Hi All
I searched all but to no avail.
I was given a XDA - MDA1 but without any cables.
I got and usb charger from eBay - on auction it was said that it will work with Wallaby but ..
usb cable works - I can connect and sync to AC
but charging don't work - neither from USB on my PC nor from wall socket using charger which was sent to me.
I saw a post where someone did something with a docking station to charge it from usb - but now I can't locate it anymore.
Any help will be much appreciated.
Tom
http://wiki.xda-developers.com/index.php?pagename=HTC_Wallaby
read the "Modifying your Wallaby cradle to power/charge from USB" part same deal
Hi everyone, hope someone can advise.
I have a UK TG01 and it works ok but overnight it wont charge from the mains charger but it charges via usb.
I have tried different chargers and an old HTC mini usb charger with a mini to micro adapter fitted but its still the same.
I have the Mugen 1300Mha battery but its the same with the standard battery on all chargers.
I have cleaned out both the charger plug and the socket on my TG01 just in case of dust but no good it only charges via usb.
I have hard reset and flashed the standard UK Orange rom but this makes no difference.
Does anyone know whats going on? it was fine, no changes or software loaded and one day its fine and the next day it wont charge??
Any advice would be gratefully received, thanks for reading.
Faulty USB sockets i think try send it back to Toshiba for warranty repair.
Not sure about that as my TG01 does charge if I plug it into my laptop, this would suggest the socket is ok?
I believe that the charger is faulty, try a new micro usb charger, or try another socket
wafeeq said:
I believe that the charger is faulty, try a new micro usb charger, or try another socket
Click to expand...
Click to collapse
Agreed. As the TG01 is charging via USB, then there is most unlikely to be an issue with the uUSB socket on the phone.
To tell the TG01 to go into charging mode, the uUSB connector on the charger must have the two data pins shorted out. This is the equivalent effect to connecting to a host laptop or PC when connected via a USB sync and charge cable.
If you have a non-standard charger or are using an adapter from eg. mini-USB to uUSB it is very likely that this will not be implemented.
A few questions...
- Are you trying with the supplied Toshiba charger ?
- If so did it work OK with this before but not now ? [likely duff charger]
- If a 3rd part charger, again has it ever worked ? [if not then probably missing the required pin config]
Hope that is of some help.
Hi Kevin, its a genuine Toshiba charger and I have been using it since day one.
I took my charger into work today and tried a friends Nokia micro usb charger and that worked first time so duff charger.
No, I asked him to try my Toshiba charger and that also worked
So I assume my original charger possibly may not be 'shorting' correctly or presenting exactly the right resistance to the TG01 or possibly my TG01 is getting a little fussy about how it charges.
Anyway I have ordered a genuine Nokia charger from ebay and fingers crossed all should be well and thanks for all the advice everyone.
Hi,
I have HTC flyer, its charging very well on usb via pc, but not charging thru. charger.any solution available.
thanks in advance.
Double checked the charger (and wall outlet for that matter)? If its a USB plug try charging something else from it.
Hi
I have purchased a wireless charging receiver.
On other phones it works just fine, but on the Motorola One it does not get recognized and does not charge my phone.
Any ideas what could I do to enable it?
It doesn't support wireless charging. Simple as that.
Sent from my moto one
I have a LG Stylo 3 plus (LGMP450) MetroPCS is Carrier.
I want to get wireless charging. I bought one adapter off Amazon by QI. The micro usb on the wireless charging receiver was to big for my phone.
So, I am looking for suggestions or guidance on where to buy the proper one.
Thabks for help!!