the phone to my pc and open in the bootloader.
Click to expand...
Click to collapse
go to the cwm and format factory setting and cache abd go to the amount and storage format system/cache/data and reboot
Jason Nino said:
go to the cwm and format factory setting and cache abd go to the amount and storage format system/cache/data and reboot
Click to expand...
Click to collapse
Thanks so much, for your reply, but I have resolved my problem. Also part of the problem was that cwm was not accessible. But thanks again.
Related
I did everything I was supposed to do, first succesfully rooted the phone. Then I put the zip file with the rom into the sd card and then went into recovery mode, installed file from zip and it said success in install so I chose to reobot and now it hangs there... Any one can help me out? I'm scared...
badaboom423 said:
I did everything I was supposed to do, first succesfully rooted the phone. Then I put the zip file with the rom into the sd card and then went into recovery mode, installed file from zip and it said success in install so I chose to reobot and now it hangs there... Any one can help me out? I'm scared...
Click to expand...
Click to collapse
A bit more details. What phone model? What were you trying to flash? Where does it hang, on the Samsung boot animation, or in the recovery?
Sent from my GT-I9100 using Tapatalk 2
Galaxy s2 international (gt 19100). It hangs on the boot logo, which now is a yin yang with ics on it, I guess this is a NEAT thing. I can go into recovery mode, it just hangs if I try to boot normally.
badaboom423 said:
Galaxy s2 international (gt 19100). It hangs on the boot logo, which now is a yin yang with ics on it, I guess this is a NEAT thing. I can go into recovery mode, it just hangs if I try to boot normally.
Click to expand...
Click to collapse
The yin yang boot logo is actually the kernel. (Siyah)
You should probably try a factory reset/wipe data from recovery. This will alleviate 90% of boot loops and stuck on boot issues.
How do I do that?
badaboom423 said:
How do I do that?
Click to expand...
Click to collapse
You just said above you can boot to recovery... Once you are in recovery mode, can you not follow the recovery menu system to find the wipe data/factory reset option? It should be pretty straightforward.
I'm not running Siyah, so I don't know what the exact menu item is called in the recovery image that is in that kernel.
I tried that but it still does the same thing... any other tips?
badaboom423 said:
I tried that but it still does the same thing... any other tips?
Click to expand...
Click to collapse
Actually, let's take a couple steps back.
What model phone do you have? It's printed on the label under your battery.
it says model GT-i9100
ssn i9100GSMH
badaboom423 said:
it says model GT-i9100
ssn i9100GSMH
Click to expand...
Click to collapse
Ok. Are you SURE you're doing a wipe data/factory reset when in recovery? If so, then I'd flash a stock firmware, full wipe again, then try the Neat ROM install again.
ctomgee said:
Ok. Are you SURE you're doing a wipe data/factory reset when in recovery? If so, then I'd flash a stock firmware, full wipe again, then try the Neat ROM install again.
Click to expand...
Click to collapse
Well I'm going into recovery mode and clicking on the option that says wipe data/ factory reset... How would I install the stock firmware if I can't get past the boot screen?
What recovery u using ? CWM ?
Sent from my GT-I9100 using xda app-developers app
CWMR Touch v5.5.0.4
badaboom423 said:
Well I'm going into recovery mode and clicking on the option that says wipe data/ factory reset... How would I install the stock firmware if I can't get past the boot screen?
Click to expand...
Click to collapse
Find all you need to know here.
As an easy rule before installing any new ROM (that isn't an upgrade from a previous version ex. Cm10 builds or if otherwise stated ) wipe data , cache and dalvik cache , which is under advanced
badaboom423 said:
Well I'm going into recovery mode and clicking on the option that says wipe data/ factory reset... How would I install the stock firmware if I can't get past the boot screen?
Click to expand...
Click to collapse
Try
Go to recovery
wipe data
wipe cache
advanced/wipe dalvik cache
go back
mounts and storage
format system
format data
format cache
go back
install rom
I have a lg l3. flash it via clockworkmod. everything was ok, and the system began to lift and fit just there, it means I only have that light-robot, I waited 12 hours and nothing's changed. Pleas help!!
sorry for my bad english
tomexxy said:
I have a lg l3. flash it via clockworkmod. everything was ok, and the system began to lift and fit just there, it means I only have that light-robot, I waited 12 hours and nothing's changed. Pleas help!!
sorry for my bad english
Click to expand...
Click to collapse
go to recovery and wipe data/factory reset and wipe dalvik cache from advanced.Then reflash the zip file...
mr.harsh said:
go to recovery and wipe data/factory reset and wipe dalvik cache from advanced.Then reflash the zip file...
Click to expand...
Click to collapse
i can't go to recovery, I can't access anything just to start and stop the??
tomexxy said:
i can't go to recovery, I can't access anything just to start and stop the??
Click to expand...
Click to collapse
try again.It should go to recovery.
if still can't then plug it to usb.wait for at least 2 minutes then open command prompt where you've installed adb and type adb reboot recovery.
I was trying to install new rom and that I have wiped data, cache and rom.
I guess I should not have had wiped rom
and now I am stuck in twrp bootloop cannot select to boot to fastboot or anything else
I have try the method 1a in this thread but seemed to changed nothing.
http://forum.xda-developers.com/showthread.php?t=1514088
I cannot mount sd card, cache or data but system only.
I think I am missing the rom but I cant find anyway to install it
Can anyone help me?
Thank you very much
Update:
I just tried using adb command to boot into bootloader and i succeeded and booted in android
Turns out it is a recovery loop and the above is the only way to boot into bootloader
950505 said:
I was trying to install new rom and that I have wiped data, cache and rom.
I guess I should not have had wiped rom
and now I am stuck in twrp bootloop cannot select to boot to fastboot or anything else
I have try the method 1a in this thread but seemed to changed nothing.
http://forum.xda-developers.com/showthread.php?t=1514088
I cannot mount sd card, cache or data but system only.
I think I am missing the rom but I cant find anyway to install it
Can anyone help me?
Thank you very much
Click to expand...
Click to collapse
same problem her ! :crying:
Cant mount ext sd card --> cant install a new rom
if i browse to the Ext sd card it says Empty but in my S4 it shows me more than 20 Folders and t
he Rom Zip :crying::crying:
I don't understand what is it that I might be doing wrong, I root the tablet, have bootloader unlocked, and install Dualrecovery. From TWRP recovery I wipe Dalvik cache, Cache, System, and Data. Install PAC Rom Castor and GApps using TWRP, all seems to go well, no errors present themselves. Then I reflash "TabZ2-lockeddualrecovery2.8.21-RELEASE.flashable" to keep the recovery intact before I attempt to boot into system per their instructions after installing a custom ROM. I wiped Dalvik and Cache before I reboot and once it goes away from recovery nothing occurs just my tablet remaining in flash boot which is a good thing so I can start all over again since obviously something went wrong and just use flashtools to get back to an old stock firmware. I have a SGP512. Any help is appreciated, thanks.
Edit: Even tried it w/o wiping system and same results just doesn't boot.
D03035790 said:
I don't understand what is it that I might be doing wrong, I root the tablet, have bootloader unlocked, and install Dualrecovery. From TWRP recovery I wipe Dalvik cache, Cache, System, and Data. Install PAC Rom Castor and GApps using TWRP, all seems to go well, no errors present themselves. Then I reflash "TabZ2-lockeddualrecovery2.8.21-RELEASE.flashable" to keep the recovery intact before I attempt to boot into system per their instructions after installing a custom ROM. I wiped Dalvik and Cache before I reboot and once it goes away from recovery nothing occurs just my tablet remaining in flash boot which is a good thing so I can start all over again since obviously something went wrong and just use flashtools to get back to an old stock firmware. I have a SGP512. Any help is appreciated, thanks.
Edit: Even tried it w/o wiping system and same results just doesn't boot.
Click to expand...
Click to collapse
Your device will never Boot if you flash pac with nuts recovery. It causes to much Problems with cm based roms. So to rescue your tab you need Boot into fastboot and write "fastboot erase recovery" then flash this kernel http://doomlord.xperia-files.com/do...2U3RrS2VybmVsX1dJRkktdjAzXzE3LjEuMS5BLjAuNDAy
Do not reboot to system. Power of the device and then Boot into recovery (when you see the Sony logo and the LED light turns pink/amber/orange keep tapping/pressing VOLUME UP key). Then you will See cwm recovery. There first do a factory reset and Format system. Format system is in mounts and storage options) now flash PAC Rom and gapps and reboot to system now the device should Boot correctly. After the first boot do all settings then go to developer options and you will find expand reboot menu or something Luke this. Tick it and than hold the power button for some second tap reboot than bootloader (before connect the device with your PC) than use fastboot to flash the New recovery. Use one of these http://forum.xda-developers.com/xpe...wrp-cwm-philz-recovery-collection-z2-t3052676
For instructions to flash recovery look in the thread there are a step "Installation" if you need more help write me
rcstar6696 said:
Your device will never Boot if you flash pac with nuts recovery. It causes to much Problems with cm based roms. So to rescue your tab you need Boot into fastboot and write "fastboot erase recovery" then flash this kernel http://doomlord.xperia-files.com/do...2U3RrS2VybmVsX1dJRkktdjAzXzE3LjEuMS5BLjAuNDAy
Do not reboot to system. Power of the device and then Boot into recovery (when you see the Sony logo and the LED light turns pink/amber/orange keep tapping/pressing VOLUME UP key). Then you will See cwm recovery. There first do a factory reset and Format system. Format system is in mounts and storage options) now flash PAC Rom and gapps and reboot to system now the device should Boot correctly. After the first boot do all settings then go to developer options and you will find expand reboot menu or something Luke this. Tick it and than hold the power button for some second tap reboot than bootloader (before connect the device with your PC) than use fastboot to flash the New recovery. Use one of these http://forum.xda-developers.com/xpe...wrp-cwm-philz-recovery-collection-z2-t3052676
For instructions to flash recovery look in the thread there are a step "Installation" if you need more help write me
Click to expand...
Click to collapse
Thanks! I used Flashtools to flash over the recovery via fastboot and accessed the recovery to do the rest. I had no idea CM based ROMS don't work well that recovery or any other I haven't tried yet. Any suggestion on what recovery to use? So far CWM got me this far not sure if I should try others. Philz Touch seems to be more appealing and the same as CWM.
D03035790 said:
Thanks! I used Flashtools to flash over the recovery via fastboot and accessed the recovery to do the rest. I had no idea CM based ROMS don't work well that recovery or any other I haven't tried yet. Any suggestion on what recovery to use? So far CWM got me this far not sure if I should try others. Philz Touch seems to be more appealing and the same as CWM.
Click to expand...
Click to collapse
Use this one https://mega.nz/#!rI4y2bJS!VksDLNy_a8cy8x-VBviYRkTP2SdSBm7Rs9G445vUXCU
This is twrp but it works with cmbased roms.
Maby this post help you when you get bootlop to recovery each time after installing twrp and custom rom.
Problem is exsdcard uses on old phone:
1. Disable phone
2. Remove sdcard
3. Run phone.
4. After system is run put sdcard again and delete twrp folder in file manager.
5. Reboot phone.
End.
Didn't work for me.
eric5949 said:
Didn't work for me.
Click to expand...
Click to collapse
1.Reinstall twrp, don't boot the rom, boot first in recovery
2.format data, wipe cache, art.
3.reboot to recovery again and flash any custom roms
MrDraska said:
1.Reinstall twrp, don't boot the rom, boot first in recovery
2.format data, wipe cache, art.
3.reboot to recovery again and flash any custom roms
Click to expand...
Click to collapse
Bootloop Never gets past LG screen now, and all computer software thinks my phone is a Pixel.
Fixed it, phone starts up just fine. Back to stock.