I'm havin problems with offline charging after i installed cm11. I've tried change kernel and change rom (i'm using PA rom now) and i'm still with the same problem.
When i plug the charger on my phone while turned off, it shows a battery icon with a question mark on it and i think it's not charging. Is this a general problem or did i make something wrong?
Try keeping it plugged in. See if it charges or not.
Also,did you change your bootlogo?
I didn't change my bootlogo. it boots motorola bootloader and then shows the battery icon with the question mark. I left my phone charging this way for a couple of hours and tried to turn it on. my phone booted with 0% battery and then shutted down, so definitely it is not charging. other thing I notice is that when my phone enter this buggy offline charging mode, I have to press power button + volume down to reboot my phone, it kind of get stuck in this mode when my phone enter it
Try using a different charger.
It doesn't seem to be a common issue.
Can you power up the phone whilst charger connected.?
I've tried two different chargers, one of my Moto X and the original one. If I want to charge the phone I need to turn it on first and then plug the charger. I can't turn it on with the charger on cuz it is stuck on that screen with the battery icon
I'm starting to think I've done something wrong. I did the following to get where I am right now:
I was on stock firmware, so I rooted the phone and installed the newest version of SS. Then I downloaded cm11 and gapps and copied to the phone. I entered the SS and wiped everything. After that I installed cm11 and gapps.
When I discovered that issue I've tried install JBX kernel to fix it and nothing. then I wiped everything again and installed PA rom + gapps and still that issue. Did I do something wrong?
No, you didn't do anything wrong.
Since its persistent across both ROMS, its not a ROM issue either.
In my opinion, its most probably a problem with port or the board. The port doesn't deliver enough power.
You can try flashing the stock ROM back, it might repair in case something s/w related is corrupted. If it doesn't work after that, then its a h/w glitch for sure.
just in case, if I install stock rom and the problem goes away, what might be causing this problem?
I can't re-flash stock rom because I can't charge my phone and I can't boot into the rom or recovery. I don't think fastboot charges my phone. I just realized that bootloader is locked. Maybe this is the problem, isn't it?
it isn't a h/w glitch because before cm11 it was OK to charge offline
You'll need a factory cable to flash in case your phone has insufficient power.
Look for it, there's a guide about making one in the general section I suppose.
No need, I've managed to charge the phone through USB on my pc. When I plug the charger on my phone, that glitch happens, but when I plug the USB on my pc, the phone lights up a white led and apparently it charges the phone (slower, but charges). That's really weird. I really want to know what is happening to my phone
Related
Everytime I plug in Nook Charging cable it keeps booting over and over. If I plug in my samsung galaxy cable it charges but the moment I plug in it just turns off completely and wont turn on until I unplug. I originally had a dual boot system running for 1.4.0 which is my nook version and tried to do a recovery which said successful from the file I created but when I rebooted the whole system didnt know what to use for what and kept asking then crashing. I factory wipe/reset after the problem started and upgraded to CM10 cynogen mod with the new JellyBean no duel boot. RUNS AMAZING. But the charging problems still remains, even when I booted stock after factory reset it was still doing this. I have CWM installed internally. Please help me I have looked over many threads one said it was an update problem created with AdobeFlash updates and I tryed to flash the fix listed but it just says error during install and aborts. Also it will stay on during the cynogen mod boot screen even if i plug in either charger but at the top it just says "Charging Disabled" says the precent. I left it plugged in at this screen and it didnt charge one percent after 30 minutes.
I just want to charge it and have it on at the same time. Please any help, any ideas and comments is appreciated. Thank You
i have this problem too. I'm using CM10. My battery died and wouldn't charge no matter how long I had it plugged in for.
Then recently it turned on, but when it is plugged into the wall, it just constantly reboots.
Any help?
Hi,
I'm having this problem for a while and don't remember exactly how it occurred, if I remember well, it started happening after flashing a non-stock ROM with CWM, but can't really reproduce it.
Current CWM is Cyanogen CWM-based recovery v5.0.3.2. The problem persisted even when upgrading the ROM to 4.2 (PacRom).
Anyway, as for the problem itself, when I plug-in the device to charger while its off, I see a legacy loading star similar to this one for like 5 secs, then comes up the battery icon for a couple of seconds, and device is turned off again for another 3 seconds. The whole routine repeats over and over infinitely.
Note, that the device warms up during the charging process while it's turned off.
How to solve this?
NullUser said:
Hi,
I'm having this problem for a while and don't remember exactly how it occurred, if I remember well, it started happening after flashing a non-stock ROM with CWM, but can't really reproduce it.
Current CWM is Cyanogen CWM-based recovery v5.0.3.2. The problem persisted even when upgrading the ROM to 4.2 (PacRom).
Anyway, as for the problem itself, when I plug-in the device to charger while its off, I see a legacy loading star similar to this one for like 5 secs, then comes up the battery icon for a couple of seconds, and device is turned off again for another 3 seconds. The whole routine repeats over and over infinitely.
Note, that the device warms up during the charging process while it's turned off.
How to solve this?
Click to expand...
Click to collapse
Afaik, this behavior is normal. When the device is off and you plug it in via a wall charger, it's fine; it boot's up and shows the battery charging icon. However, if you plug it in via a USB port on a computer, you enter an endless boot loop.
Afaik, the only solution is to charge the device via a wall charger, or turn the device on normally and charge via any source you want.
Note: I have flashed back to stock just to test this and it behaved the same.
Note: Jelly bean roms seem to have an additional issue where, when you reboot the device while it's plugged in (any source), the device goes into the "charging only" mode. If you are plugged into a USB port then you end up in the above mentioned boot loop. The solution to that is to simply unplug the device before rebooting...
Hi,
about a month ago, I managed to brick my XT910 - I was doing factory reset when I had couple of images installed (using safestrap).
The Battery went dead, as it entered a bootloop which I didn't notice.
I ordered a "Factory Cable", and now I'm able to use AP Fastboot recovery to flash a new image (4.1.2 image). As long as I'm connected with the factory cable to the computer, everything seems OK (flash succeed, I can go and setup the new system, connect to wifi...).
But - the battery never charges. As soon as I take off the factory cable, the phone dies. When I'm connecting regular charger, or regular USB cable to the computer, I get the red circle "M" logo, but it never progress - not booting and not showing the battery image.
Any idea how to solve this?
Thanks,
Ilan
Try keeping it plugged in for a few hours. It should charge.
neo.ank said:
Try keeping it plugged in for a few hours. It should charge.
Click to expand...
Click to collapse
Have tried, it was connected with both the factory cable and regular charger for few hours each times.
The battery picture (when the phone is off, but connected to power) doesn't even show up.
Any idea if the boot might have been defected? If so - any way to fix it?
I do able to go into fastboot & recovery boot options.
Thanks
Have you tried charging it through your usb port. Using the normal cable.
If nothing else works, Flash the stock ROM using RSDLite. It should fix any issue related to bad flash or anything corrupted.
Yes - tried charging with regular cable from the USB port - nothing comes on in the screen, just the led is glowing white.
I've tried to flash few stock images - 4.0.4 versions I can get flashed, and they run, but the battery icon shows a question mark (and in the system settings-> battery it says unknown).
2.3.6 images do not flash at all (I get failed in RDSlight on the first stage).
Any idea? Is there a boot only file I can flash another way.
Thanks
Hello,
I'm using GT-i8552 stock 4.1.2 (UNROOTED).
I did root my phone with 'Framaroot', the rooting was successful and SuperSU was installed properly. After this I didn't try installing any custom ROMs or any conflicting apps but still I started facing battery issues like,
1. After putting on charge, display shows that it is charging but no progress at all (it freezes at certain %)
2. When the phone is switched off and put on charge, the display just blinks up and goes off (lights on lights off) nothing else appears and no battery progress
3. Sometimes the phone charges properly to 100% but after disconnecting cable, battery status is 50-60%
The above problems occur not all the time.
The things that I tried,
1. Did unroot my phone and removed SuperSU
2. Did a factory reset from phone's settings option.
3. Got an original new battery from service center
4. Took the phone to Samsung customer care (they couldn't find any problem at all and advised that the problem must be in the charger) (I tried to charge with samsung charger, sony's charger & portable charger)
5. Changed USB cables for charging
6. Tried Battery Calibration apk by Nema
7. I think the charging port is little bit damaged but I can still get the phone to charge
Even after doing all the above things the problems still occur sometimes. Other than that the phone works fine, there is no BOOTLOOP.
When I try to boot it into recovery mode (volume up+home+switch on and release after SAMSUNG logo) but after releasing the buttons the SAMSUNG GT-i8552 logo appears and phone starts with no warning and all, it's not accessing the recovery mode or download mode too.
Is there any solution to the battery related issues or do I need to flash the stock firmware again?
I am not aware of the steps of flashing firmware, please do redirect.
Thank You!!
My xt1225 was fine , until some time ago.
Problem started there : I couldnt let it drain all the battery down or it would be a pain in the ass to charge it up.
If i let , the problem was that everytime i plug the charger in the phone would go up a second showing the charging screen and then turn off. The solution was to try to boot on bootloader or recovery and pray that it doesnt turn off, then the phone would charge a bit and back to the normal state.
The strange thing come here : one day after letting it go down to 1% (it didnt shut down but stayed at 1%), i plugged the charger in and the battery wouldnt go up past 1%. I let for hours and nothing . Then I managed to go on receovery (twrp 3.0.2) and :
The processor temp was something like 4293089048 C , the battery still 1%.
After some restarts on recovery i noticed that the battery would sometimes change a bit of the value , and i plugged the charger and managed to charge up battery to 100% in recovery only.
Now , after charging the phone a bit i decided to reflash the stock rom (was using aex) but i noticed that I can`t get my system recognized on usb. Neither on Bootloader , recovery , or system .
Anybody can help me =(?
Obs : Still have acess to system (with a custom rom , aex) , and i can flash things on recovery
douglasyc said:
My xt1225 was fine , until some time ago.
Problem started there : I couldnt let it drain all the battery down or it would be a pain in the ass to charge it up.
If i let , the problem was that everytime i plug the charger in the phone would go up a second showing the charging screen and then turn off. The solution was to try to boot on bootloader or recovery and pray that it doesnt turn off, then the phone would charge a bit and back to the normal state.
The strange thing come here : one day after letting it go down to 1% (it didnt shut down but stayed at 1%), i plugged the charger in and the battery wouldnt go up past 1%. I let for hours and nothing . Then I managed to go on receovery (twrp 3.0.2) and :
The processor temp was something like 4293089048 C , the battery still 1%.
After some restarts on recovery i noticed that the battery would sometimes change a bit of the value , and i plugged the charger and managed to charge up battery to 100% in recovery only.
Now , after charging the phone a bit i decided to reflash the stock rom (was using aex) but i noticed that I can`t get my system recognized on usb. Neither on Bootloader , recovery , or system .
Anybody can help me =(?
Obs : Still have acess to system (with a custom rom , aex) , and i can flash things on recovery
Click to expand...
Click to collapse
First of all, it seems like you have posted in the wrong section.
The XT1225 has a dedicated forum available here. So, the correct section for your thread should be here.
Secondly, it sounds like you're having a battery hardware issue. The battery is likely failing. If you can, you should replace it.
It might also be a USB Cable or USB connector issue. So, you should first change the USB Cable. If it doesn't help, change the battery. If that fails too, then you must ultimately change the USB connector (better take it to a repair center).
Before any of these, you can try to calibrate the battery with a calibration app, but I seriously doubt that will work. It's still worth the try!