Hello
i put my cloesed my phone and put it on charge and tried to open it next day and it didnt open. Logo of samsung is flashing.. My phone is GT-I9300 sim unlocked and dont know what carrier it is.. I tried kies software it showed " update is not required" . but i have noticed that by putting phones s/n number kies software showed my phone is TMU which is United Kingdom T-mobile . after i tried odin and found firmeware for TMU from sammobile. it failed and showed "There is no partition".What should i do now ?
Try the rescue firmware from general forum, flash with Odin. But sounds like the emmc chip is damaged, new motherboard required.
Hi there. Got a Samsung galaxy gti 1900
It for no reason decided it won't come on.
Done a hard reset but it says
#manual mode#
--applying multi-csc
Applied the code : cpw
Successfully applied multi CSC
Tried lots of things, there's so much technical stuff!
Downloaded Odin and kingo root but then get stuck!
Any help would be greatly appreciated
Hello, i have problem with Samsung Galaxy S6 Edge / G925 (Poland, Play) and i can't write modem and bootloader because i see error Re-Partition Operation Failed.
On this moment mobile power on, but baseband and imei is unknown.
In bootloader i see correct version as G925F, on menu is that same but on download mode i see G925W8.
Serial number from backplate isn't that same as in mobile menu.
I can restore mobile via SmartSwitch as version G825W8 but when i try power on i see DRK error.
Whe i try restore mobile via SmartSwith as 925F i see error as pc don't see phone.
I can flash radio from 925W8 version without errors, whet i try flash radio from 925F i see Re-Partition Operation Failed
I can flash via odin AP and CSC as G925F, but when i try flash BL or CS i see Re-Partition Operation Failed.
Phone is rooted via CF Auto Root, when i start Partition Backup i see two yellow position (EFS and Radio).
Thank's for all ideas.
Hi
I'm having hard time flashing the ROM of my Galaxy S9+.
I have a ROM 965fxxsefua1 and i would like to flash my phone with another rom (G965FXXSCFTK2 ) but i encounter the following error :
SW REV. CHECK FAILED(BOOTLOADER) DEVICE: 14, BINARY: 12
It seems that it's the bootloader and I need to change the CSC.
So I tried using #272*[IMEI]# to change it and I get the error "connection problem or invalid mmi code".
I googled this error and I saw it may be the multi sim but I have only one sim in my phone.
Does someone know what is the solution to change the CSC when one gets this error ?
Thank you in advance,
Hello everyone,
I need help with resurrecting the above phone model. After updating it via Samsung Switch, it 'magically' stopped receiving network recognition but it could sense the SIM card's network operator. I tried dialing some numbers and it said "Not registered on the network". I ran to the internet through various forums. I have been re-flashing STOCK ROM and i was getting PASS; still no good came out. I tried custom ROMs, same thing. NOW suddenly i got an efs/ failed to mount. How can i resurrect my baby? All i have about the phone is:
AP: G925FXXU6EVG4 (Build number) - NDR90M
CP: G925FXXU6ERF5 (Baseband version)
CSC: G925FXXU6EVG4 (Country version) - 02U
IMEI SV - 02
SN - RF8G610C1MN
The stock ROMs i have downloaded so far are:
1. Samfw.com_SM-G925F_O2U_G925FXXU6EVG4_fac.zip (stock ROM based on the last successful booting ROM; after updating via Samsung Switch)
2. Samfw.com_SM-G925F_O2U_G925FXXU6ERG1.zip
I have these in place:
- Samsung S6 Series EFS Backup Restore Tool v1.0 By Jamesjerss.exe (which i used prior; to get an efs.img before my phone got messed up (a 20Mb file was created). Is that the backed up EFS?
- Odin Odin3_v3.14.4
- CF-Auto-Root-zerolte-zeroltexx-smg925f.zip
- twrp-3.3.1-0-zerolte.img.tar and twrp-3.3.1-0-zerolte.img (i wonder the difference although the internet says i use .tar with Odin)
- SR5-SuperSU-v2.82-SR5-20171001224502.zip
Now, the stock ROM stops on the RECOVERY MODE with efs/ failed to mount, and when i try the custom ROM, it stops on SAMSUNG Galaxy S6 Edge. In all recovery modes, good enough my PC detects my phone's internal storage. I need to get this device to work, people.
Someone help with with a step by step tutorial, please. I am a fast learner
PS Am not a tech student or anything, am just a person who reads stuff on the internet although i understand some basic stuff on tech
splk said:
Hello everyone,
I need help with resurrecting the above phone model. After updating it via Samsung Switch, it 'magically' stopped receiving network recognition but it could sense the SIM card's network operator. I tried dialing some numbers and it said "Not registered on the network". I ran to the internet through various forums. I have been re-flashing STOCK ROM and i was getting PASS; still no good came out. (...)
Click to expand...
Click to collapse
1. If you think about Smart Switch Mobile, it is not for update.
2. Go back to Stock firmware via odin.
2. Have you seen >this< tutorial?
how can i know the stock firmware of the phone....i only remember the one that was updated via Smart Switch (Hanset: Samsung Galaxy S6 Edge G925F single SIM card slot no SD card slot)
1. Check your CSC on the phone box or with the Phone INFO app ★SAM★ 3.8.5.
2. Select your CSC region in the "Version" box read the instructions and download the firmware.
3. Use Odin 3.13.1 to update this model.
@ze7zez. Just bought it from some phone shop that sells used phones. I have the needed STOCK firmware already. The CSC is 02U G925F---VG4. All am getting is this image below:
Since your system is not working, go to "View recovery logs" and look for CSC or "region name".
You can also try uploading firmware from your country's region.
The CSC is 02U (O2) which according to internet research it is UK
Download SM-G925F / Galaxy S6 Edge SM-G925F O2U in Samfw - Samsung firmware download
SM-G925F / Galaxy S6 Edge SM-G925F O2U samsung firmware download all model, lastest, fast update, completely free and fast speed in Samfw.com ✅
samfw.com
ze7zez said:
Download SM-G925F / Galaxy S6 Edge SM-G925F O2U in Samfw - Samsung firmware download
SM-G925F / Galaxy S6 Edge SM-G925F O2U samsung firmware download all model, lastest, fast update, completely free and fast speed in Samfw.com ✅
samfw.com
Click to expand...
Click to collapse
@ze7zez thats where i got the firmwares from
SM-G925F O2U G925FXXU6EVG4
click
Download on Browser
or
Dowload SamFw server
ze7zez said:
SM-G925F O2U G925FXXU6EVG4
click
Download on Browser
or
Dowload SamFw server
Click to expand...
Click to collapse
I already have all firmwares for this handset from 02U. I have tried EVERY STOCK ROM...but all am getting is E: Failed to mount '/efs' (Invalid argument).
I tried EFS-Fix-regalstreak.tar.md5 basing on https://ajketech.wordpress.com/2016/07/27/efs-missing-factory-mode-activated-here-is-the-solution/ i got FAIL.
I do have an efs.img i made before all of this whole saga but i don't know if it is broken or okay.
Try flashing TWRP from >this< manual. Read it carefully!
With TWRP you will have more options for repair.
ze7zez said:
1. If you think about Smart Switch Mobile, it is not for update.
2. Go back to Stock firmware via odin.
2. Have you seen >this< tutorial?
Click to expand...
Click to collapse
i have tried and failed....up to 3. COuldn't proceed to 4. Thanks though
https://forum.xda-developers.com/t/guide-how-to-fix-efs-damaged-on-samsung-devices-easy.3850032/ try this