Does anyone know where I can get a proper fitting screen protector for the Zenfone 4 ZE554KL? None of the ones I've purchased fit the entire screen. They don't cover the edges because of the curve. Leaves about a 1/4 inch of white around the edge of the whole phone. Thanks.
Sent from my ASUS_Z01KD using Tapatalk
https://www.ebay.com/itm/2X-Dmax-Ar...lass-Full-Cover-Screen-Protector/173033129624
Eventually I went with this instead: https://www.ebay.com/itm/2X-Dooqi-P...ector-for-Asus-Zenfone-4-ZE554KL/332390163634
My phone's case kept interfering with the edges of the screen protector I mentioned above, exposing unwanted air pockets which required me to apply more pressure than normal during screen presses.
Related
I bought a tempered screen protector and installed it last night. I noticed that the upper right corner is not sticking. I figured it would set by morning but it still doesnt stick. When I push down, it sticks and darkens but as soon as I remove my finger it is lifted again.
Is this a common issue with tempered screen protectors? I've always used the regular plastic SGP ones, and never had this issue.
Is there a way to make it more adhesive so it sticks or should I just ask for an exchange or refund?
It could happen with a case, but if you're not using a case, then that shouldn't happen. Contact the seller.
Be sure you have the glass perfectly in correct place, I had the same problem and I repositioned the glass and is fine now
Sent from my SM-N9005 using Tapatalk
Dirt and Cheap glass protector tends to do that
Sent from my SM-N900T using Tapatalk 4
Please name of adhesive used in glass for sticking
If the glass is not sticking in the corners, it could be that the protector was slightly bent during the shipping/packaging process, the screen is not perfectly flat, there was dirt/residue on the phone's screen, and/or the adhesive was not evenly applied to the protector at the factory.
The adhesive, as explained to me, is a very lightly silicone-type adhesive.
So, after a week of use; I am starting to get little scratches on the glass of the watch. Anybody have any ideas on how I could get a decent screen protector for the watch? I know there aren't any perfectly sized ones for this device but maybe somebody here already found one that fits.
You may be getting real scratches on the screen, but be aware that the sapphire-coating on the TS also can appear scratched when it really is just marked. To clean those markings off takes some fairly serious buffing, but you might find the screen was not really scratched and comes out clean again.
There are no screen protectors currently available specifically cut to fit the TS. You could cut one yourself, maybe using that peel-off sticker it shipped with.
Sent from my Nexus 7 using Tapatalk
I cut my own screen protector out of an old one (unused) that I had laying around. Turned out horrible.
It was the more rigid type and where the edge of the TrueSmart screen has a bevel the screen protector was just hanging out over it. It ended up collecting dirt and made it hard to access the back and menu swipe actions. I also considered cutting it back to only the actual screen portion but I figured that was just going to make those swipe actions even more miserable so I just tossed it.
My guess is that the only thing that would work would be one of the more flexible stretchable type screen protectors, not sure how well they would conform to the bevel on the glass though.
Has anyone tried both the official OnePlus 5 3D curved screen protector and compare it to the auckly full screen full adhesive screen protector? Does anyone notice any difference between the two?
I tried both and the difference I noticed is that the aukley does not have enough Force to stick to the screen.
This leads to air between the protector and the screen.
The OnePlus does this much better
I am so happy with the official OnePlus 5 screen protector.
I have auckly. It sticks to the screen just fine. I was wondering if the OnePlus screen protector hands over the edge a little
Hello!
I recently bought a OnePlus 5 and decided to give Auckly a chance...
Installing the protector is pretty easy, it fits well but won't stick completely at the edges.
Plus: I'm using a very thin flexible case. It's pushing on the edges and lift the screen protector because he's just too thick.
I'll try another one now...
Sent from my OnePlus 5 using XDA Labs
I have found screen protectors that work for the most part. The skinomi for the LG V40 works pretty well for the outside screen. It is bigger than the inside screen, so the ones for the inner screens dont cover it as well. The inner ones I found work well but it wont shut completely so I just have one on the phone screen now. I will link the ones I used below.
Inner Screens:
https://www.amazon.com/gp/aw/d/B07TJ7M4NF/ref=ox_sc_act_image_1?smid=AVRBPWFOF87S1&psc=1
Outer Screen:
https://www.amazon.com/Protector-Co...v40&qid=1572790274&sprefix=skinomi+lg+&sr=8-3
Sent from my LM-G850 using Tapatalk
Did you find any that work with both inner screens? So careful with this new phone worried about scratching it but cannot find anything for both inner screens
I used an Iphone Xs Max screen protector and it fits great, it just has a slight gap where the notch is since the iphone has a larger notch, but otherwise fits perfect.
I put a glass one on the phone itself, a glass one on the outside of the dual screen case, and a plastic one on the inside screen of the dual case.
You can't use a glass screen screen protector on both the phone and inside screen of the case as they are too thick and won't let the case close properly.
Hi.
I was using foil based screen protector for long time but it wear out so I'm out for something new. I thought about getting glass or hydrogel one but I've noticed they don't cover whole screen but only flat part. So the edges aren't protected and as a "bonus" this does create sharp edge that is especially noticeable when swiping from edge (like some gestures or something).
So is there good glass or hydrogel protector that covers whole screen, also with rounded part? Can you recommend any? Or should I get back to foil one if it bothers me so much?
My recommendation would be to get a case for the phone, as well. I'm still using the one that came in the box, and it works great with the screen protectors I've used. Though, I haven't tried a tempered glass one. I've been using film ones.
Haha...nevermind. I suppose you probably already got one in the intervening 6 months.