dopod herm100 how to upgrade rom - 8525, TyTN, MDA Vario II, JasJam Software Upgradin

hi,
i have a dopod herm100, i need to update the rom as it is giving some battery calibration error, it shows charging and discharging in ratio of 10%. that is 20, 30 , 40 while charging and 90, 80 , 70 while discharging.
i cannot find much details about the rom,
please also give me a link to download the rom as i cannot find the right one while searching.

Related

O2 xda 2 hang on O2 screen

i have an o2 xda 2 that hang on power up at O2 screen then stuck there
i had tested sw reset and even hardware reset but same
i had flashing the rom also but still same
any bro out there who might be able to help me pls
Are you also getting GSM error?
not only gsm bro, with or without sim also when power on stuck on O2 screen
You could try flashing a new rom using sd card method then address any other issues once you get a working pda. One other thing is try removing battery overnight.
I have same issue. Even I have unplug the battery overnight. It is same. I try to download the offical ROM from seeO2 website and upgrade the ROM. (It can upgrade via service mode only.) But it get a error 114 when the upgrade in Radio ROM. After that the screen is same at O2 starting screen and hang (can't off the device).
Please give me help and advice.
Rambo
I only see the OS ROM version (1.60.00WWE) when the device startup and display "No GSM".
Please help!

CHARGE STATUS ERROR!!

Can anybody help me? I get this message under bootloader battery test.
Battery Test
______________
CHARGE STATUS
ERROR!!
Main Voltage:
0x0263
Ext. Voltage:
0x0000
Chg. Voltage:
0x0000
VOS: FFFF
ROB: 0274
My xda keeps on hanging. Would not recover from standby.
OS WM2003 4.01.12
Thanks
The ff where also noticed:
- Hangs, if on standby at TODAY screen.
- Does not hang or freeze if i put it on standby on battery meter screen.
- If put on standby ( pressing the power button), it wld recover if I put it back on in less than 2 minutes. But if more than 2 min, it would turn back on but screen freezes.
Please Help me
Changed my OS to 3.17.03
Radio ver. 4.21.00
ALSO:
After soft reset the date goes back as far as April 1951.
Please guys, I need your help.

Battery draining issues

I've experienced some strange behavior in this issue with my prophet (S200)
* I've tested ROM's that start to drain the battery, and some time after everything goes stable, without me applying any specific patch or registry hack
* I've tested ROM's that always drain battery
* And now I have the "Fantastic Mobiz v2.0b3" for some time, because it was the most stable ROM for me in this battery issue... until now...
Without me installing or uninstalling any application or modifying the registry, my prophet started to drain battery... I'm loosing about 30% over night... Same thing after soft reseting. I didn't make any hard reset yet.
Can any one try to make some light in this mysterious battery behavior?
We need more infos!
IPL/SPL Version ... Radio too ... ROM OS ... have you Reset befor the Rom Autostart the Config in the Ext_Rom?
I have:
IPL 2 09 0001
SPL 2 20 0001
GSM 02 47 21
OS 10.2.0.8 (WWE)
Protocol Version 4.1.13.24
Windows Mobile 6
OS 5.2.968 (Build 17217.0.0.0) NBD v5.31
HI!
Did you try to activate the wifi??
Because for me, I think that trying to activate wifi seems to be the draining battery problem.
I've got the fantastic mobiz v2.04b4 and everything is just fine, stable, speedy, ... BUT if I try to activate the wifi, sometimes it works, sometimes not. When it doesn't work, the battery is draining very fast, so I think the unit is trying to activate the wifi at all moments...
next is ... some roms have power on IR ... use power too ... please read all entry in the threads from your rom ... i think they have a issue for you!
My pda is dopod 830 ,Hao to use wifi?
I am a chinese ,
Help me !thanks!!!!!
My email :[email protected]
Have you used HTC Camera ver. 4.11? That is the problem! For some time I had the same problem, but searching the forum solved it! After removing that aplication, everything is back to normal. Hope that helps.
Battery drain is almost alway because of an installed software.... many software install a shortcut to the startup folder and are runing all the them.... othere programs and some dll just load and don't fully onload when closing and continu to use battery.... so there are lots of causes for battery drain just try to not install all programs at once and that way it's posible to see which programs are causing problems

Atom Strange Issue

My Atom is now in a strange mood
Either Upgrade it by bootloader or Active Sync, it always stop at 36 % in ROM Image
Any solution

Help me revive my G4 8125 :(

Hello to everyone. I am newb here. I need a great men to help fix my phone. I got a Cingular 8125 G4 CID-locked but sim-unlocked device. Prior to upgrading, it finely works in a Cingular Official ROM and WM5. Now I decide to put some more interesting rom - a AKU 2.3 rom (if i am not mistaken this is a Wizard Love Rom). It was upgraded successfully. Then I flashed another rom which I am not familiar with the content. Unfortunately didn't go right this time. Now I am stuck with RGB screen. I even use shelltool in RGB screen (even knowing not to work in this kind of mode). In the middle of the process, the device turns off and shelltool hang, never show progress. I pull out the usb cable from the device. Then when I turn on the unit it gives me the RGB screen showing IPL/SPL 2.25.0001 with no splash screen, OS and GSM. I tried flashing different rom which I know is safe for G4 CID-locked device but no luck at all. I can get through 96% and the device turns off automatically and return to blinking RGB screen with on and off usb connection. Did I bricked my device? Please help revive my Wizard 100. Thank you in advance.
Nopes ! your phone is not bricked,as long as it gets into Bootloaders (RGB screen) its safe.
Download official cingular stock rom and flash in Bootloaders to recover or flash wizard_love rom.After recovering,don't use shelltool,its risky and old method,now a much better method is available.Either upgrade through 'SoftSPL or HardSPL'.
Thanks for the reply I appreciate it. I did all that, download the cingular official rom from the link I got from xda forum and wizard love rom and flashed it but no luck at all. It gives me the same problem. When doing the upgrading the phone restart at 96% and reboot itself showing different error every upgrading attempt. What I only got in bootloader screen is the IPL/SPL 2.25.0001 no OS and GSM (Radio Rom). Maybe I got a corrupted file in my phone. Or just my battery. I tried wall charging but no good. Should I buy a new one or try my luck again. BTW, the error message appeared during upgrading are 274, 302 and 260. The first two seems to be serious matter. Please help me.
Probably,the battery is the culprit here,if its not fully charged or not having enough juice,it won't complete the flash,there are many comm errors due to weak battery,try to get it charged and then try.
How many hours just to have a fully charge battery using wallcharging?
Or maybe my battery needs to be replace. FYI it's 1 yr and 8 mos old now.
My Wizard was revived this time. The problem was the dead battery. I bought a new one and everthing goes fine when I flash the Official Cingualr Rom. Thanks to zabardast_1 and the gurus here in the forum.
Thanz !
It was pleasure to help you,glade you got it up and running

Categories

Resources