Similar to http://forum.xda-developers.com/note-2-verizon/help/to-4-1-1-rooted-to-4-4-2-rooted-t3452315 I got my phone on the first release version (VRALJB) and unlocked & went with IMNUTS's Tweaked release up through 0906 (VRAM3C OTA based).
However, I noticed that the baseband still shows VRALJB. I'm assuming that this is the radio.
I know that to go to 4.4.2 "stock" I would need to flash the MJ9 radio but would I need to flash each of the preceeding ones as well?
Also, the thread mentioned above indicates to go to VRALL4 stock and then to a new ROM from there. Would I do that or go to a VRAMC3 stock or does it matter?
I forgot to mention that I'm also running PBJ kernel 0726.
Related
as it says i have 1.16.00.402w_1 currently and was trying to figure out what the newest stable one was to flash i tried looking around but even though there were higher ver #s im not sure if they were for GB
They aren't "Froyo" and "Gingerbread" radios. There are roms built for MR1 and MR2. And which one you can update to depends on which ROM you want to use. You're on the latest MR1 right now so unless you want to flash a different ROM (assuming you currently have service), you have the newest you can use.
Just brought an Att SGH 777 sgs2 and after hours upon hours of research, rooted my phone and installed unnamed ROM. My question is under ABout phone, you will see the KERNEL which is fine, that changes, but under android version it says 2.3.4.
From my understanding there is 2.3.6 so how do I change this? Does 2.3.6 come within the kernel I installed or ROM? Or do I have to dl the official 2.3.6 first then ROOT again and install the rom afterwards.
Your firmware is still 2.3.4 until you flash the latest leak (KK6). I wouldn't worry about flashing the leaks until ATT releases them officially due to random problems that every leak has in them.
ROM and firmware go hand in hand. It you flash the leaked 2.3.6 and then flash unnamed 1.3.2 or lower you are effectively flashing 2.3.4 back on. Until the rom dev builds a new rom from the newer firmware you are on the same firmware you were before.
Sent from my GT-P7510
thanks fellas
Been away from the Fascinate for a while
I am running stock, just rooted, 2.6.32.9 / EB01
I see all kinds of numbers in the development forums eb01,ec10, eh,.......
So someone please educate me on where i'm supposed to be as far as newest system
Thanks!
The latest stock release for our device is 2.3.5 eh03 gingerbread. The number you listed in your op is the kernel version. Eb01 is 2.2.1 froyo...
Jt1134 has ICS 4.0 released for our devices, but its not stock. Not sure what your looking for exactly, but i have a guide in the general section that has everything there you need to upgrade. Fyi if you want stock eh03, stay away from the ota update. Follow section 4 of my guide...hope this helps.
i'm running ics rom right now.
because i'm running ics, as far as i know, the main version has been updated.
so, in order to go back to stock,
i need to change the main version and then use the ruu.exe (1.02.605.6),
but i recently downloaded the latest ruu.exe (2.01.605.11).
so the question would be, if i were to use the latest ruu.exe (2.01.605.11),
do i still need to change the main version or not?
Yes you will have to change it. The latest Thu is crime an ota and you will get main ver error since you are on a ics leak. There is a thread on how to do this but you will have to do it every time from now on. At least from what I have read. Somebody correct me if I am wrong
Hello!
Phone Gt-i9300
So i was happily using omnirom for 1 year until my motherboard died last week
so i ordered a new board. i installed it, it was on 4.1.2 unlocked, and i decided to update it without making a efs backup! so dumb!
So i installed a 4.3 Stock ROM, no signal so i had to install
-Patched XXUFMJ9 kernel
- Patched BUUGMJ3 modem
So i can use my phone with no problems in STOCK....
BUT. I hate STOCK..
I have tried to flash omniroom 4.4.4, but it says unknown baseband, uknown imei.. i tried installing omniroom and then installed again the patched modem buugmj3 and ofcourse nothing happened...
So.. my question is.. Am I forced to stick with this TouchWiz Rom? or is there any way for me to do something to get omniroom detecting my signal?
Oh something i was forgeting.. before i updated to stock 4.3... i installed first omniroom.. but i decided to update to stock 4.3 because i was getting signal but it could take 1 HOUR for the phone to get the signal.. and from there signal would lose at any moment.
anyone? i read the FAQ and did this
Q9: I'm sure I've correctly flashed an SGSIII ROM with the right CSC for my network but why can I still not make calls?
If your phone was running an Android version less than v4.3 before you flashed a new ROM then you may need to install a patched modem and, if you upgraded to a newer stock ROM, a patched kernel too such as the zuluman modem FW/kernel. You will usually not need to install a patched kernel if you install CyanogenMod or a CM-based ROM. A number of kernels and modem firmwares patched for Android 4.3+ are available here.
Click to expand...
Click to collapse
and still nothing