When I woke up, my battery was at 0% and the phone was off. I charged it a bit and tried to turn it on and my phone was stuck at mi logo and wasn't doing anything (it wasn't bootloop just a freeze) I tried resetting it few times but it didn't help. I managed to boot to recovery and tried to reboot via every option (system,recovery etc) but the phone freezed just as i clicked reboot. I tried to flash lineage os .zip that I had on my phone but the flashing also freezed and I had to reboot manually. Now I can't turn on my phone at all, I charged it whole night with different cables, it is constantly blinking red light when charging.
Now I'm trying to use miflash 2018.11.15.0 which after installing qualcomm driver recognizes my device (Qualcomm HS-USB QDLoader 9008 (COM4) in device manager).
I downloaded mido_global_images_V11.0.2.0.NCFMIXM_20191107.0000.00_7.0_global_91ed4d2a3f .tgz and I clicked flash
File prog_emmc_firehose_8953_ddr.mbn flashes successfully then the status gets changed to ping target via firehose for 15 seconds and I'm getting write time out,maybe device was disconnected. I have tried different methods, unplugged screen connector, battery, testpoint and held the power for like 30 seconds but I cannot fully flash at all. Any ideas?
Related
Hi, I have the phone Zopo C2. I turned off the phone and stopped responding. When connected to the charger, nothing happens. When connected to a computer is detect normally, I can flash ROM by SP flashtool. And here is the problem, as long as I want toflash, reaches the first red bar to 100% and ends flash without error. Drivers have a good, first is connected as "USB PORT MTK" and how it comes to 100% red bar that goes in the "VCOM MTK DOWNLOAD".I have a second phone zopo c2 and there I normally flash, and everything goes without problems
I tried with the removed battery inserted, all methods and nothing, always the same 100% red stripe and the end of the flash without any error.
I wanted to flash such proloader same and is the same.
Phone is brick ? Memory in phone is dead or what ?? Can still fix it?
Sorry I from Poland and my english is very bad.
Hi, I have a problem. 2 months ago I unofficially unlocked bootloader flashed twrp and everything necessary, then i tried many custom roms and there was no problems at all until yesterday when i tried to flash new rom.
I did everything correctly (like always - clean flash - rom- gapps) after that I got bootanimation loop ( sometimes happen - nothing very serious) so i wanted to reset once again to recovery twrp volume up + power to try once again and suddenly out of nowhere there was no twrp recovery. I had Mi logo ofc and after that for 0.5 sec there was a picture of droid laying with open chest and red triangle above and phone switched off. this screen lasts only for 0.5 - 1 sec and then disappear. When i try to boot system ( only power button) i get the same result mi logo -> "dead droid" screen for 1 sec and switch off.
From the other hand i can boot to fastboot but since i don't have any system on my phone (because it did not set up) and i can't go further than that screen i can't enable usb debugging to do everything by fastboot.
I tried also some edl.zip which helps with going into edl mode and I also can go to edl mode but miflash (newest) does not see my phone and I don't know why cause when plugged to computer phone is seen by it and in edl mode device is seen as Qualcomm HS-USB QDLoader 9008 port as it should be, but miflash does not see my device. I don't know if it's bricked as hell or what should i do.. ?
Thanks for answers in advance.
Samel_piesel said:
Hi, I have a problem. 2 months ago I unofficially unlocked bootloader flashed twrp and everything necessary, then i tried many custom roms and there was no problems at all until yesterday when i tried to flash new rom.
I did everything correctly (like always - clean flash - rom- gapps) after that I got bootanimation loop ( sometimes happen - nothing very serious) so i wanted to reset once again to recovery twrp volume up + power to try once again and suddenly out of nowhere there was no twrp recovery. I had Mi logo ofc and after that for 0.5 sec there was a picture of droid laying with open chest and red triangle above and phone switched off. this screen lasts only for 0.5 - 1 sec and then disappear. When i try to boot system ( only power button) i get the same result mi logo -> "dead droid" screen for 1 sec and switch off.
From the other hand i can boot to fastboot but since i don't have any system on my phone (because it did not set up) and i can't go further than that screen i can't enable usb debugging to do everything by fastboot.
I tried also some edl.zip which helps with going into edl mode and I also can go to edl mode but miflash (newest) does not see my phone and I don't know why cause when plugged to computer phone is seen by it and in edl mode device is seen as Qualcomm HS-USB QDLoader 9008 port as it should be, but miflash does not see my device. I don't know if it's bricked as hell or what should i do.. ?
Thanks for answers in advance.
Click to expand...
Click to collapse
Use the MiFlash Beta. It should work as you said your phone is recognized as QDLoader 9008. That's always a good sign. Do report back and tell us if that solved your problem.
Thanks I managed to fix it Problem solved!
Hi,
My phone turned off.
I don't think my battery was empty, but can't be sure.
When I plugged it to recharge, the led was blinking fast, and the big battery icon didn't show up.
I never could turn back my phone on.
I've read here and there that it could be a battery issue.
I've opened the phone, unplugged the battery and connected the phone to my pc. It turns on, but bootloops every 3-4 seconds (Mi logo shows up, then it vibrates and reboots).
I tried plugging the battery back with the Mi logo on, but then the led starts blinking and the phones stops looping (turned off).
I managed to boot into fastboot by holding the - button and plugging the usb. Running adb devices doesn't show anything. Yet there is no error when trying to flash twrp through adb.
I managed to boot into twrp (so it was actually flashed, because I had orangefox recovery before the crash.
Yet in twrp, the note 5 plus folder is empty. I tried to mount usb, nothing too.
I tried to backup via adb twrp, and I got a bunch of errors ("unable to mount data", "unable to mount storage", ... then a bunch of "e:recv error on uevent").
Any idea what I can do ?
Is it the battery ? Don't really want to buy a new battery if i't not sure it's the problem.
I had to buy a new phone in the meantime, so I mainly want here to recover data (pictures mostly) from my phone.
Thanks !
Hi,
My friends oppo neo 5 went into bootloop and we decided to flash stock rom to solve it. We had done the same previously and it worked without any problems. This time after initially flashing it stayed on the boot screen itself and we decided to flash again but this time instead of download on the sptool, we used firmware upgrade and after flashing, the phone wont boot up. when we try to power it on it vibrates for 2-3 seconds and then continues to vibrate after an interval. The phone is detected in device manager when its plugged in to the pc as mediatek usb port and mediatek da usb vcom. The phone is detected in sptool and we are able to flash and it gives the green tick, but there is no use as the phone wont boot up.
Hello everyone, got this bricked phone with asus logo stuck, tried to unbrick with qfil and stock firmware, and i was getting errors, one of them is finished sector adress ****, and i cant get out from edl mode with holding buttons, none of them reboot it, only power button can restart edl mode if i hold it for 30+ secs, led indicator, screen, nothing work, with removed battery still recognizes as Hs usb ....... 9008, what can i do to exit edl mode?, and how can i flash an rom? P.S phone was in water about year ago.
(Sorry for my english):crying:
P.S.S before stuck, when i was getting to fastboot, flash tool was telling me that my phone is -1% battery