Hi, my Xperia X1 does not boot normally. I did not mess with the SPL or bootloader. I made a call, put it back in it's pouch, tried to make a call a few hours later and got the bootloader screen instead. All software and ROMs are stock standard and was never changed. I started by reading XDA forums. The phone will power up to bootloader screen when switched on. Serial is displayed. Plug in a USB cable to PC and this changes to USB. The PC makes its sound to indicate a USB device has been connected. It then says the device cannot be recognised and removes the usb icon from the taskbar. Activesync, mtty, SEUS or any other software will not recognise it. I have since put RA2 on a SD card and updated the ROM. This worked fine. There is no way I know of to HardSPL the phone as it cannot communicate with a PC. If you plug in the wall charger, car charger or USB cable to a PC, the phone will skip the bootloader screen and switch on. The phone cannot be charged while switched on. No charging symbol and the battery will still run down. Switch the phone off and it will however charge. Anybody seen this before? Any ideas how to fix it?
Thanks in advance
Maybe you should ask in the correct section. This is for discussion on HTC Titan not sony experia.
Related
I found my old SPV phone so I plugged the USB cable in into my HTC USB wall plug and it just does nothing, I've tried plugging it into my computer and still no joy.
Any suggestions? I've tried loads of different USB cables with no luck
Sent from my HTC Desire using XDA App
The SPL (and the batterydriver later in OS) only charge if a dedicated HTC charger is connected or the device is linked via Active Sync. Not sure what was the specialty of the HTC chargers - but I believe it was that some (usually data lines that chargers don't need) are connected and that pin 4+5 are as well (ground).
It would also need some seconds to revive the old battery. Lights will be red first and then step to orange when you can start switching it on.
Last resort: charge battery manually (any single element charger for Li-Ion should do).
Just to add: If you replace the original SPL with one that allows you to flash up to WM5/6, then also the charging will become possible with any USB Charger. If you want to keep the original OS you can also only replace the SPL - the device will still boot but not accept an original OS Update.
Hi,
I've just become an happy owner of the Atrix since a week.
I'm writing to ask about a strange behaviour that's happening to my phone: my battery it's at full charge, and the phone is switched off. I plug the usb cable to the pc and to the phone, and the phone boot up himself. Not to regharge mode (the screen with the battery charging), but in phone mode.
Usb setting on the phone is set to none, and I've tried it also on a pc without the motorola software. Do you know it as a bug?
My version is 4.4.20.MB860.Retail.en.DE (Android version 2.2.2) and I've rooted the phone.
Thanks in advance!
hmm that's odd because it happened to me last night. but i plugged it into the wall, booted right into cm7. i will have to look into this. although its not a major issue for me in any sense.
This has always happened with my Atrix, i just assumed it was the way the phone was designed.
if anyone has experienced any differently, please let me know.
It's the same for me too. If the phone is off and I plug in the USB cable (either connected to a pc or wall charger) the phone boots up. I assumed this is intended.
Sent from my MB860 using Tapatalk
I noticed this issue, where the Photon powers on by itself when i plug it into the computer via usb.
When the phone is off and plugged to the wall charger I get the battery charging image. But When the phone is off and plugged into the computer via usb, it powers on. Also With the usb plugged in and in charge only mode, when i perform a shutdown on the phone, it restarts right after completing shutdown.
I know this might now be a serious issue, and no one have probably come across it but same thing happened when it was connected to the PS3, i powered it off while it was on and connected to ps3 via usb and it powered back on. This could be some weird usb sending out signals trying to mount the sd card and in return it forces the phone to turn on, can someone please verify this on their phone, my brother has a photon i am gonna try this on his later tonight, just need to know it is on mine,
Well i confirmed with another Photon, it is the same issue, whenever it is plugged into a USB it turns on by itself, dont know if this happens with other phones, but it is weird
Harry_Spade said:
Well i confirmed with another Photon, it is the same issue, whenever it is plugged into a USB it turns on by itself, dont know if this happens with other phones, but it is weird
Click to expand...
Click to collapse
Same thing here and it is so annoying when I am just trying to charge it and it keeps booting back up.
does anyone know of a solution, i ll try playing around with it, may be something with usb debugging, highly doubt it though
Same here. I think it must be designed this way for some reason.
Does it turn on if the USB is set to 'Charge Only' mode? I think it turns on automatically by design in Phone Portal or Sync modes but it probably shouldn't in Charge Only mode.
soo when i plug my phone to connect to my desktop it says it isn't recognized with a code error 43. It wouldn't install the phone and it won't charge while it is plugged in. and when i used my wall plug to try to charge my phone from there it still didn't work. help?
What did you do to make the phone un-responsive?
Sent from my SGH-T959 using xda premium
well it all started as i was upgrading my psu from my desktop and i guess the usb port was loose and when my desktop was put back together the usb i believe wasnt charging and i didn't notice at that time so i left it plugged with my microusb. i come back from eating finding my phone to be really hot like insanely hot and it wont turn on at all ! then i researched and found this thread to put it in download mode and so i did. but somehow i got stuck at the download mode, so i had this crazy idea that if i removed the driver .. it might work and it would install it's software like normal.. i guessed wrong. i turned off my phone since i didnt want to waste batteries. after removing the the driver i noticed that i cant charge my phone at all .. like i have two different chargers and both didnt work, the microusb and wallplug w/o the usb. now my computer won't recognize my device and won't even install at all
I think I just had an aneurysm.
Ow.
I have an un-rooted, bootloader unlocked, stock att rom that will not charge or be recognized by the computer while turned on. With the phone completely powered off, it will charge. In the bootloader, fastboot connects via USB with no problems. When I go to TWRP recovery, a USB device is connected for about 10 seconds, then it disconnects. With the phone loaded and running, I plug in the usb cable from the computer and nothing happens. The computer does not make the sound of a device connected, device manager doesn't show anything is connected nor will it charge. If I plug it into a normal wall charger, it still won't charge. My other HTC One works with these same cables. I already reflashed the stock RUU with no luck.
Any ideas what could be causing this?
Looks like an rma on that one boss...imo or try another computer possibly