hello guys, I have a small problem, more an annoying problem however small, my phone SE walkman live.
When I connect it to the PC via the USB cable, it is as if I'm unplugging, pulling him several times've done everything so far and not getting good results.
Can I delete these, usb cable with deifeito is not already switched rom, uninstalled all the pc drive, already tested by more than 3 pcs, plug the phone also is not faulty.
When you plug your phone into fast boot and flash mode, do not disconnect.
Anybody dares to help me? Thanked.
Device: Sony ericsson live walkman
Please use the Q&A Forum for questions &
Read the Forum Rules Ref Posting
Thanks ✟
Moving to Q&A
Related
Hi Everyone
First of all I'd like to thank everyone who contributes to this wonderful community. It made it very easy for a complete newcomer like me to install the Modaco custom rom on my hero and I've found answers to nearly all my other queries in the forums here.
I now have a problem I can't fix though and was hoping for some advice or help.
When I plug my Hero into my computer via the USB cable Windows has now started saying "USB device not recognised" and the phone does not acknowledge the connection other than charging. The error message says "One of the USB devices attached to this computer has malfunctioned and Windows does not recognise it".
I've tried all the USB ports and other USB devices and they work fine so I think it must be related to the phone. Tried powering off the PC and phone numerous times but hasn't helped.
I'm confused as it was working fine until recently and I can't think of what I've changed.
Can anyone help or offer any suggestions?
Thanks!
Just realised I've put this in completely the wrong forum. Sorry!
Can it be moved or should I repost in the correct forum?
Cheers
Thread moved
to Q&A
hope this helps
Thanks Liamhere.
Update- tried it on my work PC with same result.
I guess it confirms it's either the wire or the phone?
IainDM said:
Hi Everyone
First of all I'd like to thank everyone who contributes to this wonderful community. It made it very easy for a complete newcomer like me to install the Modaco custom rom on my hero and I've found answers to nearly all my other queries in the forums here.
I now have a problem I can't fix though and was hoping for some advice or help.
When I plug my Hero into my computer via the USB cable Windows has now started saying "USB device not recognised" and the phone does not acknowledge the connection other than charging. The error message says "One of the USB devices attached to this computer has malfunctioned and Windows does not recognise it".
I've tried all the USB ports and other USB devices and they work fine so I think it must be related to the phone. Tried powering off the PC and phone numerous times but hasn't helped.
I'm confused as it was working fine until recently and I can't think of what I've changed.
Can anyone help or offer any suggestions?
Thanks!
Click to expand...
Click to collapse
Try to download the HTC drivers from the HTC support or Android 1.6 SDK and reinstall the USB driver again.
Thanks for your suggestions and anyone else who has been racking their brains for me.
It was, after loads of fiddling with settings and drivers etc aproblem with the USB wire.
My new one arrived in the post and now the phone syncs up fine. Phew!
Old wire is now relegated to "charging only" duties.
I have looked everywhere for answers but cant find any on how to get my phone to connect, well be recognized by my computers. I know exactly how to use Odin to get my phone out of its bricked stage through the download menu. But the thing is, it hasnt been recognized by my computers for awhile, even when i was using ICS on it, and i tried a lot of things but recently i havent been able to get it connected. I have no idea what to do, i need help on this urgently. Just to restate, my phone is not being recognized by my computer when plugged in through a working USB cord, please help
Go to Dev section and download the AIO toolbox (links are live again). It has Odin 1.8, the correct pit/tar files and drivers. Don't forget to download the .net files too in the OP.
Might have to go into device manager and delete the drivers you might still have in there that are bunked out.
Please use the Q&A Forum for questions &
Read the Forum Rules Ref Posting
Moving to Q&A
Hi,
I have my Galaxy S III for a few months now, and after I rooted it this problem came up:
Everytime I try to connect my phone to my computer via USB it enters a sort of bootloop until I disconnect it.
Any idea of what could I do?
Thanks.
Samsung USB drivers installed ??
No information posted regards firmware etc crystal ball failed .
Basics read first.
http://forum.xda-developers.com/showthread.php?t=2344125
Critical you read the first two posts
Hi,
I have an xperia go. The place I put my usb cable on was broken and since I had a custom rom in it, I didn't send it to warranty so I made some place else repair it.
now it charges but it isn't able to connect to pc. I use an ftp server to connect my phone to my pc, so if there is something like a zipped stock rom, I could use it to install the stock rom and maybe then I'd send it to warranty. (if it's not that void yet)...and if it is void, I need it anyway because 4.4.2 android rom can't play videos with a proper resolution. I mean it looks great only with the center mode of the video player, with fit to screen, crop modes the image sucks.
there was a similar question answered but that answer doesn't work with xgo.
Are you sure that your usb port from your go is broken??
lol98lol98 said:
Are you sure that your usb port from your go is broken??
Click to expand...
Click to collapse
well, my little cousin saw that it wasn't charging but sometimes charging so he forced the charger to get inside the socket and then the part of the phone that you plug the phone into was stucked inside the charger. ( so I lost both charger and the usb socket.)
it was definitely broken.
try changing your usb cable.
in my case it was my usb cable that is broken
and next time, please post Q&A related thread here [url="http://forum.xda-developers.com/xperia-u/issues]Xperia P, U, Sola, Go Q&A, Help & Troubleshooting[/url], not in general section
edited : didnt read the post above me, well if something stuck in your usb socket i can only say..
good luck sending your phone to service center
Hello everyone! i have a strange problem with my Samsung s3 phone. the problem is when i connect my mobile via usb to my computer it won't detect my phone for USB storage but it charge my phone. a similar thread has been posted on this forum but solutions given there don't seem to be helpful for me. I've tried these methods to get it worked but failed.
changed USB cable and ports.
Ticked unticked USB debugging
and a member on this forum posted a code which was like *#7284# or *#7248# to change USB part of this utility from modem to PDA. but there is no USB option in this Utility it only shows UART which has these options.
Modem
PDA
Default selected option was PDA so i changed it to modem and rebooted my phone but still no luck...! Worst part of my problem is my system even won't feel there is something connected to the systemcomputer. Please Help!
Please somebody help.
Sir,
Please wait until mods will move this thread to the device specific forum for more relevant answers.
Stand by
Good luck