Gents, happened with me twice while i'm recording a run the activity just stop by itself after 3 vibrations (MP3 music stopped too) and restart again resulting in the loss of the first activity. The worst thing is that it happens after almost one hour of running (in my case close to the 7th kilometer...).
My pace is running ROM 1.3.8a.
how can i solve this problem? can i recover the activity?
Have you tried https://forum.xda-developers.com/smartwatch/amazfit/xiaomi-huami-amazfit-export-data-t3533292
Related
My Pace started to baaadly delay notifications It started about 2-3 weeks ago, it's irregular, about 1/3 notifications does not goes in-time. Delay is sometimes 10sec, sometimes 40 seconds or even a few minutes! The most annoying thing is that sometimes I have a call (not notified on Pace), I pickup, end it in 20 seconds, put my mobile on desk and...bam! - notification on Pace pops out. Very annoying.
I did a factory reset after WOS installed, nothing helped. I enabled screen-on if notification arrived on mobile, still no-go. Do you have any idea what's wrong with my setup?
I'm using Huawei Mate 9 EMUI 5 Nougat, Watch App v2.3.0/v2.3.2, Amazfit Pacefied rel 39 (v1.2.51) and WOS 2.6.0.12
You've asked for an idea, so: turn off Wi-Fi on your phone, and observe if it gets better.
lfom said:
You've asked for an idea, so: turn off Wi-Fi on your phone, and observe if it gets better.
Click to expand...
Click to collapse
Thanks for tips, but unfortunately does not help at all :/ It looks like watch app service is delayed somehow....
Are you sure that Amazfit app is not being killed while it's in background? Some phones have strict settings that would kill non system apps in background to save battery, even disable Bluetooth. Unless the watch has a Bluetooth problem, the culprit is the phone. Can you pair the watch to other phone for tests? Did you change anything on your phone at the time the notifications started to lag?
Hello I am facing the same problem. My phone is the Huawei nova with android nougat and emui 5
Hi All.
I recently got an Amazfit Stratos and I am having a horrible time trying to gps track my outdoor cycle.
I have tried twice, and both times, the GPS just either:
*Intermittently records data
or
*stops recording gps data altogether.
Basic questions?
Urban areas and Woods... same issue
Urban areas are residential.. no high tall building
Weather was good on both occasions
Yes I am waiting for GPS lock
Heart rate and time measurement continue flawlessly (shows data for the entire ride). It's just GPS tracking that is totally weird.
P.S. It's not "drifting" or inaccurate.. it seems to only switch on the gps sporadically... recording "every now and then"...
No errors or issues reported during the activity.
Latest Firmware (Although last nights a new firmware popped up, haven't tried the activity with last night's firmware.)
Both previous activities was on latest firmware at the time. (Yesterday and the day before)
And the REAL issue for me really, is that my wife's Pace records perfectly on the exact same routes where my Stratos just can't get anything usable going...
I have logged "feedback" request with logs using the app, but have not had any response other than, thanks.. we may use your feedback in the future...
From my own conclusions, the gps works.. because when it tracks... the location where it tracks is accurate.. it just doesn't track constantly. See my attached screenshot of my last ride. (Where my wife and her Amazfit pace tracked perfectly)
Any Ideas?
Cant add the image due to post count... How do I add it to this post?
Have you tried factory reset of the watch? Procedure is to unpair it from the app, it will reset itself, start fresh clean and ask for a pairing.
After pairing it will load last 7 days of your work, while all other old data will remain in the app, on your Mi account cloud. What you will have to add separately are only the 3rd party watchfaces, if you have installed them before.
Strongly suggest you try this first, it takes 5 minutes of your time, and you will lose no data.
image
https://ibb.co/rcJXcyx
Thanks Nidza. I will surely try this. I have not yet as the watch is brand new. Upon receiving it It upgraded firmware 3 times from out of the box, and then I started using it.
I will give it a try, surely cant hurt.
Well what do you know. That factory reset seems to have done the trick!
Thanks!
Some points worth noting:
from the factory settings, a few watch settings did not pull through from the sync back to the app after factory reset.
Time format: My previous time format was 24h (Doubt that makes a difference)
Auto Sync: After factory reset, auto sync is off (I had it "on" before). Can't say if this actually causes any bugs to pop up? Maybe the watch tried to sync which interfered with gps functions? I used it yesterday with auto sync off and it worked well. I will investigate if auto sync on causes the GPS issue again.
Thanks again.
Hi guys, is it normal, that my Stratos's Gps show me the speed to much delayed. I checked it with my car, and the gps gets to the same speed as my phone's one, but maybe 10 seconds later. By skiing it can mean worse maximum speed measurement. It is like that with all the Amazefit Startos watches or I have a wrong one? Thanks for the answers!
It's not the same sampling frequency for a car as it is for a walking man. Watch gps do not need to detect non-human speeds, so there is a lower sampling. (Slower).
Same issue again FW version 4.2.8.0:
stops recording gps data altogether after a few minutes.
I've reset and unpaired the clock twice but the issue remains.
Any advice?
Hello, I have a problem with my stratos and I would like to know if anybody else has this problem or how to fix it.
When I finish my run and then sync with phone and open the app to check my run the finish flag on the map is not on the proper spot but 2-3km sooner.
For example, I run about 15 km but on 12th km, it sets finish flag but it continues to count distance, pace and so on further. In the app, it shows proper distance and everything seems ok but when I look on the map finish flag is on 12th km.
It seems like no issue at all but after uploading on Strava it cuts off everything after the finish flag, so it shows only those 12kms and nothing else. And this bothers me because I use Strava as my primary app to analyze my runs. Interesting is that no matter how long I run it always cuts off more or less the same distance around 2-3 km before the real finish.
I appreciate any help.
Go to Settings on wacth -> Activity reminders, set both to ON, save, then set both to OFF again (you must reset them).
If watch is running firmware > 2.3.7.0 then there is a bug when GPS signal is lost that didn't happen in the past. You may want to factory reset but do NOT restore old data to watch to reset all data, do the above again (also reset Activity reminders), make sure you get a strong GPS-fix before starting to record any activity. And to get better HR data, enable continuous HR for at least 24h and use the watch while you sleep to record resting rate.
lfom said:
Go to Settings on wacth -> Activity reminders, set both to ON, save, then set both to OFF again (you must reset them).
If watch is running firmware > 2.3.7.0 then there is a bug when GPS signal is lost that didn't happen in the past. You may want to factory reset but do NOT restore old data to watch to reset all data, do the above again (also reset Activity reminders), make sure you get a strong GPS-fix before starting to record any activity. And to get better HR data, enable continuous HR for at least 24h and use the watch while you sleep to record resting rate.
Click to expand...
Click to collapse
Thanks for the reply.
I tried reset activity reminders but it did happen again. The watches are running on 2.3.9.0 and this problem first time occurred on 7th January. Is it possible that some update came out around that date?
About the GPS when I get a green screen which indicated good GPS lock and I start the activity it shows always altitude like -20000m and it takes some time until altitude becomes accurate but I always wait on the same spot till it's ok. Could that be a problem? Should I wait to start tracking even though GPS is ready?
After factory reset can I upgrade the watches to the current version or I should stay on some older one?
Reseting data will only erase the activity data stored on watch, it won't affect firmware. I'd suggest that you do the procedure above, and also turn off the watch for about 15s to reset sensors. And find start to record the activity as soon as you get a green GO, wait a few seconds for a stronger GPS fix.
Hello, I have the same exact problem on Amazfit Pace. It happens on Cycling and Walk and always cut the last 1-2 km of the track before the arrive regardless of the length of the ride.
I would try the suggested solutions but I can't find Activity reminders on Pace.
Archenan said:
Hello, I have the same exact problem on Amazfit Pace. It happens on Cycling and Walk and always cut the last 1-2 km of the track before the arrive regardless of the length of the ride.
I would try the suggested solutions but I can't find Activity reminders on Pace.
Click to expand...
Click to collapse
On the Stratos Activity Reminders are found under Settings > General. Not sure if it will be the same on the Pace.
raubbbyy said:
Hello, I have a problem with my stratos and I would like to know if anybody else has this problem or how to fix it.
When I finish my run and then sync with phone and open the app to check my run the finish flag on the map is not on the proper spot but 2-3km sooner.
For example, I run about 15 km but on 12th km, it sets finish flag but it continues to count distance, pace and so on further. In the app, it shows proper distance and everything seems ok but when I look on the map finish flag is on 12th km.
It seems like no issue at all but after uploading on Strava it cuts off everything after the finish flag, so it shows only those 12kms and nothing else. And this bothers me because I use Strava as my primary app to analyze my runs. Interesting is that no matter how long I run it always cuts off more or less the same distance around 2-3 km before the real finish.
I appreciate any help.
Click to expand...
Click to collapse
Amazfit ended up replacing my watch for this issue. None of the fixes they suggested worked. If they are hesitant to replace the watch, remind them of the Satisfaction Guarantee slip included in the package when you purchased the watch.
I have the same problem on my Amazfit pace... So annoying!
Has anyone found a fix?
d0d091 said:
I have the same problem on my Amazfit pace... So annoying!
Has anyone found a fix?
Click to expand...
Click to collapse
Hello, I have the same kind of problem.
My watch : Amazfit Pace 2.8.5.0
It happens only when the run is more than 15km
The finish flag is about 1.5 km to short.
The total distance is ok on Zepp App but it is not good in Strava.
1
Does anyone has a fix?
did you ever tryed a climb and see what the altitude map shows you?
I think my issue (https://forum.xda-developers.com/t/...os-3-2020-12-03.4033223/page-25#post-84231665) is because of that...
butcher33 said:
did you ever tryed a climb and see what the altitude map shows you?
I think my issue (https://forum.xda-developers.com/t/...os-3-2020-12-03.4033223/page-25#post-84231665) is because of that...
Click to expand...
Click to collapse
Hi.
First sorry for my english.
I have same issue. Zepp is the problem. GPX data from watch is ok. When it is updated to Zepp, data is ok.
But when you download the .gpx from Zepp (like Strava should), the latest data is missing in the .gpx
I opened a ticket at Amazfit but for them everything is fine.
In the screenshot below, we see on the left my watch's .gpx on the left and Zepp's .gpx on the right. There are 30 seconds of data missing.
Does anybody have a problem with unexpected Stratos reboots during running activity? I lost many running logs because of that. This problem does not depend on battery capacity or lenght of activity. I already tried factory reset.
Disable all alerts in activity settings besides lap and HR (if you use them), also disable auto-pause if it is enabled as well as "Activity reminders" in main watch settings.
If it doesn't help, then factory reset but do NOT restore old data to watch and configure as above, then you can try to enable the settings you use one by one to find the culprit.
Stratos Unreliable Firmware
The nice ist that it happens rarely during long runs (>30km) but also during halfmarathons..
I like the watch, it works in most cases but we have to accept that it is not the proper watch class for serious athletes.
There are also few unresolved bugs in firmware... I think they are not able to fix it.
Just check your run cadence measurement.. it is a shame as it works..
I ran 80 - 90 km per week in last 2 years with Stratos and I have to factory reset it every 2 months+ restart once upon charging than it works fine.
mmaslac said:
Does anybody have a problem with unexpected Stratos reboots during running activity? I lost many running logs because of that. This problem does not depend on battery capacity or lenght of activity. I already tried factory reset.
Click to expand...
Click to collapse
Hello
My watch has been working good for the last 3 months but lately acquiring GPS not working the first time when I enter running, I have to closecand open it again, also GPS is giving me crazy paces I am a beginner+ runner but it gives me pace of 1min 27sec / km while it should be around 5min 15sec, I tried update to firmware 2.8.5, but same issue I even tried factory reset same issue.
Can you please tell me what is the issue and how to fix ?